Skip to content
worldfires
DZ · Algeria · →

Darguina fire, 18 July 2026 درقينة · Darguina

Out · last detection 22 Jul 2026, 12:29 UTC

The fire started on 18 July 2026 in Darguina, Algeria, and satellites saw it burning for 6 days. Copernicus mapped a burnt perimeter of 106 hectares from satellite imagery, spread across a single municipality.

It is the 100th largest in Jijel since 2016 (of 110 with a page). Number 193 in Algeria in 2026, of 197.

The power measured by the satellite is low (10.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
106ha
Copernicus perimeter
Duration
≈ 6days
18 Jul 2026 – 23 Jul 2026
Municipalities hit
1
communes
Started on
18 Jul
2026
Heat detections
1
in a single hotspot: 10 MW
Danger at start
50
Very high · FWI index
Average daily power
10MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 18 Jul23 Jul

How it evolved, day by day

22 Jul 2026 · 10 MW · 1

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
26km/h · peak gust
15%lowest humidity

It had gone 13 days without rain (1 mm or more) when it started. Rain came after the fire: 1.0 mm on 25 Jul.

This area had burned before

27% of the perimeter overlaps earlier fires recorded since 2016: 4 ha in 2021, 25 ha in 2023.

What happened to each town

  1. Darguina درقينة 14,146 inhabitants · 10.4 km from the centre where it started
    106 ha reached on 22 Jul
    1.3 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land67 %
  • Mixed forest33 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

People and buildings inside the perimeter

GHSL 2025
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
21 Jul 38.5 °C 15 % 26 km/h 0.0 mm Very high 50
22 Jul 37.8 °C 18 % 26 km/h 0.0 mm Extreme 52
23 Jul 36.0 °C 24 % 16 km/h 0.0 mm Very high 38
24 Jul after 32.0 °C 32 % 10 km/h 0.0 mm High 29
25 Jul after 31.4 °C 28 % 27 km/h 1.0 mm High 35

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 11 Jul 2026
After · 30 Jul 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 25 July 2026 the air beside the fire reached 155 µg/m³ of PM2.5. That day averaged 69: 4.6 times the WHO daily guideline (15).

PM2.5 peak155 µg/m³
Days over the guideline5 days
PM10238 µg/m³
Optical depth0.83
19202122232425
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Darguina fire last?
The official perimeter only gives the start date (21 July 2026). The end comes from the heat detections inside the perimeter: it burned until 23 July 2026 (6 days from 18 July 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 106 hectares (1.1 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Darguina (106 ha, 1.3 %).
Did the fire reach a town?
The fire started in Darguina and came within 10.4 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 38.5 °C, humidity dropped to 15 % and gusts hit 26 km/h. The fire danger index (FWI) reached 52, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. One Suomi-NPP VIIRS detection on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.