The fire started on 15 August 2021 in Villaharta, Spain, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 115 hectares from satellite imagery, spread across 2 municipalities. According to EGIF (MITECO), it was detected on 15 August 2021 at 20:15 and declared extinguished on 18 August 2021.
It is the 16th largest in Córdoba since 2016 (of 16 with a page). Number 108 in Spain in 2021, of 120.
The power measured by the satellite is low (1.9 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
41.6°C · 11% RH
High of 41.6 °C and minimum humidity of 11% on 15 August 2021; gusts of 37 km/h on 16 August 2021.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official EGIF (MITECO) record
Matches: 94 ha in the official record (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
Scrub and transitional woodland40 %
Agricultural areas35 %
Broadleaved forest25 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
Official record
According to EGIF (MITECO), this fire started on 15 August 2021 and burned 94 ha (the satellite measured 115 ha).
EspielSierra de Villaharta, Enjambradero15 August 2021 · 20:1594 ha· extinguished on 18 August 2021· cause: negligence
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
It started with an FWI of 56.9, a minimum humidity of 11% and 57 days without rain. Fires in the area that started in weather like this since 2016: 38.
FWI at the start56.9
Minimum humidity11 %
Days without rain57
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Villaharta fire, August 2021
115 ha2 daysFWI 56.9Min. humidity 11 %
Malagón fire, July 2022
2,509 ha8 daysFWI 53.3Min. humidity 14 %146 km away, in 2022
First rain (1 mm or more) after it ended: none in the following ten days.
It stayed below its twins: 115 ha against a median of 449 ha. It lasted 2 days, against 2 days.
In 34 of 38, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.2 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
1.7 mmfirst rain
23 Aug7 days after it ended
37km/h · max. gust
It was considered over on 16 Aug, and on 23 Aug 1.7 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 4 of 38, with a median of 2.2 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 8 Aug 2021
After · 23 Aug 2021
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 14 August 2021 the air beside the fire reached 32 µg/m³ of PM2.5. That day averaged 29: 2.0 times the WHO daily guideline (15).
PM2.5 peak32µg/m³
Days over the guideline3days
PM1074µg/m³
WHO 15
13 Aug15 Aug17 Aug19 Aug
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 3Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Copernicus dates it between 15 August 2021 and 16 August 2021: 2 days between the first and last image with fire. According to EGIF (MITECO), it was detected on 15 August 2021 at 20:15 and declared extinguished on 18 August 2021.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 115 hectares (1.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Villaharta (105 ha, 8.8 %); Espiel (10 ha, 0.0 %).
Did the fire reach a town?
The fire started in Villaharta and reached its centre: the point marking it was inside the burnt area or less than 500 metres from it. That does not mean houses burned.
What was the weather like?
During the fire the temperature reached 41.6 °C, humidity dropped to 9 % and gusts hit 37 km/h. The fire danger index (FWI) reached 60, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 38. Their median duration was 2 days and their median area 449 ha; 24 % went past 1,000 ha. In 34 of 38, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.2 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 3 Suomi-NPP VIIRS detections on those dates.
Compared with EGIF (MITECO): 94 official ha against 115 ha of perimeter; they agree within 25%.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.