Skip to content
worldfires
BR · Brazil · –

Olho d'Água fire, October 2021 Olho d'Água, Imaculada

Out · last detection

The fire started on in Olho d'Água, Brazil, and satellites saw it burning for 17 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 4,873 hectares from heat detections, spread across 2 municipalities.

Number 414 in Brazil in 2021, of 814.

Burnt area
4,873ha
GWIS perimeter (Copernicus)
Duration
17days
25 Oct 2021 – 10 Nov 2021
Municipalities hit
2
municipalities
Started on
25 Oct
2021
Heat detections
167
in a single hotspot: 181 MW
Danger at start
55
Extreme · FWI index
Average daily power
281MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 25 Oct10 Nov
10 Nov 2021

How it evolved, day by day

25 Oct 2021 · 585 MW · 13 26 Oct 2021 · 765 MW · 36 27 Oct 2021 · 625 MW · 34 28 Oct 2021 · 282 MW · 12 29 Oct 2021 · 307 MW · 24 30 Oct 2021 · 67 MW · 7 1 Nov 2021 · 99 MW · 7 2 Nov 2021 · 489 MW · 19 4 Nov 2021 · 19 MW · 4 6 Nov 2021 · 105 MW · 7 8 Nov 2021 · 13 MW · 2 10 Nov 2021 · 22 MW · 2
26 Oct 1 Nov 6 Nov

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
42km/h · peak gust
22%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

82% of the perimeter overlaps earlier fires recorded since 2016: 3,995 ha in 2019.

How big is it?

10 km
It burned the equivalent of 3.1% of the area of London (49 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Olho d'Água 6,060 inhabitants where it started
    4,904 ha reached on 25 Oct
    8.4 %
  2. Imaculada 10,392 inhabitants
    0 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.56 ha
Residents≈ 40

Inside the perimeter there were about 0.56 hectares of built-up land and about 40 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 46 % of the area in Brazil 60 days without rain: 55 % of the area in Brazil

Day High Min. humidity Peak gust Rain Danger (FWI)
25 Oct 37.8 °C 22 % 42 km/h 0.0 mm Extreme 55
26 Oct 36.3 °C 24 % 42 km/h 0.0 mm Extreme 58
27 Oct 35.7 °C 25 % 40 km/h 0.0 mm Extreme 62
28 Oct 36.4 °C 24 % 41 km/h 0.0 mm Extreme 58
29 Oct 36.0 °C 25 % 38 km/h 0.0 mm Extreme 55
30 Oct 35.2 °C 29 % 37 km/h 0.0 mm Very high 43
31 Oct 36.2 °C 27 % 42 km/h 0.0 mm Very high 43
1 Nov 36.0 °C 30 % 38 km/h 0.0 mm Very high 47
2 Nov 36.1 °C 29 % 37 km/h 0.0 mm Extreme 50
3 Nov 35.7 °C 30 % 30 km/h 0.0 mm Very high 42
4 Nov 36.1 °C 28 % 37 km/h 0.0 mm Very high 46
5 Nov 35.6 °C 31 % 32 km/h 0.0 mm Very high 40
6 Nov 35.3 °C 31 % 31 km/h 0.0 mm Very high 45
7 Nov 35.8 °C 30 % 31 km/h 0.0 mm Very high 44
8 Nov 35.8 °C 30 % 35 km/h 0.0 mm Very high 39
9 Nov 36.4 °C 23 % 40 km/h 0.0 mm Extreme 54
10 Nov 36.8 °C 25 % 36 km/h 0.0 mm Very high 49
11 Nov after 37.0 °C 27 % 37 km/h 0.1 mm Very high 48
12 Nov after 37.7 °C 21 % 32 km/h 0.0 mm Extreme 50
13 Nov after 37.3 °C 23 % 38 km/h 0.0 mm Very high 42
14 Nov after 35.9 °C 26 % 38 km/h 0.0 mm Very high 49
15 Nov after 36.1 °C 23 % 44 km/h 0.0 mm Extreme 54
16 Nov after 36.1 °C 25 % 42 km/h 0.0 mm Extreme 57
17 Nov after 37.2 °C 22 % 42 km/h 0.0 mm Very high 50
18 Nov after 36.7 °C 24 % 44 km/h 0.0 mm Very high 48
19 Nov after 37.1 °C 24 % 44 km/h 0.0 mm Very high 49
20 Nov after 36.7 °C 21 % 37 km/h 0.0 mm Very high 50

Its twins: fires that started in the same weather

It started with an FWI of 54.6, a minimum humidity of 22% and more than two months without rain. Fires in the area that started in weather like this since 2018: 13.

FWI at the start 54.6
Minimum humidity 22 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Olho d'Água fire, October 2019
6,186 ha 32 days FWI 53.0 Min. humidity 24 % 1 km away, in 2019

First rain (1 mm or more) after it ended: 1.2 mm on 26 Nov.

What happened to them

Fires in the area that started in similar weather: 13. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
42km/h · max. gust

It was considered over on 10 Nov, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2018.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 18 Oct 2021
After · 17 Nov 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 167Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Brazil

Frequently asked questions

How long did the Olho d'Água fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 25 October 2021 to 10 November 2021 (17 days). The perimeter dates it from 25 October 2021 to 8 November 2021.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 4,873 hectares (48.7 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Olho d'Água (4,904 ha, 8.4 %); Imaculada (0 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 37.8 °C, humidity dropped to 22 % and gusts hit 42 km/h. The fire danger index (FWI) reached 62, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Brazil (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 8 November 2021 → 10 November 2021.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 25 October 2021 to 8 November 2021. 167 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.