Skip to content
worldfires
US · United States · →

Kyle Fire, March 2017 Jackson, Oglala Lakota

Out · last detection 4 Mar 2017, 20:02 UTC

The fire started on 4 March 2017 in Oglala Lakota, United States, and satellites saw it burning for 1 day. United States agencies (MTBS / NIFC) mapped an official burnt perimeter of 516 hectares, spread across 2 counties.

It is the 41th largest in South Dakota since 2016 (of 48 with a page). Number 560 in United States in 2017, of 619.

The power measured by the satellite is low (10.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
516ha
official perimeter (MTBS / NIFC)
Duration
≈ 1day
4 Mar 2017 – 4 Mar 2017
Counties hit
2
counties
Started on
4 Mar
2017
Heat detections
19
in a single hotspot: 11 MW
Danger at start
12
Moderate · FWI index
Average daily power
148MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 4 Mar4 Mar

How it evolved, day by day

4 Mar 2017 · 148 MW · 19

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

18°high
52km/h · peak gust
21%lowest humidity

It had gone 7 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

How big is it?

10 km
It burned the equivalent of 0.3% of the area of London (5.2 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each county

  1. 271 ha reached on 4 Mar
    0.1 %
  2. Oglala Lakota where it started
    241 ha reached on 4 Mar
    0.0 %

Burnt area inside each county, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
4 Mar 18.4 °C 21 % 52 km/h 0.0 mm Moderate 12
5 Mar after 20.7 °C 22 % 41 km/h 0.0 mm Moderate 12
6 Mar after 9.2 °C 33 % 70 km/h 0.0 mm Moderate 17
7 Mar after 6.1 °C 18 % 78 km/h 0.0 mm Moderate 20
8 Mar after 10.2 °C 29 % 30 km/h 0.0 mm Low 10
9 Mar after 0.1 °C 55 % 42 km/h 0.1 mm Low 7
10 Mar after 1.3 °C 51 % 52 km/h 0.4 mm Low 7
11 Mar after -2.6 °C 59 % 31 km/h 0.0 mm Very low 4
12 Mar after 4.1 °C 53 % 43 km/h 0.0 mm Low 5
13 Mar after -2.3 °C 50 % 32 km/h 0.0 mm Very low 4
14 Mar after 7.6 °C 45 % 30 km/h 0.2 mm Very low 5

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 25 Feb 2017
After · 11 Mar 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 19Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in United States ›

Frequently asked questions

How long did the Kyle Fire last?
The official perimeter only gives the start date (4 March 2017). The end comes from the heat detections inside the perimeter: it burned until 4 March 2017 (1 day from 4 March 2017), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The official perimeter published by United States agencies (MTBS / NIFC) is 516 hectares (5.2 km²). Other tallies, such as daily incident reports, may give slightly different figures.
Which counties burned?
The fire entered 2 counties: Jackson (271 ha, 0.1 %); Oglala Lakota (241 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 18.4 °C, humidity dropped to 21 % and gusts hit 52 km/h. The fire danger index (FWI) reached 12, class Moderate.
Where does this data come from?
From the official burnt perimeter of United States agencies (MTBS / NIFC, public domain), NASA FIRMS VIIRS hotspots and the administrative boundaries of United States. It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: MTBS (US Geological Survey and US Forest Service), official.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 19 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter is official and in the public domain. For past years it comes from MTBS (Monitoring Trends in Burn Severity), run by the U.S. Geological Survey and the USDA Forest Service, which map it on Landsat and Sentinel-2 imagery. For the current and last year it comes from WFIGS at the National Interagency Fire Center (NIFC): incident perimeters mapped by fire crews, aircraft and imagery. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. County boundaries come from geoBoundaries ADM2 (Public Domain). The area per county is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from official figures.