Skip to content
worldfires
IT · Italy · –

Palazzo Adriano fire, 19 August 2020 Palazzo Adriano, Bivona

Out · last detection 20 Aug 2020, 12:55 UTC

The fire started on 19 August 2020 in Palazzo Adriano, Italy, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 109 hectares from satellite imagery, spread across 2 municipalities.

It is the 162th largest in Palermo since 2016 (of 179 with a page). Number 119 in Italy in 2020, of 140.

The power measured by the satellite is low (3.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
109ha
Copernicus perimeter
Duration
2days
19 Aug 2020 – 20 Aug 2020
Municipalities hit
2
municipalities
Started on
19 Aug
2020
Heat detections
9
in a single hotspot: 4 MW
Danger at start
34
High · FWI index
Average daily power
12MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 19 Aug20 Aug
20 Aug 2020

How it evolved, day by day

19 Aug 2020 · 2 MW · 2 20 Aug 2020 · 21 MW · 7
19 Aug 20 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
33km/h · peak gust
35%lowest humidity

It had gone 35 days without rain (1 mm or more) when it started.

This area had burned before

15% of the perimeter overlaps earlier fires recorded since 2016: 16 ha in 2018.

What happened to each town

  1. Palazzo Adriano 1,814 inhabitants · 7.8 km from the centre where it started
    92 ha reached on 19 Aug
    0.7 %
  2. 17 ha reached on 20 Aug
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub59 %
  • Agricultural areas41 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
19 Aug 29.4 °C 35 % 33 km/h 0.0 mm High 34
20 Aug 28.5 °C 49 % 28 km/h 0.0 mm High 30
21 Aug after 28.6 °C 55 % 30 km/h 0.0 mm High 28
22 Aug after 29.4 °C 49 % 33 km/h 0.0 mm High 28
23 Aug after 31.2 °C 44 % 34 km/h 0.0 mm High 33
24 Aug after 28.9 °C 48 % 33 km/h 0.0 mm High 27
25 Aug after 29.1 °C 40 % 33 km/h 0.0 mm High 28
26 Aug after 28.0 °C 51 % 30 km/h 0.0 mm High 28
27 Aug after 29.9 °C 39 % 31 km/h 0.0 mm High 31
28 Aug after 28.8 °C 45 % 30 km/h 0.0 mm High 31
29 Aug after 27.2 °C 56 % 42 km/h 0.0 mm High 37
30 Aug after 28.0 °C 54 % 38 km/h 0.0 mm High 32

Its twins: fires that started in the same weather

It started with an FWI of 33.5, a minimum humidity of 35% and 35 days without rain. Fires in the area that started in weather like this since 2016: 16.

FWI at the start 33.5
Minimum humidity 35 %
Days without rain 35
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Ravanusa fire, July 2026
210 ha 5 days FWI 33.6 Min. humidity 35 % 67 km away, in 2026

First rain (1 mm or more) after it ended: 2.7 mm on 13 Aug.

What happened to them

2 days
median duration
230 ha
median area
0 %
went past 1,000 ha
3.0 mm
rain at the end (median; 8 of 16 had it)

It stayed below its twins: 109 ha against a median of 230 ha. It lasted 2 days, against 2 days.

In 8 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
33km/h · max. gust

It was considered over on 20 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 8 of 16, with a median of 3.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 12 Aug 2020
After · 27 Aug 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 August 2020 the air beside the fire reached 18 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak18 µg/m³
Days over the guideline0 days
PM1031 µg/m³
17 Aug19 Aug21 Aug23 Aug
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy

Frequently asked questions

How long did the Palazzo Adriano fire last?
Copernicus dates it between 19 August 2020 and 20 August 2020: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 109 hectares (1.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Palazzo Adriano (92 ha, 0.7 %); Bivona (17 ha, 0.2 %).
Did the fire reach a town?
The fire started in Palazzo Adriano and came within 7.8 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 29.4 °C, humidity dropped to 35 % and gusts hit 33 km/h. The fire danger index (FWI) reached 34, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 16. Their median duration was 2 days and their median area 230 ha; 0 % went past 1,000 ha. In 8 of 16, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.