Skip to content
worldfires
PT · Portugal · –

Jardim da Serra fire, December 2019 Jardim da Serra, Campanário

Out · last detection 31 Dec 2019, 02:45 UTC

The fire started on 29 December 2019 in Jardim da Serra, Portugal, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 172 hectares from satellite imagery, spread across 2 freguesias.

We are reviewing this page: some of its data look inconsistent (the place, the dates or the area), so treat them with caution.

The power measured by the satellite is low (6.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
172ha
Copernicus perimeter
Duration
4days
29 Dec 2019 – 1 Jan 2020
Freguesias hit
2
freguesias
Started on
29 Dec
2019
Heat detections
9
in a single hotspot: 6 MW
Danger at start
5
Very low · FWI index
Average daily power
6MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 29 Dec1 Jan
31 Dec 2019

How it evolved, day by day

29 Dec 2019 · 6 MW · 1 31 Dec 2019 · 7 MW · 8
29 Dec 31 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

16°high
44km/h · peak gust
37%lowest humidity

It had gone 10 days without rain (1 mm or more) when it started.

This area had burned before

100% of the perimeter overlaps earlier fires recorded since 2016: 151 ha in 2017, 139 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 218 ha that had burned before.

What happened to each freguesia

  1. Jardim da Serra 2,739 inhabitants · 1.4 km from the centre where it started
    165 ha reached on 29 Dec
    22 %
  2. Campanário 4,317 inhabitants · 3.5 km from the centre
    146 ha reached on 31 Dec
    12 %

Burnt area inside each freguesia, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland83 %
  • Mixed forest5.5 %
  • Other natural land4.2 %
  • Coniferous forest3.5 %
  • Agricultural areas3.2 %

Natura 2000 protected area affected: 4 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.27 ha
Residents≈ 40

Inside the perimeter there were about 0.27 hectares of built-up land and about 40 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
29 Dec 15.7 °C 41 % 44 km/h 0.0 mm Very low 5
30 Dec 15.5 °C 37 % 36 km/h 0.0 mm Very low 5
31 Dec 12.6 °C 64 % 43 km/h 0.0 mm Very low 4
1 Jan 12.7 °C 57 % 43 km/h 0.0 mm Very low 4
2 Jan after 12.4 °C 52 % 32 km/h 0.0 mm Very low 4
3 Jan after 12.1 °C 62 % 48 km/h 0.0 mm Low 5
4 Jan after 11.7 °C 58 % 40 km/h 0.0 mm Low 6
5 Jan after 11.5 °C 66 % 26 km/h 0.4 mm Very low 3
6 Jan after 11.4 °C 57 % 38 km/h 0.0 mm Very low 4
7 Jan after 11.2 °C 59 % 41 km/h 0.0 mm Low 6
8 Jan after 10.9 °C 62 % 33 km/h 0.0 mm Very low 4
9 Jan after 12.0 °C 74 % 35 km/h 0.7 mm Very low 4
10 Jan after 10.4 °C 71 % 35 km/h 0.0 mm Very low 4
11 Jan after 10.2 °C 66 % 36 km/h 0.0 mm Very low 4

Its twins: fires that started in the same weather

It started with an FWI of 4.9, a minimum humidity of 41% and 10 days without rain. Fires in the area that started in weather like this since 2016: 1.

FWI at the start 4.9
Minimum humidity 41 %
Days without rain 10
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Ponta do Pargo fire, February 2020
1,086 ha 6 days FWI 9.2 Min. humidity 42 % 24 km away, in 2020

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

Fires in the area that started in similar weather: 1. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
44km/h · max. gust

It was considered over on 1 Jan, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 22 Dec 2019
After · 8 Jan 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Portugal

Frequently asked questions

How long did the Jardim da Serra fire last?
Copernicus dates it between 29 December 2019 and 1 January 2020: 4 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 172 hectares (1.7 km²). Official national figures may differ.
Which freguesias burned?
The fire entered 2 freguesias: Jardim da Serra (165 ha, 22 %); Campanário (146 ha, 12 %).
Did the fire reach a town?
The fire started in Jardim da Serra and came within 1.4 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 15.7 °C, humidity dropped to 37 % and gusts hit 44 km/h. The fire danger index (FWI) reached 5, class Very low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Portugal (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery; 2 polygons grouped in this page.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Freguesia boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per freguesia is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.