Skip to content
worldfires
DZ · Algeria · →

Beni Mileuk fire, July 2016 بني مليك،تيبازة · Algeria

Out · last detection 28 Jul 2016, 13:21 UTC

The fire started on 27 July 2016 in Beni Mileuk, Algeria, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 283 hectares from satellite imagery, spread across a single municipality.

It is the 24th largest in Tipaza since 2016 (of 59 with a page). Number 25 in Algeria in 2016, of 62.

The power measured by the satellite is low (21.6 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
283ha
Copernicus perimeter
Duration
2days
27 Jul 2016 – 28 Jul 2016
Municipalities hit
0
communes
Started on
27 Jul
2016
Heat detections
20
in a single hotspot: 22 MW
Danger at start
44
Very high · FWI index
Average daily power
120MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 27 Jul28 Jul
28 Jul 2016

How it evolved, day by day

27 Jul 2016 · 229 MW · 16 28 Jul 2016 · 11 MW · 4
27 Jul 28 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
38km/h · peak gust
21%lowest humidity

It had gone 40 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What burned

  • Mixed forest78 %
  • Other natural land20 %
  • Broadleaved forest1.4 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
27 Jul 38.0 °C 21 % 38 km/h 0.0 mm Very high 44
28 Jul 37.5 °C 23 % 36 km/h 0.0 mm Very high 43
29 Jul after 37.7 °C 28 % 36 km/h 0.0 mm Very high 41
30 Jul after 38.8 °C 26 % 31 km/h 0.0 mm Very high 40
31 Jul after 38.9 °C 22 % 41 km/h 0.0 mm Very high 44
1 Aug after 38.8 °C 23 % 35 km/h 0.0 mm Very high 42
2 Aug after 37.3 °C 23 % 41 km/h 0.0 mm Very high 47
3 Aug after 39.4 °C 16 % 36 km/h 0.0 mm Very high 48
4 Aug after 37.2 °C 25 % 45 km/h 0.0 mm Very high 49
5 Aug after 34.2 °C 32 % 42 km/h 0.0 mm Very high 41
6 Aug after 29.4 °C 43 % 50 km/h 0.0 mm High 36
7 Aug after 28.3 °C 43 % 52 km/h 0.0 mm High 35

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 20 Jul 2016
After · 4 Aug 2016

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 31 July 2016 the air beside the fire reached 38 µg/m³ of PM2.5. That day averaged 24: 1.6 times the WHO daily guideline (15).

PM2.5 peak38 µg/m³
Days over the guideline4 days
PM1056 µg/m³
25262728293031
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 20Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Algeria ›

Frequently asked questions

How long did the Beni Mileuk fire last?
Copernicus dates it between 27 July 2016 and 28 July 2016: 2 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 283 hectares (2.8 km²). Official national figures may differ.
What was the weather like?
During the fire the temperature reached 38.0 °C, humidity dropped to 21 % and gusts hit 38 km/h. The fire danger index (FWI) reached 44, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Algeria (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 14 · 1021 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 14 · 1021.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 20 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution-ShareAlike 2.0). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.