Skip to content
worldfires
RS · Serbia · –

Bujanovac Municipality fire, August 2019 Бујановац · Bujanovac Municipality

Out · last detection 30 Aug 2019, 01:08 UTC

The fire started on 28 August 2019 in Bujanovac Municipality, Serbia, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 153 hectares from satellite imagery, spread across a single municipality.

It is the 50th largest in Pčinjski upravni okrug since 2016 (of 80 with a page). Number 29 in Serbia in 2019, of 38.

The power measured by the satellite is low (24.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
153ha
Copernicus perimeter
Duration
3days
28 Aug 2019 – 30 Aug 2019
Municipalities hit
1
municipalities
Started on
28 Aug
2019
Heat detections
9
in a single hotspot: 25 MW
Danger at start
28
High · FWI index
Average daily power
20MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 28 Aug30 Aug
30 Aug 2019

How it evolved, day by day

28 Aug 2019 · 2 MW · 3 29 Aug 2019 · 58 MW · 5 30 Aug 2019 · 1 MW · 1
28 Aug 29 Aug 30 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
32km/h · peak gust
26%lowest humidity

It had gone one day without rain (1 mm or more) when it started. Rain came after the fire: 1.8 mm on 6 Sept.

This area had burned before

43% of the perimeter overlaps earlier fires recorded since 2016: 66 ha in 2017.

What happened to each town

  1. Bujanovac Municipality Бујановац 41,068 inhabitants · 9.6 km from the centre where it started
    153 ha reached on 28 Aug
    0.3 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Broadleaved forest62 %
  • Scrub and transitional woodland32 %
  • Agricultural areas5.3 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
28 Aug 31.4 °C 29 % 24 km/h 0.0 mm High 28
29 Aug 31.4 °C 28 % 25 km/h 0.0 mm High 31
30 Aug 31.1 °C 26 % 32 km/h 0.0 mm High 31
31 Aug after 29.7 °C 33 % 33 km/h 0.0 mm High 34
1 Sept after 30.2 °C 21 % 24 km/h 0.0 mm High 33
2 Sept after 31.4 °C 20 % 24 km/h 0.0 mm High 32
3 Sept after 27.5 °C 38 % 45 km/h 0.0 mm Very high 40
4 Sept after 23.3 °C 53 % 38 km/h 0.0 mm High 28
5 Sept after 28.0 °C 39 % 20 km/h 0.0 mm High 22
6 Sept after 28.1 °C 47 % 25 km/h 1.8 mm High 25

Its twins: fires that started in the same weather

It started with an FWI of 27.5, a minimum humidity of 29% and 1 day without rain. Fires in the area that started in weather like this since 2016: 53.

FWI at the start 27.5
Minimum humidity 29 %
Days without rain 1
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Pukë fire, August 2021
2,498 ha 12 days FWI 27.7 Min. humidity 29 % 155 km away, in 2021

First rain (1 mm or more) after it ended: 6.7 mm on 25 Aug.

What happened to them

5 days
median duration
304 ha
median area
13 %
went past 1,000 ha
3.8 mm
rain at the end (median; 45 of 53 had it)

It stayed below its twins: 153 ha against a median of 304 ha. It lasted 3 days, against 5 days.

In 8 of 53, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.8 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

1.8 mmfirst rain
6 Sept7 days after it ended
32km/h · max. gust

It was considered over on 30 Aug, and on 6 Sept 1.8 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 45 of 53, with a median of 3.8 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 21 Aug 2019
After · 6 Sept 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 1 September 2019 the air beside the fire reached 17 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak17 µg/m³
Days over the guideline0 days
PM1020 µg/m³
26 Aug28 Aug30 Aug1 Sept
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 9Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Serbia

Frequently asked questions

How long did the Bujanovac Municipality fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 28 August 2019 to 30 August 2019 (3 days). The perimeter dates it from 29 August 2019 to 30 August 2019.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 153 hectares (1.5 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Bujanovac Municipality (153 ha, 0.3 %).
Did the fire reach a town?
The fire started in Bujanovac Municipality and came within 9.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 31.4 °C, humidity dropped to 26 % and gusts hit 32 km/h. The fire danger index (FWI) reached 31, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Serbia (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 53. Their median duration was 5 days and their median area 304 ha; 13 % went past 1,000 ha. In 8 of 53, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 3.8 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · 112 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 29 August 2019 to 30 August 2019. 9 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Open Data Commons Open Database License 1.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.