Skip to content
worldfires
MX · Mexico · –

Coyuca de Catalán fire, 10 May 2020 Coyuca de Catalán

Out · last detection

The fire started on in Coyuca de Catalán, Mexico, and satellites saw it burning for 11 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 3,553 hectares from heat detections, spread across a single municipality.

It is number 178 by size of the 582 fires with a page that started in Guerrero since 2016. Number 53 in Mexico in 2020, of 241.

Burnt area
3,553ha
GWIS perimeter (Copernicus)
Duration
11days
10 May 2020 – 20 May 2020
Municipalities hit
1
municipalities
Started on
10 May
2020
Heat detections
166
in a single hotspot: 82 MW
Danger at start
34
High · FWI index
Average daily power
108MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 10 May20 May
20 May 2020

How it evolved, day by day

10 May 2020 · 8 MW · 1 12 May 2020 · 21 MW · 4 13 May 2020 · 18 MW · 13 14 May 2020 · 136 MW · 26 15 May 2020 · 329 MW · 35 16 May 2020 · 220 MW · 49 17 May 2020 · 189 MW · 34 18 May 2020 · 52 MW · 3 20 May 2020 · 2 MW · 1
10 May 13 May 15 May 17 May 20 May

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
40km/h · peak gust
15%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started.

This area had burned before

90% of the perimeter overlaps earlier fires recorded since 2016: 436 ha in 2016, 3,115 ha in 2017, 14 ha in 2018. Part of it burned more than once, so the yearly figures add up to more than the 3,186 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 2.2% of the area of London (36 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Coyuca de Catalán where it started
    3,570 ha reached on 10 May
    1.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.11 ha
Residents< 20

Inside the perimeter there were about 0.11 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
10 May 33.3 °C 20 % 29 km/h 0.0 mm High 34
11 May 31.6 °C 26 % 25 km/h 0.1 mm High 34
12 May 32.8 °C 24 % 39 km/h 0.0 mm High 33
13 May 32.9 °C 22 % 40 km/h 0.0 mm High 34
14 May 33.0 °C 21 % 37 km/h 0.0 mm High 36
15 May 32.9 °C 18 % 37 km/h 0.0 mm High 38
16 May 33.2 °C 18 % 40 km/h 0.0 mm Very high 39
17 May 33.6 °C 16 % 34 km/h 0.0 mm Very high 41
18 May 33.5 °C 17 % 36 km/h 0.0 mm Very high 40
19 May 34.3 °C 15 % 37 km/h 0.0 mm Very high 42
20 May 33.7 °C 21 % 35 km/h 0.0 mm Very high 42
21 May after 32.7 °C 23 % 38 km/h 0.0 mm Very high 43
22 May after 33.2 °C 24 % 36 km/h 0.0 mm Very high 39
23 May after 32.9 °C 25 % 36 km/h 0.2 mm High 36
24 May after 32.6 °C 23 % 36 km/h 0.0 mm Very high 39
25 May after 32.7 °C 17 % 35 km/h 0.0 mm Very high 40
26 May after 32.1 °C 19 % 35 km/h 0.0 mm Very high 42
27 May after 33.4 °C 19 % 35 km/h 0.0 mm Very high 42
28 May after 33.2 °C 18 % 37 km/h 0.0 mm Very high 42
29 May after 32.5 °C 14 % 35 km/h 0.0 mm Very high 44
30 May after 33.1 °C 20 % 33 km/h 0.0 mm Very high 43

Its twins: fires that started in the same weather

It started with an FWI of 33.6, a minimum humidity of 20% and 2 days without rain. Fires in the area that started in weather like this since 2016: 20.

FWI at the start 33.6
Minimum humidity 20 %
Days without rain 2
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Coyuca de Catalán fire, March 2017
42,391 ha 46 days FWI 31.9 Min. humidity 20 % 2 km away, in 2017

First rain (1 mm or more) after it ended: 2.1 mm on 14 May.

What happened to them

14 days
median duration
2,464 ha
median area
100 %
went past 1,000 ha
1.4 mm
rain at the end (median; 16 of 20 had it)

It burned an area similar to its twins (3,553 ha against a median of 2,464 ha) and lasted 11 days, against 14 days.

In 4 of 20, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.4 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
40km/h · max. gust

It was considered over on 20 May, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 16 of 20, with a median of 1.4 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 3 May 2020
After · 27 May 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 166Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Mexico

Frequently asked questions

How long did the Coyuca de Catalán fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 10 May 2020 to 20 May 2020 (11 days). The perimeter dates it from 10 May 2020 to 18 May 2020.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 3,553 hectares (35.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Coyuca de Catalán (3,570 ha, 1.1 %).
What was the weather like?
During the fire the temperature reached 34.3 °C, humidity dropped to 15 % and gusts hit 40 km/h. The fire danger index (FWI) reached 42, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 20. Their median duration was 14 days and their median area 2,464 ha; 100 % went past 1,000 ha. In 4 of 20, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.4 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 10 May 2020 to 18 May 2020. 166 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.