Skip to content
worldfires
BR · Brazil · –

Altamira fire, 20 August 2019 Altamira, Itaituba

Out · last detection 4 Sept 2019, 17:29 UTC

The fire started on 20 August 2019 in Altamira, Brazil, and satellites saw it burning for 16 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 4,249 hectares from heat detections, spread across 2 municipalities.

It is the 558th largest in Pará since 2016 (of 957 with a page). Number 586 in Brazil in 2019, of 973.

Burnt area
4,249ha
GWIS perimeter (Copernicus)
Duration
16days
20 Aug 2019 – 4 Sept 2019
Municipalities hit
2
municipalities
Started on
20 Aug
2019
Heat detections
174
in a single hotspot: 310 MW
Danger at start
33
High · FWI index
Average daily power
140MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 20 Aug4 Sept
4 Sept 2019

How it evolved, day by day

20 Aug 2019 · 981 MW · 28 21 Aug 2019 · 66 MW · 41 22 Aug 2019 · 37 MW · 8 23 Aug 2019 · 34 MW · 9 24 Aug 2019 · 1 MW · 1 25 Aug 2019 · 112 MW · 11 26 Aug 2019 · 53 MW · 19 27 Aug 2019 · 411 MW · 18 28 Aug 2019 · 136 MW · 20 29 Aug 2019 · 38 MW · 8 30 Aug 2019 · 9 MW · 3 1 Sept 2019 · 19 MW · 3 3 Sept 2019 · 15 MW · 1 4 Sept 2019 · 48 MW · 4
20 Aug 23 Aug 26 Aug 29 Aug 3 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
37km/h · peak gust
28%lowest humidity

It had gone 40 days without rain (1 mm or more) when it started.

This area had burned before

81% of the perimeter overlaps earlier fires recorded since 2016: 3,439 ha in 2017.

How big is it?

10 km
It burned the equivalent of 2.7% of the area of London (42 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Altamira 126,279 inhabitants where it started
    4,138 ha reached on 20 Aug
    0.0 %
  2. Itaituba 123,314 inhabitants
    143 ha reached on 26 Aug
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
20 Aug 35.5 °C 28 % 26 km/h 0.0 mm High 33
21 Aug 33.9 °C 37 % 30 km/h 0.7 mm High 25
22 Aug 34.4 °C 40 % 27 km/h 0.0 mm High 26
23 Aug 35.3 °C 39 % 28 km/h 2.1 mm Moderate 15
24 Aug 33.6 °C 43 % 30 km/h 0.5 mm High 22
25 Aug 33.9 °C 36 % 37 km/h 0.0 mm High 28
26 Aug 34.8 °C 33 % 37 km/h 0.0 mm High 30
27 Aug 35.5 °C 31 % 35 km/h 0.0 mm High 32
28 Aug 36.1 °C 29 % 31 km/h 0.0 mm High 32
29 Aug 35.9 °C 30 % 31 km/h 0.0 mm High 32
30 Aug 36.0 °C 30 % 28 km/h 0.0 mm High 32
31 Aug 34.8 °C 30 % 36 km/h 0.0 mm High 32
1 Sept 34.1 °C 36 % 30 km/h 0.0 mm High 32
2 Sept 35.0 °C 40 % 29 km/h 0.4 mm High 30
3 Sept 34.8 °C 42 % 30 km/h 0.2 mm High 30
4 Sept 36.2 °C 38 % 36 km/h 0.7 mm High 25
5 Sept after 35.5 °C 38 % 34 km/h 0.5 mm High 27
6 Sept after 34.6 °C 42 % 29 km/h 0.0 mm High 27
7 Sept after 35.1 °C 33 % 38 km/h 0.2 mm High 32
8 Sept after 35.4 °C 29 % 32 km/h 0.0 mm High 33
9 Sept after 35.5 °C 33 % 33 km/h 0.0 mm High 34
10 Sept after 34.7 °C 37 % 35 km/h 0.0 mm High 33
11 Sept after 36.2 °C 33 % 35 km/h 0.0 mm High 34
12 Sept after 36.4 °C 31 % 34 km/h 0.0 mm High 35
13 Sept after 36.8 °C 31 % 44 km/h 0.0 mm High 36
14 Sept after 35.9 °C 35 % 27 km/h 0.0 mm High 34

Its twins: fires that started in the same weather

It started with an FWI of 32.7, a minimum humidity of 28% and 40 days without rain. Fires in the area that started in weather like this since 2016: 37.

FWI at the start 32.7
Minimum humidity 28 %
Days without rain 40
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Altamira fire, August 2021
3,555 ha 24 days FWI 38.4 Min. humidity 28 % 8 km away, in 2021

First rain (1 mm or more) after it ended: 2.9 mm on 27 Aug.

What happened to them

18 days
median duration
4,477 ha
median area
14 %
went past 10,000 ha
1.4 mm
rain at the end (median; 20 of 37 had it)

It burned an area similar to its twins (4,249 ha against a median of 4,477 ha) and lasted 16 days, against 18 days.

In 17 of 37, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.4 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
37km/h · max. gust

It was considered over on 4 Sept, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 20 of 37, with a median of 1.4 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 13 Aug 2019
After · 11 Sept 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 174Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Brazil

Frequently asked questions

How long did the Altamira fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 20 August 2019 to 4 September 2019 (16 days). The perimeter dates it from 20 August 2019 to 30 August 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 4,249 hectares (42.5 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Altamira (4,138 ha, 0.0 %); Itaituba (143 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 36.2 °C, humidity dropped to 28 % and gusts hit 37 km/h. The fire danger index (FWI) reached 33, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Brazil (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 37. Their median duration was 18 days and their median area 4,477 ha; 14 % went past 10,000 ha. In 17 of 37, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.4 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 30 August 2019 → 4 September 2019.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 20 August 2019 to 30 August 2019. 174 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.