Skip to content
worldfires
EL · Greece · →

Filiates fire, September 2020 Φιλιάτες · Filiates

Out · last detection 10 Sept 2020, 23:40 UTC

The fire started on 8 September 2020 in Filiates, Greece, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 146 hectares from satellite imagery, spread across a single municipality.

It is the 13th largest in Epirus since 2016 (of 19 with a page). Number 15 in Greece in 2020, of 22.

The power measured by the satellite is low (15.3 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
146ha
Copernicus perimeter
Duration
4days
8 Sept 2020 – 11 Sept 2020
Municipalities hit
1
municipalities
Started on
8 Sept
2020
Heat detections
7
in a single hotspot: 15 MW
Danger at start
20
Moderate · FWI index
Average daily power
21MW
detected power per day, on average

Where it burned

10 Sept 2020
HOTSPOTS BY DAY 8 Sept11 Sept

How it evolved, day by day

9 Sept 2020 · 34 MW · 4 10 Sept 2020 · 8 MW · 3
9 Sept 10 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
29km/h · peak gust
36%lowest humidity

It had gone 27 days without rain (1 mm or more) when it started. Rain came after the fire: 4.3 mm on 17 Sept.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Filiates Φιλιάτες 8,270 inhabitants where it started
    146 ha reached on 9 Sept
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Scrub and transitional woodland79 %
  • Other natural land21 %

Natura 2000 protected area affected: 100 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Sept 29.0 °C 38 % 19 km/h 0.0 mm Moderate 20
9 Sept 29.4 °C 36 % 28 km/h 0.0 mm High 22
10 Sept 28.6 °C 38 % 26 km/h 0.0 mm High 22
11 Sept 27.8 °C 42 % 29 km/h 0.0 mm Moderate 21
12 Sept after 27.6 °C 38 % 28 km/h 0.0 mm High 22
13 Sept after 28.7 °C 30 % 23 km/h 0.0 mm High 23
14 Sept after 27.6 °C 34 % 29 km/h 0.0 mm High 22
15 Sept after 27.5 °C 24 % 34 km/h 0.0 mm High 27
16 Sept after 27.8 °C 35 % 31 km/h 0.3 mm High 26
17 Sept after 26.1 °C 48 % 28 km/h 4.3 mm Very low 4

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Sept 2020
After · 18 Sept 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 10 September 2020 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline3 days
PM1032 µg/m³
67891011121314
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Greece ›

Frequently asked questions

How long did the Filiates fire last?
Copernicus dates it between 8 September 2020 and 11 September 2020: 4 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 146 hectares (1.5 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Filiates (146 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 29.4 °C, humidity dropped to 36 % and gusts hit 29 km/h. The fire danger index (FWI) reached 22, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Greece (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 199

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 199.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (CC0 1.0 Universal (CC0 1.0) Public Domain Dedication). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.