Çınar fire, 31 August 2020 Çınar
The fire started on 31 August 2020 in Çınar, Türkiye, and satellites saw it burning for 5 days. Copernicus mapped a burnt perimeter of 403 hectares from satellite imagery, spread across a single municipality.
It is the 30th largest in Diyarbakır since 2016 (of 110 with a page). Number 47 in Türkiye in 2020, of 212.
The power measured by the satellite is low (16.4 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
Compare with…
Suggestions: Çınar · 2016Çınar · 2024Çınar · 2019Çınar · 2024
- Burnt area
- 403ha
- Copernicus perimeter
- Duration
- 5days
- 31 Aug 2020 – 4 Sept 2020
- Municipalities hit
- 1
- districts
- Started on
- 31 Aug
- 2020
- Heat detections
- 28
- in a single hotspot: 16 MW
- Danger at start
- 62
- Extreme · FWI index
- Average daily power
- 57MW
- detected power per day, on average
Where it burned
How it evolved, day by day
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone more than two months without rain (1 mm or more) when it started.
This area had burned before
8% of the perimeter overlaps earlier fires recorded since 2016: 34 ha in 2016.
What happened to each town
-
403 ha reached on 31 Aug0.2 %
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
- Agricultural areas50 %
- Other natural land50 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 3 Sept | 36.7 °C | 12 % | 37 km/h | 0.0 mm | Extreme 62 |
| 4 Sept | 37.3 °C | 10 % | 33 km/h | 0.0 mm | Extreme 56 |
| 5 Sept after | 37.9 °C | 9 % | 45 km/h | 0.0 mm | Extreme 66 |
| 6 Sept after | 37.4 °C | 9 % | 52 km/h | 0.0 mm | Very extreme 72 |
| 7 Sept after | 36.2 °C | 11 % | 48 km/h | 0.0 mm | Extreme 67 |
| 8 Sept after | 36.5 °C | 12 % | 26 km/h | 0.0 mm | Extreme 54 |
| 9 Sept after | 35.2 °C | 14 % | 38 km/h | 0.0 mm | Extreme 58 |
| 10 Sept after | 35.4 °C | 12 % | 33 km/h | 0.0 mm | Extreme 54 |
| 11 Sept after | 35.6 °C | 13 % | 29 km/h | 0.0 mm | Extreme 50 |
| 12 Sept after | 34.1 °C | 14 % | 33 km/h | 0.0 mm | Extreme 52 |
| 13 Sept after | 37.6 °C | 12 % | 33 km/h | 0.0 mm | Extreme 56 |
| 14 Sept after | 35.7 °C | 14 % | 40 km/h | 0.0 mm | Extreme 59 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · CopernicusOn 5 September 2020 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table · 28Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
Frequently asked questions
- How long did the Çınar fire last?
- According to the heat detections seen by satellite inside the perimeter, it burned from 31 August 2020 to 4 September 2020 (5 days). The perimeter dates it from 3 September 2020 to 4 September 2020.
- How much area did it burn?
- The perimeter Copernicus measured from satellite imagery is 403 hectares (4.0 km²). Official national figures may differ.
- Which municipalities burned?
- The fire only entered Çınar (403 ha, 0.2 %).
- Did the fire reach a town?
- The fire started in Çınar and came within 18.2 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
- What was the weather like?
- During the fire the temperature reached 37.3 °C, humidity dropped to 10 % and gusts hit 37 km/h. The fire danger index (FWI) reached 62, class Extreme.
- Where does this data come from?
- From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Türkiye (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 112 · Emergency number and official warnings ›
Satellite cross-check
History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
No changes since 24 October 2026.
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
How we know this
- Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
- Dates adjusted with the VIIRS detections inside the perimeter, which said 3 September 2020 to 4 September 2020. 28 Suomi-NPP VIIRS detections on those dates.
- We have not matched this page with any official record.
- Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Where this data comes from
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.