Skip to content
worldfires
DZ · Algeria · →

Damous fire, July 2019 الداموس · Damous

Out · last detection 24 Jul 2019, 02:44 UTC

The fire started on 23 July 2019 in Damous, Algeria, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 136 hectares from satellite imagery, spread across a single municipality.

It is the 49th largest in Tipaza since 2016 (of 59 with a page). Number 63 in Algeria in 2019, of 78.

The power measured by the satellite is low (27.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
136ha
Copernicus perimeter
Duration
2days
23 Jul 2019 – 24 Jul 2019
Municipalities hit
1
communes
Started on
23 Jul
2019
Heat detections
20
in a single hotspot: 27 MW
Danger at start
33
High · FWI index
Energy released
46MW
sum of detected power

Where it burned

24 Jul 2019
HOTSPOTS BY DAY 23 Jul24 Jul

How it evolved, day by day

2324

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
39km/h · peak gust
32%lowest humidity

It had gone 57 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Damous الداموس 17,111 inhabitants · 5.6 km from the town where it started
    136 ha reached on 23 Jul
    1.8 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Mixed forest65 %
  • Other natural land35 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
23 Jul 30.7 °C 32 % 39 km/h 0.0 mm High 33
24 Jul 29.6 °C 38 % 32 km/h 0.0 mm High 32
25 Jul after 30.0 °C 38 % 27 km/h 0.0 mm High 28
26 Jul after 29.8 °C 40 % 40 km/h 0.0 mm High 30
27 Jul after 27.1 °C 24 % 60 km/h 0.0 mm Very high 49
28 Jul after 25.9 °C 48 % 47 km/h 0.0 mm High 35
29 Jul after 26.2 °C 56 % 29 km/h 0.0 mm High 22
30 Jul after 26.2 °C 54 % 32 km/h 0.0 mm High 24
31 Jul after 26.9 °C 63 % 52 km/h 0.0 mm High 27
1 Aug after 28.9 °C 60 % 27 km/h 0.0 mm Moderate 21
2 Aug after 26.9 °C 65 % 30 km/h 0.0 mm Moderate 18
3 Aug after 26.9 °C 65 % 31 km/h 0.0 mm Moderate 19

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 16 Jul 2019
After · 31 Jul 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 21 July 2019 the air beside the fire reached 30 µg/m³ of PM2.5. That day averaged 23: 1.5 times the WHO daily guideline (15).

PM2.5 peak30 µg/m³
Days over the guideline3 days
PM1056 µg/m³
2122232425262728293031
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 20Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Damous fire last?
Copernicus dates it between 23 July 2019 and 24 July 2019: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 136 hectares (1.4 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Damous (136 ha, 1.8 %).
Did the fire reach a town?
The closest fire to a town centre came within 5.6 km of Damous. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 30.7 °C, humidity dropped to 32 % and gusts hit 39 km/h. The fire danger index (FWI) reached 33, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.