Skip to content
worldfires
ES · Spain · →

Nacimiento fire, August 2026 Las Tres Villas, Nacimiento

Out · last detection 25 Aug 2026, 02:11 UTC

The fire started on 24 August 2026 in Nacimiento, Spain, and satellites saw it burning for 10 days. Copernicus mapped a burnt perimeter of 300 hectares from satellite imagery, spread across 2 municipalities.

It is the 12th largest in Almeria since 2016 (of 16 with a page). Number 76 in Spain in 2026, of 195.

The power measured by the satellite is low (13.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
300ha
Copernicus perimeter
Duration
10days
24 Aug 2026 – 2 Sept 2026
Municipalities hit
2
municipalities
Started on
24 Aug
2026
Heat detections
1
in a single hotspot: 14 MW
Danger at start
59
Extreme · FWI index
Energy released
14MW
sum of detected power

Where it burned

HOTSPOTS BY DAY 24 Aug2 Sept

How it evolved, day by day

25

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
53km/h · peak gust
13%lowest humidity

It had gone 13 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Las Tres Villas 547 inhabitants · 1.2 km from the town
    152 ha
    1.8 %
  2. Nacimiento 485 inhabitants · 5.0 km from the town where it started
    148 ha reached on 25 Aug
    1.8 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub44 %
  • Agricultural areas23 %
  • Coniferous forest19 %
  • Other natural land13 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
24 Aug 31.5 °C 13 % 53 km/h 0.0 mm Extreme 59
25 Aug 33.7 °C 15 % 30 km/h 0.0 mm Very high 45
26 Aug 34.3 °C 10 % 50 km/h 0.0 mm Extreme 55
27 Aug 31.4 °C 10 % 43 km/h 0.0 mm Extreme 62
28 Aug 26.6 °C 32 % 69 km/h 0.0 mm High 36
29 Aug 28.2 °C 27 % 26 km/h 0.0 mm Very high 38
30 Aug 31.2 °C 22 % 26 km/h 0.0 mm Very high 39
31 Aug 33.0 °C 23 % 27 km/h 0.0 mm Very high 40
1 Sept 29.5 °C 31 % 35 km/h 0.0 mm High 37
2 Sept 31.0 °C 33 % 24 km/h 0.0 mm High 36
3 Sept after 32.5 °C 38 % 29 km/h 0.0 mm High 36

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 17 Aug 2026
After · 9 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 27 August 2026 the air beside the fire reached 26 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak26 µg/m³
Days over the guideline0 days
PM1033 µg/m³
Optical depth0.38
222324252627
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Nacimiento fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 24 August 2026 to 2 September 2026 (10 days). The perimeter dates it from 24 August 2026 to 24 August 2026.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 300 hectares (3.0 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Las Tres Villas (152 ha, 1.8 %); Nacimiento (148 ha, 1.8 %).
Did the fire reach a town?
The closest fire to a town centre came within 1.2 km of Las Tres Villas. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 31.5 °C, humidity dropped to 13 % and gusts hit 53 km/h. The fire danger index (FWI) reached 59, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.