Skip to content
worldfires
ZW · Zimbabwe · –

Hurungwe fire, 27 August 2021 Hurungwe

Out · last detection 10 Sept 2021, 12:03 UTC

The fire started on 27 August 2021 in Hurungwe, Zimbabwe, and satellites saw it burning for 15 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,299 hectares from heat detections, spread across a single municipality.

It is the 86th largest in Mashonaland West since 2016 (of 644 with a page). Number 23 in Zimbabwe in 2021, of 176.

The power measured by the satellite is low (28.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
3,299ha
GWIS perimeter (Copernicus)
Duration
15days
27 Aug 2021 – 10 Sept 2021
Municipalities hit
1
districts
Started on
27 Aug
2021
Heat detections
85
in a single hotspot: 28 MW
Danger at start
44
Very high · FWI index
Average daily power
32MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 27 Aug10 Sept
10 Sept 2021

How it evolved, day by day

28 Aug 2021 · 2 MW · 3 29 Aug 2021 · 168 MW · 18 30 Aug 2021 · 7 MW · 7 31 Aug 2021 · 17 MW · 3 1 Sept 2021 · 18 MW · 3 3 Sept 2021 · 68 MW · 6 4 Sept 2021 · 2 MW · 3 5 Sept 2021 · 28 MW · 9 6 Sept 2021 · 27 MW · 9 7 Sept 2021 · 32 MW · 7 8 Sept 2021 · 2 MW · 1 9 Sept 2021 · 28 MW · 13 10 Sept 2021 · 20 MW · 3
29 Aug 4 Sept 7 Sept 10 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

32°high
57km/h · peak gust
21%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

3% of the perimeter overlaps earlier fires recorded since 2016: 19 ha in 2016, 81 ha in 2018.

How big is it?

10 km
It burned the equivalent of 2.1% of the area of London (33 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Hurungwe where it started
    3,315 ha reached on 28 Aug
    0.2 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Strong wind: 11 % of the area in Zimbabwe 60 days without rain: 63 % of the area in Zimbabwe

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Aug 29.4 °C 27 % 53 km/h 0.0 mm Very high 44
28 Aug 32.0 °C 21 % 45 km/h 0.0 mm Very high 43
29 Aug 30.7 °C 24 % 37 km/h 0.0 mm Very high 38
30 Aug 25.3 °C 40 % 53 km/h 0.0 mm Very high 39
31 Aug 28.5 °C 32 % 35 km/h 0.0 mm High 31
1 Sept 30.5 °C 22 % 41 km/h 0.0 mm Very high 40
2 Sept 28.2 °C 39 % 52 km/h 0.0 mm Very high 39
3 Sept 27.9 °C 36 % 52 km/h 0.0 mm Very high 39
4 Sept 29.0 °C 33 % 50 km/h 0.0 mm Very high 39
5 Sept 29.7 °C 24 % 50 km/h 0.0 mm Very high 44
6 Sept 30.5 °C 25 % 53 km/h 0.0 mm Very high 46
7 Sept 30.7 °C 22 % 52 km/h 0.0 mm Very high 47
8 Sept 30.7 °C 22 % 57 km/h 0.0 mm Extreme 51
9 Sept 28.8 °C 27 % 50 km/h 0.0 mm Very high 47
10 Sept 27.4 °C 32 % 49 km/h 0.0 mm Very high 43
11 Sept after 24.8 °C 26 % 45 km/h 0.0 mm Very high 41
12 Sept after 25.5 °C 31 % 39 km/h 0.0 mm High 38
13 Sept after 28.7 °C 30 % 49 km/h 0.0 mm Very high 43
14 Sept after 31.1 °C 26 % 52 km/h 0.0 mm Very high 45
15 Sept after 32.5 °C 22 % 55 km/h 0.0 mm Extreme 52
16 Sept after 34.2 °C 18 % 45 km/h 0.0 mm Extreme 50
17 Sept after 34.8 °C 18 % 46 km/h 0.0 mm Extreme 53
18 Sept after 27.6 °C 32 % 53 km/h 0.0 mm Very high 49
19 Sept after 27.5 °C 33 % 52 km/h 0.0 mm Very high 45
20 Sept after 30.8 °C 24 % 38 km/h 0.0 mm Very high 43

Its twins: fires that started in the same weather

It started with an FWI of 44.3, a minimum humidity of 27% and more than two months without rain. Fires in the area that started in weather like this since 2016: 24.

FWI at the start 44.3
Minimum humidity 27 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Hurungwe fire, October 2018
3,993 ha 11 days FWI 44.9 Min. humidity 27 % 73 km away, in 2018

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

6 days
median duration
1,548 ha
median area
100 %
went past 1,000 ha
3.4 mm
rain at the end (median; 4 of 24 had it)

It was 2.1 times larger than the median of its twins and lasted 15 days, against 6 days.

Only 3 of its 24 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 20 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.4 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
57km/h · max. gust

It was considered over on 10 Sept, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 4 of 24, with a median of 3.4 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 20 Aug 2021
After · 17 Sept 2021

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 85Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Zimbabwe

Frequently asked questions

How long did the Hurungwe fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 27 August 2021 to 10 September 2021 (15 days). The perimeter dates it from 29 August 2021 to 10 September 2021.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,299 hectares (33.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Hurungwe (3,315 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 32.0 °C, humidity dropped to 21 % and gusts hit 57 km/h. The fire danger index (FWI) reached 51, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Zimbabwe (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 24. Their median duration was 6 days and their median area 1,548 ha; 100 % went past 1,000 ha. Only 3 of its 24 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 20 of 24, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.4 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Start date: 29 August 2021 → 27 August 2021.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 29 August 2021 to 10 September 2021. 85 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.