Skip to content
worldfires
MM · Myanmar · –

Shadaw fire, 25 February 2020 Shadaw, Loikaw

Out · last detection 6 Mar 2020, 06:36 UTC

The fire started on 25 February 2020 in Shadaw, Myanmar, and satellites saw it burning for 11 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,589 hectares from heat detections, spread across 2 municipalities.

It is the 60th largest in Kayah since 2016 (of 169 with a page). Number 87 in Myanmar in 2020, of 232.

Compare with…
Burnt area
3,589ha
GWIS perimeter (Copernicus)
Duration
11days
25 Feb 2020 – 6 Mar 2020
Municipalities hit
2
municipalities
Started on
25 Feb
2020
Heat detections
130
in a single hotspot: 36 MW
Danger at start
33
High · FWI index
Average daily power
85MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 25 Feb6 Mar
6 Mar 2020

How it evolved, day by day

25 Feb 2020 · 3 MW · 3 27 Feb 2020 · 39 MW · 18 28 Feb 2020 · 79 MW · 26 29 Feb 2020 · 469 MW · 54 1 Mar 2020 · 88 MW · 19 2 Mar 2020 · 6 MW · 4 3 Mar 2020 · 53 MW · 4 5 Mar 2020 · 3 MW · 1 6 Mar 2020 · 21 MW · 1
25 Feb 29 Feb 3 Mar 6 Mar

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
41km/h · peak gust
21%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

96% of the perimeter overlaps earlier fires recorded since 2016: 2,818 ha in 2016, 1,427 ha in 2017, 2,224 ha in 2018, 10 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 3,438 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 2.3% of the area of London (36 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Shadaw where it started
    2,873 ha reached on 25 Feb
    1.3 %
  2. 740 ha reached on 29 Feb
    0.5 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area1.5 ha
Residents≈ 150

Inside the perimeter there were about 1.5 hectares of built-up land and about 150 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with 60 days without rain: 24 % of the area in Myanmar

Day High Min. humidity Peak gust Rain Danger (FWI)
25 Feb 34.4 °C 24 % 27 km/h 0.0 mm High 33
26 Feb 33.9 °C 29 % 35 km/h 0.0 mm High 35
27 Feb 32.8 °C 29 % 32 km/h 0.0 mm High 34
28 Feb 33.6 °C 28 % 36 km/h 0.0 mm High 36
29 Feb 35.1 °C 23 % 32 km/h 0.0 mm High 36
1 Mar 35.9 °C 23 % 28 km/h 0.0 mm High 34
2 Mar 36.0 °C 22 % 31 km/h 0.0 mm High 36
3 Mar 35.1 °C 28 % 41 km/h 0.2 mm Very high 40
4 Mar 35.2 °C 23 % 30 km/h 0.0 mm High 36
5 Mar 35.4 °C 21 % 33 km/h 0.0 mm High 38
6 Mar 36.2 °C 22 % 34 km/h 0.0 mm Very high 39
7 Mar after 36.6 °C 22 % 34 km/h 0.0 mm Very high 38
8 Mar after 36.1 °C 22 % 38 km/h 0.0 mm Very high 41
9 Mar after 36.8 °C 17 % 34 km/h 0.0 mm Very high 42
10 Mar after 36.8 °C 18 % 27 km/h 0.0 mm Very high 40
11 Mar after 37.8 °C 20 % 29 km/h 0.0 mm Very high 41
12 Mar after 38.6 °C 27 % 25 km/h 0.0 mm High 38
13 Mar after 39.0 °C 23 % 23 km/h 0.0 mm Very high 40
14 Mar after 38.6 °C 24 % 22 km/h 0.0 mm Very high 40
15 Mar after 38.8 °C 24 % 36 km/h 0.0 mm Very high 44
16 Mar after 39.1 °C 19 % 37 km/h 0.0 mm Very high 44

Its twins: fires that started in the same weather

It started with an FWI of 32.7, a minimum humidity of 24% and more than two months without rain. Fires in the area that started in weather like this since 2016: 19.

FWI at the start 32.7
Minimum humidity 24 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Hpruso fire, March 2019
2,557 ha 15 days FWI 33.6 Min. humidity 25 % 67 km away, in 2019

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

12 days
median duration
2,706 ha
median area
100 %
went past 1,000 ha
2.0 mm
rain at the end (median; 13 of 19 had it)

It burned an area similar to its twins (3,589 ha against a median of 2,706 ha) and lasted 11 days, against 12 days.

In 6 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
41km/h · max. gust

It was considered over on 6 Mar, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 13 of 19, with a median of 2.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 18 Feb 2020
After · 13 Mar 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 130Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Myanmar

Frequently asked questions

How long did the Shadaw fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 25 February 2020 to 6 March 2020 (11 days). The perimeter dates it from 25 February 2020 to 3 March 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,589 hectares (35.9 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Shadaw (2,873 ha, 1.3 %); Loikaw (740 ha, 0.5 %).
What was the weather like?
During the fire the temperature reached 36.2 °C, humidity dropped to 21 % and gusts hit 41 km/h. The fire danger index (FWI) reached 40, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Myanmar (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 19. Their median duration was 12 days and their median area 2,706 ha; 100 % went past 1,000 ha. In 6 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 3 March 2020 → 6 March 2020.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 25 February 2020 to 3 March 2020. 130 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.