Skip to content
worldfires
PT · Portugal ·

Monção e Troviscoso fire, October 2018 Monção e Troviscoso, Longos Vales, Cambeses

Out · last detection 3 Oct 2018, 14:20 UTC

The fire started on 3 October 2018 in Monção e Troviscoso, Portugal, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 154 hectares from satellite imagery, spread across 3 freguesias.

It is the 10th largest in Monção since 2016 (of 11 with a page). Number 16 in Portugal in 2018, of 23.

The power measured by the satellite is low (8.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
154ha
Copernicus perimeter
Duration
1day
3 Oct 2018 – 3 Oct 2018
Freguesias hit
3
freguesias
Started on
3 Oct
2018
Heat detections
5
in a single hotspot: 8 MW
Danger at start
24
High · FWI index
Average daily power
38MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 3 Oct3 Oct

How it evolved, day by day

3 Oct 2018 · 38 MW · 5

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
21km/h · peak gust
28%lowest humidity

It had gone 27 days without rain (1 mm or more) when it started. Rain came after the fire: 16.3 mm on 11 Oct.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each freguesia

  1. Monção e Troviscoso 3,279 inhabitants · fire reached the centre where it started
    117 ha reached on 3 Oct
    14 %
  2. Longos Vales 863 inhabitants · 1.4 km from the centre
    33 ha
    2.4 %
  3. Cambeses 496 inhabitants · 1.2 km from the centre
    3 ha reached on 3 Oct
    0.8 %

Burnt area inside each freguesia, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland67 %
  • Agricultural areas26 %
  • Coniferous forest7.1 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.82 ha
Residents< 20

Inside the perimeter there were about 0.82 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

Official record

According to ICNF, this fire started on 3 October 2018 and burned 66 ha (the satellite measured 154 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

ICNF (Instituto da Conservação da Natureza e das Florestas). This is the agency’s operational record: its figures may be revised when the year’s statistics are closed.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Oct 28.6 °C 28 % 21 km/h 0.0 mm High 24
4 Oct after 28.0 °C 30 % 24 km/h 0.0 mm High 27
5 Oct after 22.2 °C 45 % 27 km/h 0.0 mm High 26
6 Oct after 19.6 °C 61 % 45 km/h 0.0 mm High 22
7 Oct after 20.7 °C 39 % 53 km/h 0.0 mm High 27
8 Oct after 23.4 °C 40 % 24 km/h 0.0 mm Moderate 20
9 Oct after 24.2 °C 37 % 23 km/h 0.0 mm Moderate 19
10 Oct after 22.4 °C 41 % 62 km/h 0.0 mm High 36
11 Oct after 20.2 °C 63 % 71 km/h 16.3 mm Very low 1

Its twins: fires that started in the same weather

It started with an FWI of 23.9, a minimum humidity of 28% and 27 days without rain. Fires in the area that started in weather like this since 2016: 24.

FWI at the start 23.9
Minimum humidity 28 %
Days without rain 27
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Portela e Extremo fire, September 2020
114 ha 2 days FWI 24.5 Min. humidity 28 % 12 km away, in 2020

First rain (1 mm or more) after it ended: 3.8 mm on 14 Sept.

What happened to them

2 days
median duration
380 ha
median area
17 %
went past 1,000 ha
6.5 mm
rain at the end (median; 19 of 24 had it)

It stayed below its twins: 154 ha against a median of 380 ha. It lasted 1 day, against 2 days.

In 5 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 6.5 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

16.3 mmfirst rain
11 Oct8 days after it ended
21km/h · max. gust

It was considered over on 3 Oct, and on 11 Oct 16.3 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 19 of 24, with a median of 6.5 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 26 Sept 2018
After · 10 Oct 2018

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 6 October 2018 the air beside the fire reached 16 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak16 µg/m³
Days over the guideline0 days
PM1024 µg/m³
1 Oct3 Oct5 Oct
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Portugal

Frequently asked questions

How long did the Monção e Troviscoso fire last?
Copernicus dates it between 3 October 2018 and 3 October 2018: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 154 hectares (1.5 km²). Official national figures may differ.
Which freguesias burned?
The fire entered 3 freguesias: Monção e Troviscoso (117 ha, 14 %); Longos Vales (33 ha, 2.4 %); Cambeses (3 ha, 0.8 %).
Did the fire reach a town?
The fire started in Monção e Troviscoso and reached its centre: the point marking it was inside the burnt area or less than 500 metres from it. That does not mean houses burned.
What was the weather like?
During the fire the temperature reached 28.6 °C, humidity dropped to 28 % and gusts hit 21 km/h. The fire danger index (FWI) reached 24, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Portugal (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 24. Their median duration was 2 days and their median area 380 ha; 17 % went past 1,000 ha. In 5 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 6.5 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 5 Suomi-NPP VIIRS detections on those dates.
  • Compared with ICNF: 66 official ha against 154 ha of perimeter; similar, but with reservations.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Freguesia boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per freguesia is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.