Skip to content
worldfires
UA · Ukraine · →

Apostolove fire, June 2025 Апостолівський район · Apostolove

Out · last detection 12 Jun 2025, 10:34 UTC

The fire started on 12 June 2025 in Apostolove, Ukraine, and satellites saw it burning for 3 days. Copernicus mapped a burnt perimeter of 296 hectares from satellite imagery, spread across a single municipality.

It is the 48th largest in Dnipropetrovsk Oblast since 2016 (of 183 with a page). Number 399 in Ukraine in 2025, of 1359.

The power measured by the satellite is low (5.5 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
296ha
Copernicus perimeter
Duration
3days
12 Jun 2025 – 14 Jun 2025
Municipalities hit
1
districts
Started on
12 Jun
2025
Heat detections
1
in a single hotspot: 5 MW
Danger at start
23
High · FWI index
Average daily power
5MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 12 Jun14 Jun

How it evolved, day by day

12 Jun 2025 · 5 MW · 1

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

26°high
49km/h · peak gust
38%lowest humidity

It had gone 11 days without rain (1 mm or more) when it started. Rain came after the fire: 6.3 mm on 15 Jun.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Apostolove Апостолівський район 54,324 inhabitants · 22.6 km from the centre where it started
    295 ha reached on 12 Jun
    0.2 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Agricultural areas63 %
  • Other natural land32 %
  • Mixed forest5.4 %

Land cover inside the perimeter as reported by Copernicus EFFIS (outside the Corine Land Cover area).

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
12 Jun 25.8 °C 38 % 43 km/h 0.9 mm High 23
13 Jun 22.1 °C 39 % 49 km/h 0.0 mm High 26
14 Jun 20.8 °C 56 % 31 km/h 2.6 mm Low 5
15 Jun after 20.3 °C 60 % 42 km/h 6.3 mm Very low 2

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 5 Jun 2025
After · 21 Jun 2025

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 14 June 2025 the air beside the fire reached 18 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak18 µg/m³
Days over the guideline0 days
PM1028 µg/m³
Optical depth0.88
1011121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 1Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Ukraine ›

Frequently asked questions

How long did the Apostolove fire last?
Copernicus dates it between 12 June 2025 and 14 June 2025: 3 days between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 296 hectares (3.0 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Apostolove (295 ha, 0.2 %).
Did the fire reach a town?
The fire started in Apostolove and came within 22.6 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 25.8 °C, humidity dropped to 38 % and gusts hit 49 km/h. The fire danger index (FWI) reached 26, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Ukraine (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 101 · 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 101 · 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. One Suomi-NPP VIIRS detection on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Public Domain). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.