Skip to content
worldfires
IT · Italy · →

Cutro fire, 8 October 2025 Cutro, Crotone

Out · last detection 11 Oct 2025, 12:47 UTC

The fire started on 8 October 2025 in Cutro, Italy, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 235 hectares from satellite imagery, spread across 2 municipalities.

It is the 16th largest in Crotone since 2016 (of 53 with a page). Number 79 in Italy in 2025, of 216.

The power measured by the satellite is low (9.0 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
235ha
Copernicus perimeter
Duration
3days
8 Oct 2025 – 10 Oct 2025
Municipalities hit
2
municipalities
Started on
8 Oct
2025
Heat detections
5
in a single hotspot: 9 MW
Danger at start
8
Low · FWI index
Energy released
27MW
sum of detected power

Where it burned

11 Oct 2025
HOTSPOTS BY DAY 8 Oct10 Oct

How it evolved, day by day

811

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

21°high
59km/h · peak gust
47%lowest humidity

It had gone 0 days without rain (1 mm or more) when it started. Rain came after the fire: 1.3 mm on 13 Oct.

This area had burned before

19% of the perimeter overlaps earlier fires recorded since 2016: 44 ha in 2021, 10 ha in 2023. Part of it burned more than once, so the yearly figures add up to more than the 44 ha that had burned before.

What happened to each town

  1. Cutro 9,385 inhabitants · 2.7 km from the town where it started
    198 ha reached on 8 Oct
    1.5 %
  2. Crotone 58,445 inhabitants · 9.7 km from the town
    38 ha reached on 11 Oct
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas67 %
  • Broadleaved forest14 %
  • Scrub and transitional woodland9.0 %
  • Sclerophyllous scrub4.3 %
  • Coniferous forest3.4 %
  • Other natural land1.3 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 Oct 20.2 °C 47 % 59 km/h 0.2 mm Low 8
9 Oct 21.0 °C 47 % 30 km/h 0.0 mm Low 6
10 Oct 20.7 °C 67 % 20 km/h 0.0 mm Very low 4
11 Oct after 22.3 °C 56 % 40 km/h 0.0 mm Low 7
12 Oct after 21.0 °C 59 % 38 km/h 0.0 mm Low 7
13 Oct after 19.8 °C 73 % 22 km/h 1.3 mm Very low 1

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 Oct 2025
After · 17 Oct 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 13 October 2025 the air beside the fire reached 9 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak9 µg/m³
Days over the guideline0 days
PM1012 µg/m³
Optical depth0.25
678910111213
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 5Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Cutro fire last?
Copernicus dates it between 8 October 2025 and 10 October 2025: 3 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 235 hectares (2.4 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Cutro (198 ha, 1.5 %); Crotone (38 ha, 0.2 %).
Did the fire reach a town?
The closest fire to a town centre came within 2.7 km of Cutro. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 21.0 °C, humidity dropped to 47 % and gusts hit 59 km/h. The fire danger index (FWI) reached 8, class Low.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.