Skip to content
worldfires
IT · Italy ·

San Vito Lo Capo fire, August 2019 San Vito Lo Capo

Out · last detection

The fire started on in San Vito Lo Capo, Italy, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 173 hectares from satellite imagery, spread across a single municipality.

It is number 46 by size of the 68 fires with a page that started in Trapani since 2016. Number 41 in Italy in 2019, of 103.

Burnt area
173ha
Copernicus perimeter
Duration
1day
7 Aug 2019 – 7 Aug 2019
Municipalities hit
1
municipalities
Started on
7 Aug
2019
Heat detections
8
in a single hotspot: 34 MW
Danger at start
74
Very extreme · FWI index
Average daily power
203MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 7 Aug7 Aug

How it evolved, day by day

7 Aug 2019 · 203 MW · 8

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
58km/h · peak gust
29%lowest humidity

It had gone 21 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. San Vito Lo Capo 4,814 inhabitants · fire reached the centre where it started
    173 ha reached on 7 Aug
    2.9 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub91 %
  • Agricultural areas8.9 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 22 % of the area in Italy Strong wind: 15 % of the area in Italy

Day High Min. humidity Peak gust Rain Danger (FWI)
7 Aug 32.5 °C 29 % 58 km/h 0.0 mm Very extreme 74
8 Aug after 34.0 °C 37 % 40 km/h 0.0 mm Very high 46
9 Aug after 31.7 °C 50 % 43 km/h 0.0 mm Very high 42
10 Aug after 33.0 °C 44 % 37 km/h 0.0 mm High 29
11 Aug after 34.3 °C 37 % 37 km/h 0.0 mm High 36
12 Aug after 34.4 °C 37 % 36 km/h 0.0 mm Very high 38
13 Aug after 33.1 °C 38 % 40 km/h 0.0 mm Very high 44
14 Aug after 29.1 °C 48 % 48 km/h 0.0 mm Very high 38
15 Aug after 28.7 °C 49 % 45 km/h 0.0 mm Very high 39
16 Aug after 30.6 °C 37 % 36 km/h 0.0 mm High 33
17 Aug after 29.2 °C 39 % 38 km/h 0.0 mm Very high 39

Its twins: fires that started in the same weather

It started with an FWI of 74.5, a minimum humidity of 29% and 21 days without rain. Fires in the area that started in weather like this since 2016: 32.

FWI at the start 74.5
Minimum humidity 29 %
Days without rain 21
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Custonaci fire, August 2023
292 ha 2 days FWI 73.7 Min. humidity 29 % 7 km away, in 2023

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

2 days
median duration
304 ha
median area
16 %
went past 1,000 ha
3.7 mm
rain at the end (median; 13 of 32 had it)

It stayed below its twins: 173 ha against a median of 304 ha. It lasted 1 day, against 2 days.

In 19 of 32, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.7 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
58km/h · max. gust

It was considered over on 7 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 13 of 32, with a median of 3.7 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 31 Jul 2019
After · 14 Aug 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 10 August 2019 the air beside the fire reached 26 µg/m³ of PM2.5. That day averaged 22: 1.5 times the WHO daily guideline (15).

PM2.5 peak26 µg/m³
Days over the guideline4 days
PM1049 µg/m³
5 Aug7 Aug9 Aug
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy

Frequently asked questions

How long did the San Vito Lo Capo fire last?
Copernicus dates it between 7 August 2019 and 7 August 2019: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 173 hectares (1.7 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered San Vito Lo Capo (173 ha, 2.9 %).
Did the fire reach a town?
The fire started in San Vito Lo Capo and reached its centre: the point marking it was inside the burnt area or less than 500 metres from it. That does not mean houses burned.
What was the weather like?
During the fire the temperature reached 32.5 °C, humidity dropped to 29 % and gusts hit 58 km/h. The fire danger index (FWI) reached 74, class Very extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 32. Their median duration was 2 days and their median area 304 ha; 16 % went past 1,000 ha. In 19 of 32, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.7 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.