Skip to content
worldfires
SS · South Sudan · →

Aweil Centre fire, 21 October 2026 Aweil Centre, Aweil West

Dying down · last detection 31 Oct 2026, 23:44 UTC

Satellites first detected fire on 21 October 2026 in Aweil Centre, South Sudan. It has been active for 10 days, with 418 heat detections and an area with fire of about 5,194 hectares rebuilt from them, spread across 2 municipalities.

Compare with…

GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.

Is it still active?

No detections since 31 Oct 2026, 23:44 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.

Area with fire
≈ 5,194ha
rebuilt from hotspots, no official perimeter yet
Duration
10days
21 Oct 2026 – 30 Oct 2026
Municipalities hit
2
counties
Started on
21 Oct
2026
Heat detections
418
in a single hotspot: 67 MW
Danger at start
38
Very high · FWI index
Average daily power
449MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 21 Oct30 Oct
31 Oct 2026

How it evolved, day by day

21 Oct 2026 · 533 MW · 57 22 Oct 2026 · 507 MW · 90 23 Oct 2026 · 323 MW · 68 24 Oct 2026 · 68 MW · 12 25 Oct 2026 · 330 MW · 46 26 Oct 2026 · 4 MW · 1 27 Oct 2026 · 0 MW · 0 28 Oct 2026 · 1,189 MW · 135 29 Oct 2026 · 591 MW · 99 30 Oct 2026 · 654 MW · 81 31 Oct 2026 · 289 MW · 25
21 Oct 23 Oct 25 Oct 27 Oct 28 Oct 29 Oct 31 Oct

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

41°high
42km/h · peak gust
10%lowest humidity

It had gone 9 days without rain (1 mm or more) when it started.

What happened to each town

  1. Aweil Centre where it started
    2,772 ha reached on 21 Oct
    0.2 %
  2. 2,436 ha reached on 21 Oct
    0.5 %

Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives

Day High Min. humidity Peak gust Rain Danger (FWI)
21 Oct 40.6 °C 21 % 30 km/h 0.0 mm Very high 38
22 Oct 40.9 °C 14 % 29 km/h 0.0 mm Very high 43
23 Oct 39.0 °C 13 % 31 km/h 0.0 mm Very high 49
24 Oct 40.0 °C 14 % 28 km/h 0.0 mm Very high 41
25 Oct 39.8 °C 13 % 23 km/h 0.0 mm Very high 44
26 Oct 39.2 °C 24 % 26 km/h 1.8 mm High 30
27 Oct 36.8 °C 24 % 42 km/h 0.0 mm High 37
28 Oct 38.5 °C 19 % 37 km/h 0.0 mm Very high 44
29 Oct 40.0 °C 10 % 31 km/h 0.0 mm Extreme 52
30 Oct 39.5 °C 13 % 32 km/h 0.0 mm Extreme 52
31 Oct after 38.6 °C 20 % 20 km/h 0.0 mm Very high 47
1 Nov after 38.5 °C 23 % 27 km/h 0.1 mm Very high 43
2 Nov after 39.5 °C 20 % 26 km/h 0.0 mm Very high 44

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 14 Oct 2026
After · 1 Nov 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 23 October 2026 the air beside the fire reached 80 µg/m³ of PM2.5. That day averaged 52: 3.4 times the WHO daily guideline (15).

PM2.5 peak80 µg/m³
Days over the guideline11 days
PM10164 µg/m³
Optical depth0.55
181920212223242526272829
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 418Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in South Sudan ›

Frequently asked questions

How long did the Aweil Centre fire last?
According to the heat detections seen by satellite, it burned from 21 October 2026 to 30 October 2026 (10 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no perimeter yet. Heat detections rebuild about 5,194 hectares with fire (51.9 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
Which municipalities burned?
The fire entered 2 municipalities: Aweil Centre (2,772 ha, 0.2 %); Aweil West (2,436 ha, 0.5 %).
Is the Aweil Centre fire still active?
No fire detections since 31 Oct 2026, 23:44 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 40.9 °C, humidity dropped to 10 % and gusts hit 42 km/h. The fire danger index (FWI) reached 52, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of South Sudan (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 4 Changes in area, dates, name, official record or merged pages, compared every night since 30 October 2026.
  1. Last day with fire: 29 October 2026 → 30 October 2026.
  2. Area: ≈ 6,496 → ≈ 5,194 ha.
  3. Start date: 20 October 2026 → 21 October 2026.
  4. Page published (≈ 6,496 ha).

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • No perimeter yet: the area (≈ 5,194 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
  • Dates of the first and last VIIRS detection of the cluster. 418 Suomi-NPP VIIRS detections on those dates.
  • Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.

How we build fire pages: methodology ›

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.