Skip to content
worldfires
MX · Mexico · –

Del Nayar fire, 14 April 2023 Del Nayar

Out · last detection 20 Apr 2023, 20:36 UTC

The fire started on 14 April 2023 in Del Nayar, Mexico, and satellites saw it burning for 7 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,129 hectares from heat detections, spread across a single municipality.

It is the 99th largest in Nayarit since 2016 (of 171 with a page). Number 166 in Mexico in 2023, of 285.

The power measured by the satellite is low (21.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
2,129ha
GWIS perimeter (Copernicus)
Duration
7days
14 Apr 2023 – 20 Apr 2023
Municipalities hit
1
municipalities
Started on
14 Apr
2023
Heat detections
113
in a single hotspot: 21 MW
Danger at start
45
Very high · FWI index
Average daily power
64MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Apr20 Apr
20 Apr 2023

How it evolved, day by day

14 Apr 2023 · 7 MW · 3 15 Apr 2023 · 35 MW · 6 16 Apr 2023 · 152 MW · 28 17 Apr 2023 · 150 MW · 41 18 Apr 2023 · 44 MW · 17 19 Apr 2023 · 29 MW · 10 20 Apr 2023 · 34 MW · 8
14 Apr 16 Apr 18 Apr 20 Apr

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

29°high
51km/h · peak gust
16%lowest humidity

It had gone one day without rain (1 mm or more) when it started.

This area had burned before

68% of the perimeter overlaps earlier fires recorded since 2016: 1,228 ha in 2016, 1 ha in 2017, 1,095 ha in 2019, 2 ha in 2022. Part of it burned more than once, so the yearly figures add up to more than the 1,449 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 1.3% of the area of London (21 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Del Nayar where it started
    2,143 ha reached on 14 Apr
    0.4 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

Official record

According to CONAFOR, this fire started on 15 April 2023 and burned 1,448 ha (the satellite measured 2,129 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.

CONAFOR (Comisión Nacional Forestal), estadística de incendios forestales en datos.gob.mx (CC BY 4.0). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Apr 26.3 °C 16 % 45 km/h 0.0 mm Very high 45
15 Apr 26.3 °C 26 % 51 km/h 0.5 mm Very high 49
16 Apr 29.0 °C 17 % 45 km/h 0.0 mm Very high 49
17 Apr 27.8 °C 19 % 44 km/h 0.0 mm Very high 48
18 Apr 26.6 °C 26 % 42 km/h 0.0 mm Very high 45
19 Apr 27.2 °C 26 % 40 km/h 0.0 mm Very high 44
20 Apr 27.5 °C 29 % 41 km/h 0.0 mm Very high 45
21 Apr after 29.2 °C 27 % 40 km/h 0.0 mm Very high 44
22 Apr after 29.5 °C 24 % 43 km/h 0.0 mm Very high 45
23 Apr after 28.1 °C 18 % 43 km/h 0.0 mm Very high 49
24 Apr after 27.9 °C 16 % 45 km/h 0.0 mm Extreme 51
25 Apr after 27.2 °C 16 % 48 km/h 0.0 mm Extreme 50
26 Apr after 26.0 °C 23 % 35 km/h 0.0 mm Very high 46
27 Apr after 28.2 °C 22 % 42 km/h 0.0 mm Very high 48
28 Apr after 26.6 °C 22 % 43 km/h 0.0 mm Very high 49
29 Apr after 28.7 °C 28 % 42 km/h 0.2 mm Very high 43
30 Apr after 27.8 °C 29 % 45 km/h 0.0 mm Very high 44

Its twins: fires that started in the same weather

It started with an FWI of 45.2, a minimum humidity of 16% and 1 day without rain. Fires in the area that started in weather like this since 2016: 19.

FWI at the start 45.2
Minimum humidity 16 %
Days without rain 1
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Mezquital fire, May 2021
1,740 ha 13 days FWI 45.0 Min. humidity 17 % 48 km away, in 2021

First rain (1 mm or more) after it ended: 9.9 mm on 2 Jun.

What happened to them

11 days
median duration
2,996 ha
median area
100 %
went past 1,000 ha
2.1 mm
rain at the end (median; 14 of 19 had it)

It burned an area similar to its twins (2,129 ha against a median of 2,996 ha) and lasted 7 days, against 11 days.

In 5 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.1 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
51km/h · max. gust

It was considered over on 20 Apr, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 14 of 19, with a median of 2.1 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Apr 2023
After · 27 Apr 2023

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 17 April 2023 the air beside the fire reached 14 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak14 µg/m³
Days over the guideline0 days
PM1020 µg/m³
Optical depth0.17
12 Apr15 Apr18 Apr21 Apr
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 113Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mexico

Frequently asked questions

How long did the Del Nayar fire last?
GWIS (Copernicus) dates it between 14 April 2023 and 20 April 2023: 7 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,129 hectares (21.3 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Del Nayar (2,143 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 29.0 °C, humidity dropped to 16 % and gusts hit 51 km/h. The fire danger index (FWI) reached 49, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 19. Their median duration was 11 days and their median area 2,996 ha; 100 % went past 1,000 ha. In 5 of 19, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.1 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 113 Suomi-NPP VIIRS detections on those dates.
  • Compared with CONAFOR: 1,448 official ha against 2,129 ha of perimeter; similar, but with reservations.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.