Skip to content
worldfires
IT · Italy · →

Sassari fire, June 2025 Alghero, Sassari

Out · last detection 29 Jun 2025, 13:36 UTC

The fire started on 29 June 2025 in Sassari, Italy, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 214 hectares from satellite imagery, spread across 2 municipalities.

It is the 13th largest in Tàttari/Sassari since 2016 (of 17 with a page). Number 94 in Italy in 2025, of 216.

The power measured by the satellite is low (4.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
214ha
Copernicus perimeter
Duration
1day
29 Jun 2025 – 29 Jun 2025
Municipalities hit
2
municipalities
Started on
29 Jun
2025
Heat detections
2
in a single hotspot: 5 MW
Danger at start
26
High · FWI index
Energy released
9MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 29 Jun29 Jun

How it evolved, day by day

29

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
35km/h · peak gust
49%lowest humidity

It had gone 38 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. 157 ha
    0.7 %
  2. Sassari 121,021 inhabitants · 27.3 km from the town where it started
    57 ha reached on 29 Jun
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub78 %
  • Agricultural areas22 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to CFVA Sardegna, this fire started on 29 June 2025 and burned 220 ha (the satellite measured 214 ha).

Regione Autonoma della Sardegna, Corpo Forestale e di Vigilanza Ambientale: perimetri delle aree percorse dal fuoco (CC BY 4.0). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
29 Jun 32.1 °C 49 % 35 km/h 0.0 mm High 26
30 Jun after 31.1 °C 52 % 32 km/h 0.0 mm High 23
1 Jul after 31.1 °C 56 % 28 km/h 0.0 mm High 22
2 Jul after 31.5 °C 57 % 36 km/h 0.0 mm High 25
3 Jul after 30.5 °C 60 % 32 km/h 0.3 mm High 26
4 Jul after 30.3 °C 62 % 27 km/h 0.5 mm Moderate 21
5 Jul after 30.1 °C 62 % 26 km/h 0.0 mm Moderate 20
6 Jul after 30.4 °C 48 % 30 km/h 0.0 mm High 25
7 Jul after 27.5 °C 57 % 36 km/h 0.0 mm High 27
8 Jul after 24.9 °C 52 % 58 km/h 0.0 mm High 37
9 Jul after 27.7 °C 43 % 52 km/h 0.0 mm High 37

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 22 Jun 2025
After · 6 Jul 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 27 June 2025 the air beside the fire reached 15 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak15 µg/m³
Days over the guideline0 days
PM1027 µg/m³
Optical depth0.18
2728293012
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Sassari fire last?
Copernicus dates it between 29 June 2025 and 29 June 2025: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 214 hectares (2.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Alghero (157 ha, 0.7 %); Sassari (57 ha, 0.1 %).
Did the fire reach a town?
The closest fire to a town centre came within 27.3 km of Sassari. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 32.1 °C, humidity dropped to 49 % and gusts hit 35 km/h. The fire danger index (FWI) reached 26, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.