Skip to content
worldfires
IT · Italy · →

Ravanusa fire, 31 July 2026 Ravanusa, Mazzarino

Out · last detection 31 Jul 2026, 12:59 UTC

The fire started on 31 July 2026 in Ravanusa, Italy, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 210 hectares from satellite imagery, spread across 2 municipalities.

It is the 119th largest in Agrigento since 2016 (of 289 with a page). Number 110 in Italy in 2026, of 232.

The power measured by the satellite is low (14.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
210ha
Copernicus perimeter
Duration
≈ 1day
31 Jul 2026 – 31 Jul 2026
Municipalities hit
2
municipalities
Started on
31 Jul
2026
Heat detections
3
in a single hotspot: 14 MW
Danger at start
23
High · FWI index
Average daily power
30MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 31 Jul31 Jul

How it evolved, day by day

31 Jul 2026 · 30 MW · 3

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
35km/h · peak gust
40%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started.

This area had burned before

68% of the perimeter overlaps earlier fires recorded since 2016: 1 ha in 2020, 29 ha in 2021, 120 ha in 2023, 1 ha in 2024, 8 ha in 2025. Part of it burned more than once, so the yearly figures add up to more than the 143 ha that had burned before.

What happened to each town

  1. Ravanusa 10,349 inhabitants · 2.7 km from the centre where it started
    210 ha reached on 31 Jul
    4.2 %
  2. Mazzarino 10,932 inhabitants · 18.8 km from the centre
    1 ha reached on 31 Jul
    0.0 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas76 %
  • Other natural land12 %
  • Sclerophyllous scrub6.7 %
  • Other land cover4.8 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
31 Jul 33.9 °C 40 % 35 km/h 0.0 mm High 23
1 Aug after 34.2 °C 36 % 36 km/h 0.0 mm High 26
2 Aug after 33.2 °C 45 % 31 km/h 0.0 mm High 25
3 Aug after 31.4 °C 55 % 30 km/h 0.0 mm Moderate 20
4 Aug after 33.2 °C 42 % 28 km/h 0.0 mm High 22
5 Aug after 32.8 °C 41 % 37 km/h 0.0 mm High 26
6 Aug after 32.6 °C 50 % 40 km/h 0.2 mm High 27
7 Aug after 35.0 °C 40 % 47 km/h 0.0 mm High 31
8 Aug after 36.0 °C 28 % 40 km/h 0.0 mm High 37
9 Aug after 34.0 °C 37 % 31 km/h 0.0 mm High 32
10 Aug after 33.8 °C 43 % 37 km/h 0.0 mm High 32

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 24 Jul 2026
After · 7 Aug 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 3 August 2026 the air beside the fire reached 14 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak14 µg/m³
Days over the guideline0 days
PM1038 µg/m³
Optical depth0.43
293031123
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Ravanusa fire last?
The official perimeter only gives the start date (31 July 2026). The end comes from the heat detections inside the perimeter: it burned until 31 July 2026 (1 day from 31 July 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 210 hectares (2.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Ravanusa (210 ha, 4.2 %); Mazzarino (1 ha, 0.0 %).
Did the fire reach a town?
The fire started in Ravanusa and came within 2.7 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 33.9 °C, humidity dropped to 40 % and gusts hit 35 km/h. The fire danger index (FWI) reached 23, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 3 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.