Skip to content
worldfires
BR · Brazil · –

Prainha fire, 14 October 2026 Prainha

Dying down · last detection 18 Nov 2026, 05:16 UTC

The fire started on 14 October 2026 in Prainha, Brazil, and satellites saw it burning for 36 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,186 hectares from heat detections, spread across a single municipality.

Number 750 in Brazil in 2026, of 808.

GWIS near-real-time perimeter, from the layer that changed in October 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

The power measured by the satellite is low (18.1 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Is it still active?

No detections since 18 Nov 2026, 05:16 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Burnt area
3,186ha
GWIS perimeter (Copernicus)
Duration
36days
14 Oct 2026 – 18 Nov 2026
Municipalities hit
1
municipalities
Started on
14 Oct
2026
Heat detections
184
in a single hotspot: 18 MW
Danger at start
33
High · FWI index
Average daily power
27MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Oct18 Nov
18 Nov 2026

How it evolved, day by day

27 Oct 2026 · 38 MW · 4 28 Oct 2026 · 17 MW · 5 29 Oct 2026 · 86 MW · 21 30 Oct 2026 · 31 MW · 16 31 Oct 2026 · 0 MW · 0 1 Nov 2026 · 25 MW · 6 2 Nov 2026 · 26 MW · 5 3 Nov 2026 · 0 MW · 0 4 Nov 2026 · 5 MW · 1 5 Nov 2026 · 19 MW · 10 6 Nov 2026 · 36 MW · 22 7 Nov 2026 · 5 MW · 2 8 Nov 2026 · 18 MW · 2 9 Nov 2026 · 1 MW · 2 10 Nov 2026 · 5 MW · 3 11 Nov 2026 · 30 MW · 18 12 Nov 2026 · 25 MW · 14 13 Nov 2026 · 0 MW · 0 14 Nov 2026 · 5 MW · 1 15 Nov 2026 · 17 MW · 9 16 Nov 2026 · 36 MW · 15 17 Nov 2026 · 104 MW · 26 18 Nov 2026 · 4 MW · 2
27 Oct 1 Nov 6 Nov 11 Nov 17 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

Fire front film How it spread from one satellite pass to the next (56 passes) and with what wind. Watch the film

The weather it burned in

38°high
41km/h · peak gust
29%lowest humidity

It had gone 26 days without rain (1 mm or more) when it started.

This area had burned before

50% of the perimeter overlaps earlier fires recorded since 2016: 1,633 ha in 2024.

How big is it?

10 km
It burned the equivalent of 2% of the area of London (32 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Prainha 35,577 inhabitants where it started
    3,209 ha reached on 27 Oct
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Oct 33.6 °C 48 % 37 km/h 0.1 mm High 33
15 Oct 34.7 °C 42 % 38 km/h 0.0 mm High 34
16 Oct 35.1 °C 41 % 31 km/h 0.0 mm High 33
17 Oct 35.5 °C 42 % 28 km/h 0.2 mm High 30
18 Oct 35.2 °C 45 % 28 km/h 1.1 mm High 30
19 Oct 35.1 °C 43 % 31 km/h 0.6 mm Moderate 21
20 Oct 35.6 °C 43 % 32 km/h 1.4 mm High 27
21 Oct 34.9 °C 47 % 38 km/h 1.2 mm Moderate 18
22 Oct 36.5 °C 33 % 38 km/h 0.1 mm High 37
23 Oct 35.8 °C 37 % 29 km/h 0.1 mm High 28
24 Oct 36.8 °C 36 % 28 km/h 0.1 mm High 31
25 Oct 36.4 °C 44 % 34 km/h 0.0 mm High 35
26 Oct 35.1 °C 42 % 34 km/h 3.0 mm Moderate 18
27 Oct 38.0 °C 31 % 32 km/h 0.2 mm High 31
28 Oct 38.1 °C 29 % 30 km/h 0.1 mm High 34
29 Oct 36.4 °C 42 % 31 km/h 0.8 mm High 34
30 Oct 34.1 °C 49 % 35 km/h 2.6 mm High 28
31 Oct 35.4 °C 39 % 32 km/h 0.0 mm Moderate 21
1 Nov 36.3 °C 37 % 31 km/h 0.0 mm High 29
2 Nov 35.8 °C 43 % 36 km/h 0.9 mm High 24
3 Nov 35.5 °C 42 % 41 km/h 1.1 mm High 30
4 Nov 35.2 °C 45 % 31 km/h 0.8 mm Moderate 19
5 Nov 35.8 °C 35 % 34 km/h 0.5 mm High 28
6 Nov 34.8 °C 42 % 35 km/h 0.3 mm High 29
7 Nov 35.0 °C 44 % 36 km/h 0.3 mm High 33
8 Nov 36.0 °C 41 % 34 km/h 0.2 mm High 31
9 Nov 36.3 °C 41 % 33 km/h 1.8 mm High 33
10 Nov 33.5 °C 50 % 29 km/h 4.5 mm Low 8
11 Nov 35.0 °C 41 % 38 km/h 0.8 mm High 26
12 Nov 34.9 °C 44 % 38 km/h 0.9 mm High 26
13 Nov 35.3 °C 42 % 37 km/h 0.3 mm High 29
14 Nov 35.0 °C 44 % 31 km/h 0.6 mm High 26
15 Nov 35.4 °C 39 % 33 km/h 0.2 mm High 29
16 Nov 35.6 °C 37 % 34 km/h 0.1 mm High 32
17 Nov 35.3 °C 41 % 36 km/h 0.0 mm High 33
18 Nov 32.7 °C 57 % 32 km/h 0.0 mm High 26
19 Nov after 35.7 °C 44 % 34 km/h 0.4 mm High 28

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Oct 2026
After · 18 Nov 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 18 October 2026 the air beside the fire reached 400 µg/m³ of PM2.5. That day averaged 110: 7.4 times the WHO daily guideline (15).

PM2.5 peak400 µg/m³
Days over the guideline36 days
PM10404 µg/m³
Optical depth2.37
12 Oct20 Oct28 Oct5 Nov13 Nov
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 184Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Brazil

Frequently asked questions

How long did the Prainha fire last?
GWIS (Copernicus) dates it between 14 October 2026 and 18 November 2026: 36 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,186 hectares (31.9 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Prainha (3,209 ha, 0.2 %).
Is the Prainha fire still active?
No fire detections since 18 Nov 2026, 05:16 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 38.1 °C, humidity dropped to 29 % and gusts hit 41 km/h. The fire danger index (FWI) reached 37, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Brazil (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 18 November 2026.
  1. Page published (3,166 ha).

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 184 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.