Skip to content
worldfires
CN · China · –

Lanxi County fire, 15 November 2026 兰西县 · Qinggang County, Lanxi County, Anda City

Dying down · last detection 17 Nov 2026, 04:14 UTC

The fire started on 15 November 2026 in Lanxi County, China, and satellites saw it burning for 3 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,564 hectares from heat detections, spread across 3 municipalities.

Number 627 in China in 2026, of 1146.

GWIS near-real-time perimeter, from the layer that changed in October 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.

The power measured by the satellite is low (14.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Is it still active?

No detections since 17 Nov 2026, 04:14 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Wind, humidity and rain for the next 72 h

Burnt area
1,564ha
GWIS perimeter (Copernicus)
Duration
3days
15 Nov 2026 – 17 Nov 2026
Municipalities hit
3
counties
Started on
15 Nov
2026
Heat detections
52
in a single hotspot: 14 MW
Danger at start
9
Low · FWI index
Average daily power
116MW
detected power per day, on average

The next 72 hours

The wind is blowing from the south-west and pushing to the north-east; no sharp shifts are expected until Sat 21, 06:00.

ECMWF IFS 0.25° at the centre of the fire · computed 17 Nov 2026, 23:22 UTC

No sharp changes in the next 72 h

No strong wind shifts and no dry nights. No warnings does not mean the fire will go out: in this weather it can carry on as it is.

Checked, no warning: no wind shifts of more than 60° nights recover humidity (peaks of 65 % or more) no useful rain expected (1.3 mm in 72 h)

Hour by hour, local time

Tap the strip to see each hour

Mean wind Gusts where it blows to Relative humidity Night (8 pm to 8 am) Rain (mm) · chance in %

Where is it blowing? The next 48 h

geoBoundaries/Lee Beryman, OpenStreetMap (Open Data Commons Open Database License 1.0)

At this hour

Places the fan reaches

    Is it heading my way?

    We compare your point with the fan for each hour. Your location never leaves your device.

    or tap the map

    This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.

    Emergencies · China 119 Emergency number and official warnings

    Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).

    Fire: GWIS / Copernicus (reconstructed from VIIRS) (CC BY 4.0); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/Lee Beryman, OpenStreetMap (Open Data Commons Open Database License 1.0).

    How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology

    Where it burned

    HOTSPOTS BY DAY 15 Nov17 Nov
    17 Nov 2026

    How it evolved, day by day

    15 Nov 2026 · 2 MW · 1 16 Nov 2026 · 335 MW · 49 17 Nov 2026 · 11 MW · 2
    15 Nov 16 Nov 17 Nov

    Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

    Fire front film How it spread from one satellite pass to the next (6 passes) and with what wind. Watch the film

    The weather it burned in

    2°high
    31km/h · peak gust
    27%lowest humidity

    It had gone 9 days without rain (1 mm or more) when it started.

    This area had burned before

    34% of the perimeter overlaps earlier fires recorded since 2016: 150 ha in 2017, 627 ha in 2024. Part of it burned more than once, so the yearly figures add up to more than the 535 ha that had burned before.

    How big is it?

    10 km
    It burned the equivalent of 1% of the area of London (16 km² against 1,583 km²).

    London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

    This compares size, not location: both shapes are at the same scale, north up, centred on each other.

    What happened to each town

    1. Qinggang County 青冈县
      1,378 ha reached on 16 Nov
      0.5 %
    2. Lanxi County 兰西县 where it started
      173 ha reached on 15 Nov
      0.1 %
    3. Anda City 安达市
      10 ha
      0.0 %

    Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

    The weather day by day

    ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

    Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

    Day High Min. humidity Peak gust Rain Danger (FWI)
    15 Nov 2.4 °C 46 % 31 km/h 0.0 mm Low 9
    16 Nov -2.6 °C 30 % 28 km/h 0.0 mm Low 8
    17 Nov -2.7 °C 27 % 13 km/h 0.0 mm Low 6

    Before and after, from space

    Drag the line to compare the same ground before the fire and after it.

    Before · 8 Nov 2026
    After · 17 Nov 2026

    If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

    The smoke

    CAMS · Copernicus

    On 13 November 2026 the air beside the fire reached 86 µg/m³ of PM2.5. That day averaged 61: 4.1 times the WHO daily guideline (15).

    PM2.5 peak86 µg/m³
    Days over the guideline3 days
    PM10104 µg/m³
    Optical depth0.40
    13141516
    Good Fair Moderate Poor Very poor Extremely poor

    Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

    Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

    Detections table · 52Every satellite heat detection, one by one, with time, satellite, power and coordinates.
    ⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
    Date and timeSatelliteFRP (MW)LatLon

    Other fires nearby

    All fires in China

    Frequently asked questions

    How long did the Lanxi County fire last?
    According to the heat detections seen by satellite inside the perimeter, it burned from 15 November 2026 to 17 November 2026 (3 days). The perimeter dates it from 15 November 2026 to 16 November 2026.
    How much area did it burn?
    The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,564 hectares (15.6 km²). It is an estimate: official national figures may differ.
    Which municipalities burned?
    The fire entered 3 municipalities: Qinggang County (1,378 ha, 0.5 %); Lanxi County (173 ha, 0.1 %); Anda City (10 ha, 0.0 %).
    Is the Lanxi County fire still active?
    No fire detections since 17 Nov 2026, 04:14 UTC. A lack of detections is not an official extinction.
    What was the weather like?
    During the fire the temperature reached 2.4 °C, humidity dropped to 27 % and gusts hit 31 km/h. The fire danger index (FWI) reached 9, class Low.
    What weather is expected at the fire over the next 72 hours?
    The wind is blowing from the south-west and pushing to the north-east; no sharp shifts are expected until Sat 21, 06:00. No strong wind shifts, dry nights or useful rain are expected. Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 17 Nov 2026, 23:22 UTC; this is not an official warning.
    Where does this data come from?
    From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of China (geoBoundaries). It is not an official report.

    Where to verify it

    A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

    Emergency number: 119 · Emergency number and official warnings

    Satellite cross-check

    History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 17 November 2026.
    1. Page published (1,564 ha).

    RSS Changes to this page With cross-checks and a citable version

    Does something look wrong on this page?

    This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

    Report an error
    What do you think is wrong?

    We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 119.

    How we know this
    • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
    • Dates adjusted with the VIIRS detections inside the perimeter, which said 15 November 2026 to 16 November 2026. 52 Suomi-NPP VIIRS detections on those dates.
    • We have not matched this page with any official record.
    • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

    How we build fire pages: methodology

    Where this data comes from

    The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.