Skip to content
worldfires
BW · Botswana · –

Ngamiland East fire, 4 June 2018 Ngamiland East

Out · last detection 12 Jun 2018, 00:09 UTC

The fire started on 4 June 2018 in Ngamiland East, Botswana, and satellites saw it burning for 9 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 10,981 hectares from heat detections, spread across a single municipality.

It is the 68th largest in North-West District since 2016 (of 516 with a page). Number 17 in Botswana in 2018, of 93.

Burnt area
10,981ha
GWIS perimeter (Copernicus)
Duration
9days
4 Jun 2018 – 12 Jun 2018
Municipalities hit
1
subdistricts
Started on
4 Jun
2018
Heat detections
399
in a single hotspot: 80 MW
Danger at start
48
Very high · FWI index
Average daily power
333MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 4 Jun12 Jun
12 Jun 2018

How it evolved, day by day

4 Jun 2018 · 508 MW · 49 5 Jun 2018 · 1,168 MW · 122 6 Jun 2018 · 859 MW · 134 7 Jun 2018 · 302 MW · 61 8 Jun 2018 · 133 MW · 22 9 Jun 2018 · 11 MW · 3 10 Jun 2018 · 10 MW · 3 11 Jun 2018 · 4 MW · 2 12 Jun 2018 · 5 MW · 3
5 Jun 8 Jun 10 Jun 12 Jun

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

28°high
41km/h · peak gust
18%lowest humidity

It had gone 52 days without rain (1 mm or more) when it started.

This area had burned before

22% of the perimeter overlaps earlier fires recorded since 2016: 2,408 ha in 2016.

How big is it?

10 km
It burned the equivalent of 6.9% of the area of London (110 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Ngamiland East where it started
    11,035 ha
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.13 ha
Residents< 20

Inside the perimeter there were about 0.13 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
4 Jun 27.5 °C 19 % 36 km/h 0.0 mm Very high 48
5 Jun 23.3 °C 28 % 41 km/h 0.0 mm Extreme 51
6 Jun 22.2 °C 28 % 41 km/h 0.0 mm Extreme 51
7 Jun 22.9 °C 25 % 32 km/h 0.0 mm Very high 44
8 Jun 24.5 °C 23 % 32 km/h 0.0 mm Very high 43
9 Jun 25.4 °C 20 % 27 km/h 0.0 mm Very high 40
10 Jun 25.1 °C 20 % 26 km/h 0.0 mm Very high 40
11 Jun 24.9 °C 18 % 35 km/h 0.0 mm Extreme 51
12 Jun 24.2 °C 22 % 34 km/h 0.0 mm Very high 46
13 Jun after 23.9 °C 29 % 29 km/h 0.0 mm Very high 38
14 Jun after 24.9 °C 29 % 26 km/h 0.0 mm High 34
15 Jun after 27.0 °C 23 % 18 km/h 0.0 mm High 28
16 Jun after 27.6 °C 20 % 19 km/h 0.0 mm High 36
17 Jun after 28.0 °C 18 % 34 km/h 0.0 mm Extreme 53
18 Jun after 27.6 °C 19 % 23 km/h 0.0 mm Very high 42
19 Jun after 27.0 °C 24 % 24 km/h 0.0 mm Very high 44
20 Jun after 27.6 °C 22 % 29 km/h 0.0 mm Very high 47
21 Jun after 27.0 °C 24 % 27 km/h 0.0 mm Very high 43
22 Jun after 26.6 °C 25 % 31 km/h 0.0 mm Very high 47

Its twins: fires that started in the same weather

It started with an FWI of 48.4, a minimum humidity of 19% and 52 days without rain. Fires in the area that started in weather like this since 2016: 23.

FWI at the start 48.4
Minimum humidity 19 %
Days without rain 52
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Ngamiland East fire, September 2021
2,654 ha 7 days FWI 49.7 Min. humidity 18 % 9 km away, in 2021

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

7 days
median duration
3,243 ha
median area
4 %
went past 10,000 ha
1.1 mm
rain at the end (median; 1 of 23 had it)

It was 3.4 times larger than the median of its twins and lasted 9 days, against 7 days.

Only 1 of its 23 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 22 of 23, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.1 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
41km/h · max. gust

It was considered over on 12 Jun, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 1 of 23, with a median of 1.1 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 28 May 2018
After · 19 Jun 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 399Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Botswana

Frequently asked questions

How long did the Ngamiland East fire last?
GWIS (Copernicus) dates it between 4 June 2018 and 12 June 2018: 9 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 10,981 hectares (109.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Ngamiland East (11,035 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 27.5 °C, humidity dropped to 18 % and gusts hit 41 km/h. The fire danger index (FWI) reached 51, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Botswana (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 23. Their median duration was 7 days and their median area 3,243 ha; 4 % went past 10,000 ha. Only 1 of its 23 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 22 of 23, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.1 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 399 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.