Skip to content
worldfires
ES · Spain · →

Almogía fire, August 2020 Almogía, Málaga

Out · last detection 15 Aug 2020, 12:49 UTC

The fire started on 15 August 2020 in Almogía, Spain, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 113 hectares from satellite imagery, spread across 2 municipalities. According to EGIF (MITECO), it was detected on 15 August 2020 at 14:45 and declared extinguished on 16 August 2020.

It is the 14th largest in Malaga since 2016 (of 16 with a page). Number 80 in Spain in 2020, of 89.

The power measured by the satellite is low (17.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
113ha
Copernicus perimeter
Duration
1day
15 Aug 2020 – 15 Aug 2020
Municipalities hit
2
municipalities
Started on
15 Aug
2020
Heat detections
2
in a single hotspot: 18 MW
Danger at start
29
High · FWI index
Average daily power
25MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 15 Aug15 Aug

How it evolved, day by day

15 Aug 2020 · 25 MW · 2

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

31°high
28km/h · peak gust
35%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Almogía 4,269 inhabitants · 5.4 km from the centre where it started
    70 ha reached on 15 Aug
    0.4 %
  2. Málaga 603,144 inhabitants · 16.6 km from the centre
    44 ha
    0.1 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Sclerophyllous scrub87 %
  • Agricultural areas13 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

Official record

According to EGIF (MITECO), this fire started on 15 August 2020 and burned 92 ha (the satellite measured 113 ha).

MITECO, Estadística General de Incendios Forestales (EGIF). This is the agency’s consolidated statistic: it measures the area in its own way, which is why it can differ from the satellite.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
15 Aug 31.2 °C 35 % 28 km/h 0.0 mm High 29
16 Aug after 30.7 °C 31 % 31 km/h 0.0 mm High 31
17 Aug after 31.5 °C 36 % 33 km/h 0.0 mm High 32
18 Aug after 30.9 °C 40 % 26 km/h 0.0 mm High 30
19 Aug after 29.2 °C 45 % 27 km/h 0.0 mm High 26
20 Aug after 29.6 °C 44 % 25 km/h 0.0 mm High 26
21 Aug after 32.3 °C 31 % 19 km/h 0.0 mm High 29
22 Aug after 33.8 °C 40 % 26 km/h 0.0 mm High 32
23 Aug after 28.9 °C 54 % 29 km/h 0.0 mm High 24
24 Aug after 27.7 °C 70 % 29 km/h 0.0 mm Moderate 16
25 Aug after 29.3 °C 63 % 24 km/h 0.0 mm Moderate 16

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 8 Aug 2020
After · 22 Aug 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 14 August 2020 the air beside the fire reached 16 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak16 µg/m³
Days over the guideline0 days
PM1029 µg/m³
131415161718
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 2Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Spain ›

Frequently asked questions

How long did the Almogía fire last?
Copernicus dates it between 15 August 2020 and 15 August 2020: 1 day between the first and last image with fire. According to EGIF (MITECO), it was detected on 15 August 2020 at 14:45 and declared extinguished on 16 August 2020.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 113 hectares (1.1 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Almogía (70 ha, 0.4 %); Málaga (44 ha, 0.1 %).
Did the fire reach a town?
The fire started in Almogía and came within 5.4 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 31.2 °C, humidity dropped to 35 % and gusts hit 28 km/h. The fire danger index (FWI) reached 29, class High.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Spain (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 2 Suomi-NPP VIIRS detections on those dates.
  • Compared with EGIF (MITECO): 92 official ha against 113 ha of perimeter; they agree within 25%.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM3 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.