Skip to content
worldfires
ES · Spain · →

Monóvar/Monòver fire, July 2020 Monóvar/Monòver

Out · last detection 16 Jul 2020, 13:52 UTC

The fire started on 16 July 2020 in Monóvar/Monòver, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 140 hectares from satellite imagery, spread across a single municipality. According to EGIF (MITECO), it was detected on 16 July 2020 at 12:03 and declared extinguished on 19 July 2020.

It is the 10th largest in Alacant / Alicante since 2016 (of 10 with a page). Number 67 in Spain in 2020, of 89.

Compare with…

Suggestions: Beneixama · 2019Jumilla · 2022

Burnt area
140ha
Copernicus perimeter
Duration
1day
16 Jul 2020 – 16 Jul 2020
Municipalities hit
1
municipalities
Started on
16 Jul
2020
Heat detections
17
in a single hotspot: 87 MW
Danger at start
27
High · FWI index
Average daily power
557MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 16 Jul16 Jul

How it evolved, day by day

16 Jul 2020 · 557 MW · 17

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

30°high
34km/h · peak gust
37%lowest humidity

It had gone one day without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Monóvar/Monòver 13,116 inhabitants · 6.7 km from the centre where it started
    140 ha reached on 16 Jul
    0.9 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Coniferous forest86 %
  • Scrub and transitional woodland10 %
  • Agricultural areas3.6 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to EGIF (MITECO), this fire started on 16 July 2020 and burned 140 ha (the satellite measured 140 ha).

MITECO, Estadística General de Incendios Forestales (EGIF). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
16 Jul 30.5 °C 37 % 34 km/h 0.0 mm High 27
17 Jul after 30.2 °C 42 % 36 km/h 0.2 mm High 29
18 Jul after 31.1 °C 40 % 39 km/h 0.0 mm High 30
19 Jul after 32.6 °C 35 % 36 km/h 0.0 mm High 32
20 Jul after 33.1 °C 34 % 37 km/h 0.2 mm High 31
21 Jul after 33.0 °C 28 % 43 km/h 0.0 mm Very high 38
22 Jul after 31.8 °C 32 % 41 km/h 0.0 mm Very high 38
23 Jul after 34.5 °C 20 % 37 km/h 0.0 mm Very high 44
24 Jul after 33.1 °C 38 % 35 km/h 0.5 mm High 37
25 Jul after 33.9 °C 31 % 32 km/h 0.0 mm High 34
26 Jul after 36.1 °C 27 % 37 km/h 0.0 mm Very high 40

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 9 Jul 2020
After · 23 Jul 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 16 July 2020 the air beside the fire reached 10 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak10 µg/m³
Days over the guideline0 days
PM1016 µg/m³
141516171819
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 17Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Monóvar/Monòver fire last?
Copernicus dates it between 16 July 2020 and 16 July 2020: 1 day between the first and last image with fire. According to EGIF (MITECO), it was detected on 16 July 2020 at 12:03 and declared extinguished on 19 July 2020.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 140 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Monóvar/Monòver (140 ha, 0.9 %).
Did the fire reach a town?
The fire started in Monóvar/Monòver and came within 6.7 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 30.5 °C, humidity dropped to 37 % and gusts hit 34 km/h. The fire danger index (FWI) reached 27, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 17 Suomi-NPP VIIRS detections on those dates.
  • Compared with EGIF (MITECO): 140 official ha against 140 ha of perimeter; they agree within 25%.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.