Sant'Andréa-di-Cotone fire, January 2018
Sant'Andréa-di-Cotone, Valle-d'Alesani, Cervione
Out · last detection
The fire started on in Sant'Andréa-di-Cotone, France, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 1,266 hectares from satellite imagery, spread across 8 municipalities.
It is number 4 by size of the 27 fires with a page that started in Haute-Corse since 2016. The largest in France in 2018, of 3.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
matches the official record
1,266ha
Perimeter published by EFFIS (Copernicus).
This page1,266BDIFF1,317
Source
EFFIS (Copernicus)
Date
perimeter revised on 26 January 2022
+− cross-check
BDIFF: 1,317 ha (matched records: 1). Difference between the page and the official record: −3.9%. Matched on 15 November 2026.
Duration by satellite
satellite only
3days
2 Jan 2018 to 4 Jan 2018: first and last day with fire on the page.
Source
EFFIS (Copernicus) · NASA FIRMS · VIIRS
Date
last detection: 4 Jan 2018, 01:14 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start and cause
matches the official record
2 Jan 201805:13
Alert according to BDIFF: 2 January 2018 at 05:13. Official cause: negligence.
Source
BDIFF · 2018-4880
Date
matched to the page on 15 November 2026
+− cross-check
First day with fire on the page (satellite or perimeter): 2 January 2018.
Hotspots
satellite only
36
VIIRS detections at 375 m. Most intense hotspot: 55 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
2 Jan 2018 – 4 Jan 2018
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
391MW
Total radiative power on 2 January 2018; hotspots that day: 16.
Source
NASA FIRMS · VIIRS (FRP)
Date
2 Jan 2018
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
3.8FWI · very low
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 2.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
14.5°C · 55% RH
High of 14.5 °C and minimum humidity of 55% on 3 January 2018; gusts of 76 km/h on 3 January 2018.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
Living inside
model
≈ 250people
Estimated residents inside the perimeter and 2.6 ha of built-up area (100 m grid, epoch 2020).
Source
GHSL R2023A · JRC
Date
calculated on 24 October 2026
+− cross-check
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official BDIFF record
Matches: 1,317 ha in the official record (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
San-Giuliano812 inhabitants · 0.6 km from the centre
2 hareached on 4 Jan
0.1 %
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
Sclerophyllous scrub65 %
Broadleaved forest19 %
Other natural land8.3 %
Scrub and transitional woodland7.0 %
Artificial surfaces1.3 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
People and buildings inside the perimeter
GHSL 2020
Built-up area2.6ha
Residents≈ 250
Inside the perimeter there were about 2.6 hectares of built-up land and about 250 residents (GHSL 2020, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
According to BDIFF, a fire of 1,317 ha was recorded in Sant'Andréa-di-Cotone on 2 January 2018 (the satellite measured 1,266 ha). The record has no coordinates, so it was matched by municipality and date.
Sant'Andréa-di-Cotone2 January 2018 · 05:131,317 ha· cause: negligence
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
2 Jan
12.3 °C
37 %
41 km/h
0.0 mm
Very low 4
3 Jan
14.5 °C
55 %
76 km/h
0.0 mm
Very low 2
4 Jan
12.8 °C
60 %
56 km/h
0.2 mm
Very low 1
5 Jan after
12.8 °C
72 %
27 km/h
0.2 mm
Very low 1
6 Jan after
12.0 °C
77 %
31 km/h
0.9 mm
Very low 2
7 Jan after
12.0 °C
84 %
38 km/h
1.7 mm
Very low 1
Its twins: fires that started in the same weather
It started with an FWI of 3.8, a minimum humidity of 37% and 2 days without rain. Fires in the area that started in weather like this since 2016: 19.
FWI at the start3.8
Minimum humidity37 %
Days without rain2
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Sant'Andréa-di-Cotone fire, January 2018
1,266 ha3 daysFWI 3.8Min. humidity 37 %
Albertacce fire, July 2026
383 ha9 daysFWI 4.9Min. humidity 40 %45 km away, in 2026
First rain (1 mm or more) after it ended: 1.8 mm on 26 Jul.
It was 6.3 times larger than the median of its twins and lasted 3 days, against 3 days.
None of its 19 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 3 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 5.4 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
1.7 mmfirst rain
7 Jan3 days after it ended
76km/h · max. gust
It was considered over on 4 Jan, and on 7 Jan 1.7 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 16 of 19, with a median of 5.4 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 26 Dec 2017
After · 11 Jan 2018
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 31 December 2017 the air beside the fire reached 13 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).
PM2.5 peak13µg/m³
Days over the guideline0days
PM1023µg/m³
31 Dec2 Jan4 Jan6 Jan
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 36Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Copernicus dates it between 2 January 2018 and 4 January 2018: 3 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 1,266 hectares (12.7 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 8 municipalities: Sant'Andréa-di-Cotone (638 ha, 72 %); Valle-d'Alesani (255 ha, 27 %); Cervione (176 ha, 15 %); Santa-Reparata-di-Moriani (165 ha, 18 %); Valle-di-Campoloro (13 ha, 2.2 %); Ortale (10 ha, 2.5 %); Felce (7 ha, 1.4 %); San-Giuliano (2 ha, 0.1 %).
Did the fire reach a town?
The fire started in Sant'Andréa-di-Cotone and reached its centre: the point marking it was inside the burnt area or less than 500 metres from it. That does not mean houses burned.
What was the weather like?
During the fire the temperature reached 14.5 °C, humidity dropped to 37 % and gusts hit 76 km/h. The fire danger index (FWI) reached 4, class Very low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of France (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 19. Their median duration was 3 days and their median area 200 ha; 5 % went past 1,000 ha. None of its 19 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 3 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 5.4 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 36 Suomi-NPP VIIRS detections on those dates.
Compared with BDIFF: 1,317 official ha against 1,266 ha of perimeter; they agree within 25%.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM5 (Open Data Commons Attribution License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.