Chandrexa de Queixa fire, 13 September 2020
Manzaneda, Chandrexa de Queixa, Vilariño de Conso
Out · last detection 16 Sept 2020, 03:08 UTC
The fire started on 13 September 2020 in Chandrexa de Queixa, Spain, and satellites saw it burning for 4 days. Copernicus mapped a burnt perimeter of 823 hectares from satellite imagery, spread across 3 municipalities. According to EGIF (MITECO), it was detected on 13 September 2020 at 23:29 and declared extinguished on 17 September 2020.
It is the 28th largest in Ourense since 2016 (of 118 with a page). Number 10 in Spain in 2020, of 89.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
27.5°C · 22% RH
High of 27.5 °C and minimum humidity of 22% on 13 September 2020; gusts of 61 km/h on 14 September 2020.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official EGIF (MITECO) record
Matches: 811 ha in the official record (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
CSV for this fire chandrexa-de-queixa-2020-09-2.csv · daily, no individual hotspots
fecha
focos_viirs
frp_mw
tmax_c
tmin_c
hr_min_pct
viento_max_kmh
racha_max_kmh
precip_mm
fwi
clase_fwi
dentro_del_incendio
2020-09-13
0
0
27.5
12.5
22
15.2
37.8
0
31.1
alto
1
2020-09-14
11
139
22.1
12.7
46
17.1
61.2
10.7
18.3
moderado
1
2020-09-15
29
394
20.8
9.3
39
14
39.2
0.1
2.2
muy_bajo
1
2020-09-16
10
34
21.8
7.9
35
12.9
36.7
0
8.2
bajo
1
2020-09-17
0
0
21.2
11.1
45
14.9
51.8
11.2
13.1
moderado
0
It is generated in your browser from this page’s data: one file per fire, aggregated by day and without individual hotspots.
Live widget for your story
It updates itself while the fire is still active and links to this page. Free, with the attribution shown at the bottom.
Sources for this page: EFFIS (Copernicus), NASA FIRMS (VIIRS), EGIF (MITECO), ERA5 (ECMWF/Copernicus C3S) · Open-Meteo.com (CC BY 4.0), GHSL (JRC). Open-Meteo.com · How we build fire pages: methodology
Burnt area
823ha
Copernicus perimeter
Duration
4days
13 Sept 2020 – 16 Sept 2020
Municipalities hit
3
municipalities
Started on
13 Sept
2020
Heat detections
50
in a single hotspot: 64 MW
Danger at start
31
High · FWI index
Average daily power
189MW
detected power per day, on average
Where it burned
HOTSPOTS BY DAY
13 Sept16 Sept
Play back16 Sept 2020
How it evolved, day by day
14 Sept15 Sept16 Sept
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
28°high
61km/h · peak gust
22%lowest humidity
It had gone 23 days without rain (1 mm or more) when it started. Rain came after the fire: 11.2 mm on 17 Sept.
This area had burned before
No earlier perimeters overlap this fire since 2016, when the satellite record begins.
How big is it?
It burned the equivalent of 0.5% of the area of London (8.2 km² against 1,583 km²).
London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).
It burned the equivalent of 1.4% of the area of Madrid (8.2 km² against 604 km²).
Madrid boundary: geoBoundaries · Open Data ESRI, IGN Central Registry of Cartography Area (CC BY 4.0).
It burned the equivalent of 7.8% of the area of Paris (8.2 km² against 105 km²).
Paris boundary: geoBoundaries · Institut national de l'information géographique et forestière (IGN-F) (Etalab Open License 2.0).
It burned the equivalent of 0.9% of the area of Berlin (8.2 km² against 892 km²).
Berlin boundary: geoBoundaries · Federal Agency for Cartography and Geodesy (dl-de/by-2-0).
Fire perimeterLondon
This compares size, not location: both shapes are at the same scale, north up, centred on each other.
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
People and buildings inside the perimeter
GHSL 2020
Built-up area< 0.1ha
Residents< 20
Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
13 Sept
27.5 °C
22 %
38 km/h
0.0 mm
High 31
14 Sept
22.1 °C
46 %
61 km/h
10.7 mm
Moderate 18
15 Sept
20.8 °C
39 %
39 km/h
0.1 mm
Very low 2
16 Sept
21.8 °C
35 %
37 km/h
0.0 mm
Low 8
17 Sept after
21.2 °C
45 %
52 km/h
11.2 mm
Moderate 13
Its twins: fires that started in the same weather
It started with an FWI of 31.1, a minimum humidity of 22% and 23 days without rain. Fires in the area that started in weather like this since 2016: 25.
FWI at the start31.1
Minimum humidity22 %
Days without rain23
this firechosen twinsrest of the area
Almost identicalSimilar
Outlines of the closest twins
This fire · Chandrexa de Queixa fire, 13 September 2020
823 ha4 daysFWI 31.1Min. humidity 22 %
Maceda fire, October 2017
712 ha2 daysFWI 30.2Min. humidity 23 %25 km away, in 2017
First rain (1 mm or more) after it ended: 19.6 mm on 17 Oct.
It was 2.3 times larger than the median of its twins and lasted 4 days, against 2 days.
Only 4 of its 25 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 6 of 25, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.4 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
11.2 mmfirst rain
17 Septthe day after it ended
61km/h · max. gust
It was considered over on 16 Sept, and on 17 Sept 11.2 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 19 of 25, with a median of 1.4 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
Drag the line to compare the same ground before the fire and after it.
↔
Before · 6 Sept 2020
After · 23 Sept 2020
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · Copernicus
On 14 September 2020 the air beside the fire reached 38 µg/m³ of PM2.5. That day averaged 23: 1.5 times the WHO daily guideline (15).
PM2.5 peak38µg/m³
Days over the guideline2days
PM1055µg/m³
WHO 15
11 Sept13 Sept15 Sept17 Sept19 Sept
GoodFairModeratePoorVery poorExtremely poor
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table· 50Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Copernicus dates it between 13 September 2020 and 16 September 2020: 4 days between the first and last image with fire. According to EGIF (MITECO), it was detected on 13 September 2020 at 23:29 and declared extinguished on 17 September 2020.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 823 hectares (8.2 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Manzaneda (539 ha, 4.7 %); Chandrexa de Queixa (232 ha, 1.4 %); Vilariño de Conso (52 ha, 0.3 %).
Did the fire reach a town?
The fire came within 6.6 km of the centre of Manzaneda, the closest of the areas it touched. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 27.5 °C, humidity dropped to 22 % and gusts hit 61 km/h. The fire danger index (FWI) reached 31, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 25. Their median duration was 2 days and their median area 359 ha; 16 % went past 1,000 ha. Only 4 of its 25 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 6 of 25, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.4 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: EFFIS (Copernicus), mapped on satellite imagery; 2 polygons grouped in this page.
Dates from the perimeter: the VIIRS detections inside it did not change them. 50 Suomi-NPP VIIRS detections on those dates.
Compared with EGIF (MITECO): 811 official ha against 823 ha of perimeter; they agree within 25%.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.