Skip to content
worldfires
BR · Brazil · –

Altamira fire, 16 August 2019 Altamira

Out · last detection 30 Aug 2019, 17:22 UTC

The fire started on 16 August 2019 in Altamira, Brazil, and satellites saw it burning for 14 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 6,885 hectares from heat detections, spread across a single municipality.

It is the 300th largest in Pará since 2016 (of 957 with a page). Number 295 in Brazil in 2019, of 973.

Burnt area
6,885ha
GWIS perimeter (Copernicus)
Duration
14days
16 Aug 2019 – 29 Aug 2019
Municipalities hit
1
municipalities
Started on
16 Aug
2019
Heat detections
460
in a single hotspot: 410 MW
Danger at start
42
Very high · FWI index
Average daily power
629MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 16 Aug29 Aug
30 Aug 2019

How it evolved, day by day

16 Aug 2019 · 393 MW · 5 17 Aug 2019 · 3,836 MW · 89 18 Aug 2019 · 653 MW · 131 19 Aug 2019 · 1,245 MW · 103 20 Aug 2019 · 276 MW · 44 21 Aug 2019 · 36 MW · 4 25 Aug 2019 · 4 MW · 2 26 Aug 2019 · 715 MW · 38 27 Aug 2019 · 66 MW · 18 28 Aug 2019 · 48 MW · 8 29 Aug 2019 · 261 MW · 14 30 Aug 2019 · 9 MW · 4
17 Aug 25 Aug 28 Aug

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

36°high
40km/h · peak gust
23%lowest humidity

It had gone 37 days without rain (1 mm or more) when it started.

This area had burned before

83% of the perimeter overlaps earlier fires recorded since 2016: 4,093 ha in 2016, 647 ha in 2017, 4,089 ha in 2018. Part of it burned more than once, so the yearly figures add up to more than the 5,715 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 4.3% of the area of London (69 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Altamira 126,279 inhabitants where it started
    6,965 ha reached on 16 Aug
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.10 ha
Residents< 20

Inside the perimeter there were about 0.10 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
16 Aug 34.4 °C 29 % 40 km/h 0.0 mm Very high 42
17 Aug 34.1 °C 27 % 35 km/h 0.0 mm Very high 39
18 Aug 34.0 °C 29 % 27 km/h 0.0 mm High 36
19 Aug 35.0 °C 27 % 27 km/h 0.0 mm High 36
20 Aug 35.2 °C 23 % 25 km/h 0.0 mm High 37
21 Aug 34.7 °C 29 % 23 km/h 0.0 mm High 37
22 Aug 34.3 °C 36 % 25 km/h 0.0 mm High 32
23 Aug 35.0 °C 33 % 25 km/h 0.0 mm High 33
24 Aug 32.3 °C 46 % 29 km/h 0.3 mm High 27
25 Aug 32.9 °C 37 % 35 km/h 0.1 mm High 30
26 Aug 34.7 °C 29 % 35 km/h 0.0 mm High 33
27 Aug 35.1 °C 29 % 31 km/h 0.0 mm High 33
28 Aug 35.7 °C 26 % 30 km/h 0.0 mm High 36
29 Aug 35.9 °C 26 % 25 km/h 0.0 mm High 34
30 Aug after 34.9 °C 30 % 20 km/h 0.0 mm High 36
31 Aug after 35.0 °C 27 % 26 km/h 0.0 mm High 36
1 Sept after 34.5 °C 32 % 19 km/h 0.0 mm High 33
2 Sept after 33.7 °C 37 % 25 km/h 0.0 mm High 32
3 Sept after 34.8 °C 34 % 25 km/h 0.0 mm High 31
4 Sept after 36.0 °C 30 % 30 km/h 0.0 mm High 33
5 Sept after 36.6 °C 28 % 30 km/h 0.0 mm High 34
6 Sept after 34.5 °C 40 % 29 km/h 0.2 mm High 32
7 Sept after 34.5 °C 34 % 34 km/h 0.0 mm High 34
8 Sept after 35.8 °C 22 % 33 km/h 0.0 mm Very high 40

Its twins: fires that started in the same weather

It started with an FWI of 41.6, a minimum humidity of 29% and 37 days without rain. Fires in the area that started in weather like this since 2016: 55.

FWI at the start 41.6
Minimum humidity 29 %
Days without rain 37
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Altamira fire, July 2016
3,640 ha 18 days FWI 38.5 Min. humidity 30 % 49 km away, in 2016

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

15 days
median duration
5,003 ha
median area
16 %
went past 10,000 ha
4.5 mm
rain at the end (median; 28 of 55 had it)

It burned an area similar to its twins (6,885 ha against a median of 5,003 ha) and lasted 14 days, against 15 days.

In 27 of 55, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.5 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
40km/h · max. gust

It was considered over on 29 Aug, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 28 of 55, with a median of 4.5 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 9 Aug 2019
After · 5 Sept 2019

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 460Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Brazil

Frequently asked questions

How long did the Altamira fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 16 August 2019 to 29 August 2019 (14 days). The perimeter dates it from 16 August 2019 to 22 August 2019.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 6,885 hectares (68.8 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Altamira (6,965 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 35.9 °C, humidity dropped to 23 % and gusts hit 40 km/h. The fire danger index (FWI) reached 42, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Brazil (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 55. Their median duration was 15 days and their median area 5,003 ha; 16 % went past 10,000 ha. In 27 of 55, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 4.5 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 193 · Emergency number and official warnings

Satellite cross-check

History of this page · 1 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 22 August 2019 → 29 August 2019.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 193.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 16 August 2019 to 22 August 2019. 460 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.