Skip to content
worldfires
ID · Indonesia · –

Merauke fire, 10 November 2023 Merauke

Out · last measured on 13 Nov 2023

The fire started on 10 November 2023 in Merauke, Indonesia, and satellites saw it burning for 4 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,825 hectares from heat detections, spread across a single municipality.

It is the 56th largest in Papua since 2016 (of 88 with a page). Number 98 in Indonesia in 2023, of 162.

We have the GWIS perimeter for this fire, but the VIIRS sensors did not capture it in enough detail: no day-by-day evolution, but the split by municipality is there.

Burnt area
1,825ha
GWIS perimeter (Copernicus)
Duration
4days
10 Nov 2023 – 13 Nov 2023
Municipalities hit
1
regencies
Started on
10 Nov
2023
Danger at start
10
Low · FWI index

Where it burned

The weather it burned in

36°high
35km/h · peak gust
34%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started. Rain came after the fire: 6.9 mm on 21 Nov.

This area had burned before

24% of the perimeter overlaps earlier fires recorded since 2016: 430 ha in 2018.

How big is it?

10 km
It burned the equivalent of 1.2% of the area of London (18 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Merauke where it started
    1,836 ha
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 Nov 33.8 °C 47 % 28 km/h 0.5 mm Low 10
11 Nov 34.8 °C 40 % 30 km/h 0.0 mm Moderate 16
12 Nov 34.9 °C 36 % 34 km/h 0.0 mm Moderate 21
13 Nov 35.8 °C 34 % 35 km/h 0.0 mm Moderate 21
14 Nov after 35.6 °C 39 % 28 km/h 0.0 mm Moderate 18
15 Nov after 34.1 °C 47 % 27 km/h 0.3 mm Moderate 18
16 Nov after 34.4 °C 49 % 22 km/h 0.9 mm Moderate 14
17 Nov after 34.6 °C 49 % 27 km/h 0.7 mm Moderate 16
18 Nov after 34.4 °C 42 % 27 km/h 0.0 mm Moderate 19
19 Nov after 34.5 °C 47 % 30 km/h 0.3 mm Moderate 20
20 Nov after 34.5 °C 50 % 35 km/h 0.2 mm High 22
21 Nov after 35.6 °C 49 % 34 km/h 6.9 mm High 25

Its twins: fires that started in the same weather

It started with an FWI of 10.5, a minimum humidity of 47% and 2 days without rain. Fires in the area that started in weather like this since 2016: 20.

FWI at the start 10.5
Minimum humidity 47 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Merauke fire, January 2016
2,550 ha 9 days FWI 8.2 Min. humidity 47 % 107 km away, in 2016

First rain (1 mm or more) after it ended: 6.5 mm on 20 Jan.

What happened to them

7 days
median duration
2,358 ha
median area
100 %
went past 1,000 ha
4.0 mm
rain at the end (median; 20 of 20 had it)

It burned an area similar to its twins (1,825 ha against a median of 2,358 ha) and lasted 4 days, against 7 days.

All of them had rain in the ten days after the end: the first rainy day brought a median of 4.0 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

6.9 mmfirst rain
21 Nov8 days after it ended
35km/h · max. gust

It was considered over on 13 Nov, and on 21 Nov 6.9 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 20 of 20, with a median of 4.0 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 Nov 2023
After · 20 Nov 2023

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 14 November 2023 the air beside the fire reached 170 µg/m³ of PM2.5. That day averaged 62: 4.1 times the WHO daily guideline (15).

PM2.5 peak170 µg/m³
Days over the guideline9 days
PM10244 µg/m³
Optical depth3.52
8 Nov10 Nov12 Nov14 Nov16 Nov
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Other fires nearby

All fires in Indonesia

Frequently asked questions

How long did the Merauke fire last?
GWIS (Copernicus) dates it between 10 November 2023 and 13 November 2023: 4 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,825 hectares (18.2 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Merauke (1,836 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 35.8 °C, humidity dropped to 34 % and gusts hit 35 km/h. The fire danger index (FWI) reached 21, class Moderate.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Indonesia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 20. Their median duration was 7 days and their median area 2,358 ha; 100 % went past 1,000 ha. All of them had rain in the ten days after the end: the first rainy day brought a median of 4.0 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. No Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.