Bulqizë fire, 27 August 2026 Bulqizë, Dibër, Mat
The fire started on 27 August 2026 in Bulqizë, Albania, and satellites saw it burning for 16 days. Copernicus mapped a burnt perimeter of 1,055 hectares from satellite imagery, spread across 3 municipalities.
It is the 5th largest in Dibër since 2016 (of 54 with a page). Number 4 in Albania in 2026, of 43.
The power measured by the satellite is low (24.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.
- Burnt area
- 1,055ha
- Copernicus perimeter
- Duration
- 16days
- 27 Aug 2026 – 11 Sept 2026
- Municipalities hit
- 3
- municipalities
- Started on
- 27 Aug
- 2026
- Heat detections
- 122
- in a single hotspot: 25 MW
- Danger at start
- 34
- High · FWI index
- Energy released
- 706MW
- sum of detected power
Where it burned
How it evolved, day by day
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
The weather it burned in
It had gone 30 days without rain (1 mm or more) when it started.
This area had burned before
5% of the perimeter overlaps earlier fires recorded since 2016: 50 ha in 2017.
What happened to each town
-
Bulqizë where it started698 ha reached on 27 Aug1.0 %
-
204 ha reached on 5 Sept0.2 %
-
154 ha reached on 7 Sept0.2 %
Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.
What burned
- Other natural land65 %
- Scrub and transitional woodland29 %
- Broadleaved forest6.6 %
Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
| Day | High | Min. humidity | Peak gust | Rain | Danger (FWI) |
|---|---|---|---|---|---|
| 27 Aug | 31.2 °C | 25 % | 40 km/h | 0.0 mm | High 34 |
| 28 Aug | 32.3 °C | 26 % | 42 km/h | 0.0 mm | High 35 |
| 29 Aug | 33.5 °C | 24 % | 48 km/h | 0.0 mm | Very high 40 |
| 30 Aug | 30.4 °C | 25 % | 47 km/h | 0.0 mm | Very high 41 |
| 31 Aug | 31.2 °C | 23 % | 36 km/h | 0.0 mm | High 37 |
| 1 Sept | 30.1 °C | 28 % | 35 km/h | 0.0 mm | High 36 |
| 2 Sept | 29.0 °C | 32 % | 34 km/h | 0.0 mm | High 34 |
| 3 Sept | 27.1 °C | 29 % | 30 km/h | 0.1 mm | High 31 |
| 4 Sept | 27.9 °C | 20 % | 37 km/h | 0.0 mm | High 37 |
| 5 Sept | 30.6 °C | 17 % | 31 km/h | 0.0 mm | Very high 38 |
| 6 Sept | 30.8 °C | 21 % | 35 km/h | 0.0 mm | Very high 40 |
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
The smoke
CAMS · CopernicusOn 29 August 2026 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 20: 1.3 times the WHO daily guideline (15).
Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.
Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)
Detections table · 122Every satellite heat detection, one by one, with time, satellite, power and coordinates.
| Date and time | Satellite | FRP (MW) | Lat | Lon |
|---|
Other fires nearby
Frequently asked questions
- How long did the Bulqizë fire last?
- According to the heat detections seen by satellite inside the perimeter, it burned from 27 August 2026 to 11 September 2026 (16 days). The perimeter dates it from 27 August 2026 to 27 August 2026.
- How much area did it burn?
- The perimeter Copernicus measured from satellite imagery is 1,055 hectares (10.6 km²). Official national figures may differ.
- Which municipalities burned?
- The fire entered 3 municipalities: Bulqizë (698 ha, 1.0 %); Dibër (204 ha, 0.2 %); Mat (154 ha, 0.2 %).
- What was the weather like?
- During the fire the temperature reached 31.2 °C, humidity dropped to 25 % and gusts hit 40 km/h. The fire danger index (FWI) reached 34, class High.
- Where does this data come from?
- From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Albania (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
Emergency number: 128 · 112
Satellite cross-check
Does something look wrong on this page?
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
Report an error
Where this data comes from
The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 2.5 Generic). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.