Skip to content
worldfires
DZ · Algeria · →

Larhat fire, July 2020 لارهاط · Larhat

Out · last detection 27 Jul 2020, 13:46 UTC

The fire started on 25 July 2020 in Larhat, Algeria, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 158 hectares from satellite imagery, spread across a single municipality.

It is the 40th largest in Tipaza since 2016 (of 59 with a page). Number 163 in Algeria in 2020, of 236.

The power measured by the satellite is low (25.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
158ha
Copernicus perimeter
Duration
2days
25 Jul 2020 – 26 Jul 2020
Municipalities hit
1
communes
Started on
25 Jul
2020
Heat detections
17
in a single hotspot: 25 MW
Danger at start
32
High · FWI index
Energy released
108MW
sum of detected power

Where it burned

27 Jul 2020
HOTSPOTS BY DAY 25 Jul26 Jul

How it evolved, day by day

2627

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
36km/h · peak gust
29%lowest humidity

It had gone 47 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Larhat لارهاط 7,359 inhabitants · 4.9 km from the town where it started
    158 ha reached on 26 Jul
    2.5 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest78 %
  • Other natural land20 %
  • Broadleaved forest1.9 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
25 Jul 31.8 °C 29 % 36 km/h 0.0 mm High 32
26 Jul 32.4 °C 36 % 35 km/h 0.0 mm High 36
27 Jul after 33.6 °C 29 % 31 km/h 0.0 mm High 34
28 Jul after 31.1 °C 42 % 27 km/h 0.0 mm High 29
29 Jul after 30.5 °C 48 % 29 km/h 0.0 mm High 27
30 Jul after 32.2 °C 45 % 27 km/h 0.0 mm High 26
31 Jul after 32.3 °C 38 % 28 km/h 0.0 mm High 29
1 Aug after 32.5 °C 46 % 29 km/h 0.0 mm High 27
2 Aug after 34.3 °C 34 % 30 km/h 0.0 mm High 31
3 Aug after 31.9 °C 33 % 45 km/h 0.0 mm High 35
4 Aug after 28.2 °C 52 % 44 km/h 0.0 mm High 31
5 Aug after 29.1 °C 40 % 42 km/h 0.0 mm High 31

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 18 Jul 2020
After · 2 Aug 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 28 July 2020 the air beside the fire reached 32 µg/m³ of PM2.5. That day averaged 22: 1.5 times the WHO daily guideline (15).

PM2.5 peak32 µg/m³
Days over the guideline4 days
PM1052 µg/m³
232425262728293031
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 17Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Larhat fire last?
Copernicus dates it between 25 July 2020 and 26 July 2020: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 158 hectares (1.6 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Larhat (158 ha, 2.5 %).
Did the fire reach a town?
The closest fire to a town centre came within 4.9 km of Larhat. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 32.4 °C, humidity dropped to 29 % and gusts hit 36 km/h. The fire danger index (FWI) reached 36, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.