Skip to content
worldfires
ES · Spain · →

Azuaga fire, June 2022 Azuaga

Out · last detection 14 Jun 2022, 14:05 UTC

The fire started on 14 June 2022 in Azuaga, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 129 hectares from satellite imagery, spread across a single municipality. According to EGIF (MITECO), it was detected on 14 June 2022 at 16:12 and declared extinguished on 16 June 2022.

It is the 45th largest in Badajoz since 2016 (of 52 with a page). Number 144 in Spain in 2022, of 192.

Compare with…
Burnt area
129ha
Copernicus perimeter
Duration
1day
14 Jun 2022 – 14 Jun 2022
Municipalities hit
1
municipalities
Started on
14 Jun
2022
Heat detections
4
in a single hotspot: 44 MW
Danger at start
50
Extreme · FWI index
Average daily power
125MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Jun14 Jun

How it evolved, day by day

14 Jun 2022 · 125 MW · 4

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

38°high
35km/h · peak gust
17%lowest humidity

It had gone 40 days without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Azuaga 7,587 inhabitants · 17.6 km from the centre where it started
    130 ha reached on 14 Jun
    0.3 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas69 %
  • Scrub and transitional woodland31 %

Natura 2000 protected area affected: 4 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to EGIF (MITECO), this fire started on 14 June 2022 and burned 143 ha (the satellite measured 129 ha).

MITECO, Estadística General de Incendios Forestales (EGIF). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Jun 37.9 °C 17 % 35 km/h 0.0 mm Extreme 50
15 Jun after 37.1 °C 19 % 47 km/h 0.0 mm Extreme 60
16 Jun after 34.9 °C 28 % 44 km/h 0.2 mm Extreme 52
17 Jun after 36.0 °C 22 % 43 km/h 0.0 mm Very high 50
18 Jun after 32.6 °C 28 % 58 km/h 0.0 mm Extreme 50
19 Jun after 28.0 °C 32 % 42 km/h 0.0 mm Very high 39
20 Jun after 24.6 °C 30 % 34 km/h 0.0 mm High 36
21 Jun after 26.1 °C 27 % 41 km/h 0.0 mm Very high 41
22 Jun after 22.2 °C 43 % 32 km/h 0.6 mm High 27
23 Jun after 23.4 °C 37 % 35 km/h 0.3 mm High 27
24 Jun after 25.8 °C 31 % 31 km/h 0.0 mm High 30

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Jun 2022
After · 21 Jun 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 15 June 2022 the air beside the fire reached 23 µg/m³ of PM2.5. That day averaged 18: 1.2 times the WHO daily guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline3 days
PM10107 µg/m³
121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 4Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Azuaga fire last?
Copernicus dates it between 14 June 2022 and 14 June 2022: 1 day between the first and last image with fire. According to EGIF (MITECO), it was detected on 14 June 2022 at 16:12 and declared extinguished on 16 June 2022.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 129 hectares (1.3 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Azuaga (130 ha, 0.3 %).
Did the fire reach a town?
The fire started in Azuaga and came within 17.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 37.9 °C, humidity dropped to 17 % and gusts hit 35 km/h. The fire danger index (FWI) reached 50, class Extreme.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 4 Suomi-NPP VIIRS detections on those dates.
  • Compared with EGIF (MITECO): 143 official ha against 129 ha of perimeter; they agree within 25%.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.