Skip to content
worldfires
IT · Italy · →

Letojanni fire, August 2026 Letojanni, Gallodoro

Out · last detection 1 Sept 2026, 11:21 UTC

The fire started on 30 August 2026 in Letojanni, Italy, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 384 hectares from satellite imagery, spread across 2 municipalities.

It is the 18th largest in Messina since 2016 (of 70 with a page). Number 45 in Italy in 2026, of 231.

Compare with…
Burnt area
384ha
Copernicus perimeter
Duration
≈ 3days
30 Aug 2026 – 1 Sept 2026
Municipalities hit
2
municipalities
Started on
30 Aug
2026
Heat detections
28
in a single hotspot: 56 MW
Danger at start
32
High · FWI index
Average daily power
146MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 30 Aug1 Sept
1 Sept 2026

How it evolved, day by day

30 Aug 2026 · 58 MW · 7 31 Aug 2026 · 27 MW · 7 1 Sept 2026 · 354 MW · 14
30 Aug 31 Aug 1 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

33°high
30km/h · peak gust
44%lowest humidity

It had gone 17 days without rain (1 mm or more) when it started.

This area had burned before

22% of the perimeter overlaps earlier fires recorded since 2016: 36 ha in 2020, 22 ha in 2021, 36 ha in 2022. Part of it burned more than once, so the yearly figures add up to more than the 84 ha that had burned before.

What happened to each town

  1. Letojanni 2,842 inhabitants · fire reached the centre where it started
    229 ha reached on 30 Aug
    33 %
  2. Gallodoro 336 inhabitants · 1.0 km from the centre
    155 ha reached on 31 Aug
    23 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas57 %
  • Other natural land30 %
  • Sclerophyllous scrub12 %
  • Artificial surfaces1.6 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
31 Aug 32.9 °C 44 % 30 km/h 0.0 mm High 32
1 Sept 32.4 °C 38 % 34 km/h 0.0 mm High 34
2 Sept after 32.6 °C 32 % 31 km/h 0.0 mm High 34
3 Sept after 32.5 °C 33 % 30 km/h 0.0 mm High 33
4 Sept after 32.0 °C 39 % 30 km/h 0.0 mm High 33
5 Sept after 32.2 °C 30 % 25 km/h 0.0 mm High 34
6 Sept after 32.3 °C 35 % 28 km/h 0.0 mm High 35
7 Sept after 31.6 °C 38 % 23 km/h 0.0 mm High 33
8 Sept after 30.6 °C 48 % 21 km/h 0.0 mm High 27
9 Sept after 30.2 °C 46 % 24 km/h 0.0 mm High 28
10 Sept after 29.8 °C 40 % 24 km/h 0.0 mm High 28

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 23 Aug 2026
After · 8 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 3 September 2026 the air beside the fire reached 40 µg/m³ of PM2.5. That day averaged 20: 1.3 times the WHO daily guideline (15).

PM2.5 peak40 µg/m³
Days over the guideline3 days
PM1073 µg/m³
Optical depth0.70
293031123
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 28Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Letojanni fire last?
The official perimeter only gives the start date (31 August 2026). The end comes from the heat detections inside the perimeter: it burned until 1 September 2026 (3 days from 30 August 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 384 hectares (3.8 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Letojanni (229 ha, 33 %); Gallodoro (155 ha, 23 %).
Did the fire reach a town?
The fire started in Letojanni and reached its centre: the point marking it was inside the burnt area or less than 500 metres from it. That does not mean houses burned.
What was the weather like?
During the fire the temperature reached 32.9 °C, humidity dropped to 44 % and gusts hit 30 km/h. The fire danger index (FWI) reached 32, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 28 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.