Skip to content
worldfires
HR · Croatia ·

Grad Dubrovnik fire, October 2026 Grad Dubrovnik

Out · last detection 15 Oct 2026, 01:34 UTC

Satellites first detected fire on 15 October 2026 in Grad Dubrovnik, Croatia. It was active for 1 day, with 14 heat detections and an area with fire of about 196 hectares rebuilt from them, spread across a single municipality.

The power measured by the satellite is low (8.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Copernicus has not yet published the burnt perimeter, which takes a few days to measure on satellite imagery. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). When the perimeter arrives, this page picks it up on its own and keeps the same address.

Area with fire
≈ 196ha
rebuilt from hotspots, no official perimeter yet
Duration
1day
15 Oct 2026 – 15 Oct 2026
Municipalities hit
1
municipalities
Started on
15 Oct
2026
Heat detections
14
in a single hotspot: 9 MW
Danger at start
10
Low · FWI index
Average daily power
47MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 15 Oct15 Oct

How it evolved, day by day

15 Oct 2026 · 47 MW · 14

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

23°high
30km/h · peak gust
35%lowest humidity

It had gone 3 days without rain (1 mm or more) when it started. Rain came after the fire: 61.6 mm on 21 Oct.

What happened to each town

  1. Grad Dubrovnik where it started
    126 ha reached on 15 Oct
    0.9 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
15 Oct 22.6 °C 35 % 30 km/h 0.0 mm Low 10
16 Oct after 21.0 °C 31 % 40 km/h 0.0 mm Moderate 14
17 Oct after 19.1 °C 41 % 26 km/h 0.0 mm Low 11
18 Oct after 20.7 °C 58 % 18 km/h 0.0 mm Low 9
19 Oct after 22.2 °C 55 % 22 km/h 0.0 mm Low 9
20 Oct after 22.3 °C 65 % 33 km/h 0.0 mm Low 10
21 Oct after 19.7 °C 72 % 75 km/h 61.6 mm Very low 0

Its twins: fires that started in the same weather

It started with an FWI of 10.4, a minimum humidity of 35% and 3 days without rain. Fires in the area that started in weather like this since 2016: 20.

FWI at the start 10.4
Minimum humidity 35 %
Days without rain 3
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Berkovići fire, August 2019
199 ha 2 days FWI 9.3 Min. humidity 35 % 49 km away, in 2019

First rain (1 mm or more) after it ended: 1.5 mm on 31 Aug.

What happened to them

2 days
median duration
202 ha
median area
5 %
went past 1,000 ha
6.4 mm
rain at the end (median; 20 of 20 had it)

It burned an area similar to its twins (196 ha against a median of 202 ha) and lasted 1 day, against 2 days.

All of them had rain in the ten days after the end: the first rainy day brought a median of 6.4 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

61.6 mmfirst rain
21 Oct6 days after it ended
30km/h · max. gust

It was considered over on 15 Oct, and on 21 Oct 61.6 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 20 of 20, with a median of 6.4 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 8 Oct 2026
After · 22 Oct 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 15 October 2026 the air beside the fire reached 9 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak9 µg/m³
Days over the guideline0 days
PM1010 µg/m³
Optical depth0.18
12131415
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 14Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Croatia

Frequently asked questions

How long did the Grad Dubrovnik fire last?
According to the heat detections seen by satellite, it burned from 15 October 2026 to 15 October 2026 (1 day between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no official perimeter yet. Heat detections rebuild about 196 hectares with fire (2.0 km²); Copernicus will publish the measured figure within days.
Which municipalities burned?
The fire only entered Grad Dubrovnik (126 ha, 0.9 %).
What was the weather like?
During the fire the temperature reached 22.6 °C, humidity dropped to 35 % and gusts hit 30 km/h. The fire danger index (FWI) reached 10, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Croatia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 20. Their median duration was 2 days and their median area 202 ha; 5 % went past 1,000 ha. All of them had rain in the ten days after the end: the first rainy day brought a median of 6.4 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 193 · Emergency number and official warnings

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Area: ≈ 210 → ≈ 196 ha.
  2. Start date: 14 October 2026 → 15 October 2026.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 193.

How we know this
  • No perimeter yet: the area (≈ 196 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 14 Suomi-NPP VIIRS detections on those dates.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.