Córdoba fire, July 2026 Córdoba
The fire started on 24 July 2026 in Córdoba, Spain, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 186 hectares from satellite imagery, spread across a single municipality.
It is the 12th largest in Córdoba since 2016 (of 16 with a page). Number 116 in Spain in 2026, of 196.
Compare with…
Suggestions: Obejo · 2024Obejo · 2017Obejo · 2026Obejo · 2022
- Burnt area
- 186ha
- Copernicus perimeter
- Duration
- ≈ 2days
- 24 Jul 2026 – 25 Jul 2026
- Municipalities hit
- 1
- municipalities
- Started on
- 24 Jul
- 2026
- Heat detections
- 7
- in a single hotspot: 79 MW
- Danger at start
- 52
- Extreme · FWI index
- Average daily power
- 85MW
- detected power per day, on average
Where it burned
How it evolved, day by day
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone 15 days without rain (1 mm or more) when it started.
This area had burned before
No earlier perimeters overlap this fire since 2016, when the satellite record begins.
What happened to each town
-
186 ha reached on 24 Jul0.2 %
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
- Sclerophyllous scrub66 %
- Agricultural areas28 %
- Broadleaved forest5.4 %
Natura 2000 protected area affected: 2 %
- LIC Guadalmellato ES6130006
Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 24 Jul | 36.7 °C | 9 % | 21 km/h | 0.0 mm | Extreme 52 |
| 25 Jul | 30.9 °C | 20 % | 17 km/h | 0.0 mm | Very high 43 |
| 26 Jul after | 35.3 °C | 12 % | 11 km/h | 0.0 mm | Very high 40 |
| 27 Jul after | 37.7 °C | 9 % | 19 km/h | 0.0 mm | Very high 45 |
| 28 Jul after | 38.9 °C | 12 % | 34 km/h | 0.0 mm | Extreme 52 |
| 29 Jul after | 38.8 °C | 15 % | 31 km/h | 0.0 mm | Extreme 51 |
| 30 Jul after | 40.3 °C | 13 % | 30 km/h | 0.0 mm | Extreme 51 |
| 31 Jul after | 41.2 °C | 14 % | 30 km/h | 0.0 mm | Extreme 52 |
| 1 Aug after | 41.5 °C | 10 % | 46 km/h | 0.0 mm | Extreme 65 |
| 2 Aug after | 37.6 °C | 16 % | 43 km/h | 0.0 mm | Extreme 60 |
| 3 Aug after | 33.5 °C | 24 % | 33 km/h | 0.0 mm | Very high 46 |
| 4 Aug after | 34.2 °C | 32 % | 33 km/h | 0.0 mm | Very high 41 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · CopernicusOn 22 July 2026 the air beside the fire reached 17 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table · 7Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
Frequently asked questions
- How long did the Córdoba fire last?
- The official perimeter only gives the start date (24 July 2026). The end comes from the heat detections inside the perimeter: it burned until 25 July 2026 (2 days from 24 July 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
- How much area did it burn?
- The perimeter Copernicus measured from satellite imagery is 186 hectares (1.9 km²). Official national figures may differ.
- Which municipalities burned?
- The fire only entered Córdoba (186 ha, 0.2 %).
- Did the fire reach a town?
- The fire started in Córdoba and came within 8.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
- What was the weather like?
- During the fire the temperature reached 36.7 °C, humidity dropped to 9 % and gusts hit 21 km/h. The fire danger index (FWI) reached 52, class Extreme.
- Where does this data come from?
- From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 112 · Emergency number and official warnings ›
Satellite cross-check
History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
No changes since 24 October 2026.
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
How we know this
- Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
- The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 7 Suomi-NPP VIIRS detections on those dates.
- We have not matched this page with any official record.
- Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Where this data comes from
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.