The fire started on 16 May 2019 in Del Nayar, Mexico, and satellites saw it burning for 24 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 14,907 hectares from heat detections, spread across 2 municipalities. According to CONAFOR, the largest of the 2 recorded fires was detected on 18 May 2019 and declared extinguished on 2 June 2019.
It is the largest fire in Nayarit since 2016 (of 171 with a page). Number 12 in Mexico in 2019, of 363.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
30.8°C · 30% RH
High of 30.8 °C and minimum humidity of 30% on 7 June 2019; gusts of 52 km/h on 18 May 2019.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
Living inside
model
≈ 30people
Estimated residents inside the perimeter and 0.15 ha of built-up area (100 m grid, epoch 2020).
Source
GHSL R2023A · JRC
Date
calculated on 24 October 2026
+− cross-check
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official CONAFOR record
Matches: 13,103 ha in the official record (records: 2).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
31°high
52km/h · peak gust
12%lowest humidity
It had gone more than two months without rain (1 mm or more) when it started. Rain came after the fire: 1.8 mm on 9 Jun.
This area had burned before
69% of the perimeter overlaps earlier fires recorded since 2016: 1,339 ha in 2016, 9,227 ha in 2017, 878 ha in 2018. Part of it burned more than once, so the yearly figures add up to more than the 10,349 ha that had burned before.
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
People and buildings inside the perimeter
GHSL 2020
Built-up area0.15ha
Residents≈ 30
Inside the perimeter there were about 0.15 hectares of built-up land and about 30 residents (GHSL 2020, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
According to CONAFOR, 2 fires started inside this perimeter on these dates, totalling 13,103 ha (the satellite measured 14,907 ha).
CONAFOR records each fire that started at a different time or place separately; the satellite sees a single burned area, so this page groups them together. The numbers on the map show where each one started.
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
It started with an FWI of 55.8, a minimum humidity of 15% and more than two months without rain. Fires in the area that started in weather like this since 2016: 15.
FWI at the start55.8
Minimum humidity15 %
Days without rain60+
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Del Nayar fire, 16 May 2019
14,907 ha24 daysFWI 55.8Min. humidity 15 %
Del Nayar fire, April 2021
1,745 ha12 daysFWI 53.8Min. humidity 16 %31 km away, in 2021
First rain (1 mm or more) after it ended: none in the following ten days.
It was 6.3 times larger than the median of its twins and lasted 24 days, against 12 days.
Only 1 of its 15 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 7 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.2 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
1.8 mmfirst rain
9 Junthe day after it ended
52km/h · max. gust
It was considered over on 8 Jun, and on 9 Jun 1.8 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 8 of 15, with a median of 1.2 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
According to the heat detections seen by satellite inside the perimeter, it burned from 16 May 2019 to 8 June 2019 (24 days). The perimeter dates it from 16 May 2019 to 1 June 2019. According to CONAFOR, the largest of the 2 recorded fires was detected on 18 May 2019 and declared extinguished on 2 June 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 14,907 hectares (149.1 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Del Nayar (13,097 ha, 2.5 %); Mezquital (1,905 ha, 0.2 %).
What was the weather like?
During the fire the temperature reached 30.8 °C, humidity dropped to 12 % and gusts hit 52 km/h. The fire danger index (FWI) reached 58, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 15. Their median duration was 12 days and their median area 2,357 ha; 100 % went past 1,000 ha. Only 1 of its 15 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 7 of 15, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.2 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
Dates adjusted with the VIIRS detections inside the perimeter, which said 16 May 2019 to 1 June 2019. 725 Suomi-NPP VIIRS detections on those dates.
Compared with CONAFOR: 13,103 official ha against 14,907 ha of perimeter; they agree within 25%.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.