Skip to content
worldfires
BR · Brazil · –

Itaipava do Grajaú fire, September 2017 Itaipava do Grajaú, Grajaú

Out · last detection 19 Sept 2017, 15:55 UTC

The fire started on 5 September 2017 in Itaipava do Grajaú, Brazil, and satellites saw it burning for 15 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 10,290 hectares from heat detections, spread across 2 municipalities.

It is the 48th largest in Maranhão since 2016 (of 531 with a page). Number 171 in Brazil in 2017, of 994.

Burnt area
10,290ha
GWIS perimeter (Copernicus)
Duration
15days
5 Sept 2017 – 19 Sept 2017
Municipalities hit
2
municipalities
Started on
5 Sept
2017
Heat detections
530
in a single hotspot: 0 MW
Danger at start
55
Extreme · FWI index
Average daily power
456MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 5 Sept19 Sept
19 Sept 2017

How it evolved, day by day

5 Sept 2017 · 109 MW · 16 6 Sept 2017 · 138 MW · 18 8 Sept 2017 · 12 MW · 2 9 Sept 2017 · 309 MW · 37 10 Sept 2017 · 705 MW · 67 11 Sept 2017 · 556 MW · 79 12 Sept 2017 · 1,256 MW · 86 13 Sept 2017 · 27 MW · 15 14 Sept 2017 · 841 MW · 25 15 Sept 2017 · 877 MW · 87 16 Sept 2017 · 955 MW · 54 17 Sept 2017 · 527 MW · 35 18 Sept 2017 · 46 MW · 4 19 Sept 2017 · 24 MW · 5
5 Sept 9 Sept 12 Sept 15 Sept 18 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
46km/h · peak gust
30%lowest humidity

It had gone 15 days without rain (1 mm or more) when it started.

This area had burned before

4% of the perimeter overlaps earlier fires recorded since 2016: 386 ha in 2016.

How big is it?

10 km
It burned the equivalent of 6.5% of the area of London (103 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Itaipava do Grajaú where it started
    7,227 ha
    5.8 %
  2. Grajaú 73,872 inhabitants
    3,146 ha
    0.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2015
Built-up area2.4 ha
Residents≈ 700

Inside the perimeter there were about 2.4 hectares of built-up land and about 700 residents (GHSL 2015, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 46 % of the area in Brazil

Day High Min. humidity Peak gust Rain Danger (FWI)
5 Sept 35.0 °C 36 % 45 km/h 0.0 mm Extreme 55
6 Sept 35.6 °C 40 % 43 km/h 0.0 mm Extreme 56
7 Sept 35.3 °C 42 % 40 km/h 0.0 mm Very high 50
8 Sept 36.5 °C 38 % 40 km/h 0.0 mm Extreme 53
9 Sept 36.0 °C 32 % 44 km/h 0.0 mm Extreme 55
10 Sept 36.6 °C 33 % 41 km/h 0.0 mm Extreme 55
11 Sept 36.3 °C 36 % 40 km/h 0.0 mm Extreme 54
12 Sept 36.7 °C 34 % 44 km/h 0.0 mm Extreme 56
13 Sept 35.4 °C 40 % 40 km/h 0.0 mm Extreme 54
14 Sept 36.5 °C 36 % 38 km/h 0.0 mm Very high 50
15 Sept 36.5 °C 36 % 37 km/h 0.0 mm Extreme 52
16 Sept 36.0 °C 30 % 42 km/h 0.0 mm Extreme 52
17 Sept 36.1 °C 32 % 45 km/h 0.0 mm Extreme 58
18 Sept 36.4 °C 37 % 46 km/h 0.0 mm Extreme 56
19 Sept 37.4 °C 33 % 35 km/h 0.0 mm Very high 44
20 Sept after 36.7 °C 38 % 40 km/h 0.0 mm Extreme 50
21 Sept after 37.0 °C 35 % 38 km/h 0.0 mm Extreme 52
22 Sept after 36.3 °C 35 % 46 km/h 0.0 mm Extreme 58
23 Sept after 36.7 °C 34 % 38 km/h 0.0 mm Extreme 53
24 Sept after 36.5 °C 34 % 40 km/h 0.0 mm Extreme 51
25 Sept after 35.2 °C 39 % 40 km/h 0.0 mm Very high 49
26 Sept after 37.6 °C 36 % 38 km/h 0.0 mm Extreme 53
27 Sept after 37.2 °C 36 % 41 km/h 0.0 mm Extreme 54
28 Sept after 37.8 °C 34 % 39 km/h 0.0 mm Very high 48
29 Sept after 38.0 °C 35 % 46 km/h 0.0 mm Extreme 54

Its twins: fires that started in the same weather

It started with an FWI of 55.2, a minimum humidity of 36% and 15 days without rain. Fires in the area that started in weather like this since 2016: 32.

FWI at the start 55.2
Minimum humidity 36 %
Days without rain 15
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Amarante do Maranhão fire, August 2016
4,247 ha 14 days FWI 55.2 Min. humidity 33 % 74 km away, in 2016

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

14 days
median duration
5,034 ha
median area
12 %
went past 10,000 ha
2.2 mm
rain at the end (median; 8 of 32 had it)

It was 2.0 times larger than the median of its twins and lasted 15 days, against 14 days.

Only 4 of its 32 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 24 of 32, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.2 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
46km/h · max. gust

It was considered over on 19 Sept, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 8 of 32, with a median of 2.2 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 29 Aug 2017
After · 26 Sept 2017

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 0Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Brazil

Frequently asked questions

How long did the Itaipava do Grajaú fire last?
GWIS (Copernicus) dates it between 5 September 2017 and 19 September 2017: 15 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 10,290 hectares (102.9 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Itaipava do Grajaú (7,227 ha, 5.8 %); Grajaú (3,146 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 37.4 °C, humidity dropped to 30 % and gusts hit 46 km/h. The fire danger index (FWI) reached 58, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Brazil (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 32. Their median duration was 14 days and their median area 5,034 ha; 12 % went past 10,000 ha. Only 4 of its 32 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 24 of 32, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.2 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · Emergency number and official warnings

Satellite cross-check

History of this page · 4 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 26 September 2017 → 19 September 2017.
  2. Start date: 29 August 2017 → 5 September 2017.
  3. Last day with fire: 19 September 2017 → 26 September 2017.
  4. Start date: 5 September 2017 → 29 August 2017.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery; 2 polygons grouped in this page.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. No Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.