Skip to content
worldfires
TR · Türkiye · →

Çınar fire, September 2020 Çınar

Out · last detection 4 Sept 2020, 00:11 UTC

The fire started on 3 September 2020 in Çınar, Türkiye, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 403 hectares from satellite imagery, spread across a single municipality.

It is the 30th largest in Diyarbakır since 2016 (of 110 with a page). Number 47 in Türkiye in 2020, of 212.

The power measured by the satellite is low (16.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
403ha
Copernicus perimeter
Duration
2days
3 Sept 2020 – 4 Sept 2020
Municipalities hit
1
districts
Started on
3 Sept
2020
Heat detections
28
in a single hotspot: 16 MW
Danger at start
62
Extreme · FWI index
Energy released
138MW
sum of detected power

Where it burned

4 Sept 2020
HOTSPOTS BY DAY 3 Sept4 Sept

How it evolved, day by day

34

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
37km/h · peak gust
10%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

8% of the perimeter overlaps earlier fires recorded since 2016: 34 ha in 2016.

What happened to each town

  1. Çınar 74,207 inhabitants · 18.2 km from the town where it started
    403 ha reached on 31 Aug
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas50 %
  • Other natural land50 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
3 Sept 36.7 °C 12 % 37 km/h 0.0 mm Extreme 62
4 Sept 37.3 °C 10 % 33 km/h 0.0 mm Extreme 56
5 Sept after 37.9 °C 9 % 45 km/h 0.0 mm Extreme 66
6 Sept after 37.4 °C 9 % 52 km/h 0.0 mm Very extreme 72
7 Sept after 36.2 °C 11 % 48 km/h 0.0 mm Extreme 67
8 Sept after 36.5 °C 12 % 26 km/h 0.0 mm Extreme 54
9 Sept after 35.2 °C 14 % 38 km/h 0.0 mm Extreme 58
10 Sept after 35.4 °C 12 % 33 km/h 0.0 mm Extreme 54
11 Sept after 35.6 °C 13 % 29 km/h 0.0 mm Extreme 50
12 Sept after 34.1 °C 14 % 33 km/h 0.0 mm Extreme 52
13 Sept after 37.6 °C 12 % 33 km/h 0.0 mm Extreme 56
14 Sept after 35.7 °C 14 % 40 km/h 0.0 mm Extreme 59

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 27 Aug 2020
After · 11 Sept 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 5 September 2020 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline3 days
PM1037 µg/m³
2930311234567
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 28Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Türkiye ›

Frequently asked questions

How long did the Çınar fire last?
Copernicus dates it between 3 September 2020 and 4 September 2020: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 403 hectares (4.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Çınar (403 ha, 0.2 %).
Did the fire reach a town?
The closest fire to a town centre came within 18.2 km of Çınar. That is the distance to the perimeter or nearest hotspot; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 37.3 °C, humidity dropped to 10 % and gusts hit 37 km/h. The fire danger index (FWI) reached 62, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.