Dying down · last detection 16 Nov 2026, 05:10 UTC
Satellites first detected fire on 6 November 2026 in Alenquer, Brazil. It has been active for 11 days, with 318 heat detections and an area with fire of about 3,136 hectares rebuilt from them, spread across a single municipality.
GWIS near-real-time perimeter, from the layer that changed in October 2025: this fire is not compared with fires from earlier years, because since then the GWIS layer gives more and larger perimeters.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
satellite only
≈ 3,136ha
Estimated from hotspots: no perimeter has been published yet.
Source
NASA FIRMS · VIIRS
Date
6 Nov 2026 – 16 Nov 2026
+− cross-check
This is an estimate from the VIIRS pixels that saw fire. It will change when the perimeter is published.
Duration by satellite
satellite only
11days
From 6 Nov 2026 to today: still being detected.
Source
NASA FIRMS · VIIRS
Date
last detection: 16 Nov 2026, 05:10 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
6 Nov 2026
First day with fire seen by the satellites or the perimeter.
Source
NASA FIRMS · VIIRS
Date
6 Nov 2026
+− cross-check
No official record is matched to this page, so the alert time and the cause are not known here.
Hotspots
satellite only
318
VIIRS detections at 375 m. Most intense hotspot: 121 MW.
Source
NASA FIRMS · VIIRS (NOAA-20)
Date
6 Nov 2026 – 16 Nov 2026
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
959MW
Total radiative power on 13 November 2026; hotspots that day: 32.
Source
NASA FIRMS · VIIRS (FRP)
Date
13 Nov 2026
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
34.5FWI · high
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 1.
Source
WorldFires calculation (Canadian FWI system)
Date
6 Nov 2026, local noon
Model
ECMWF IFS 0,25° · Open-Meteo.com · provisional
+− cross-check
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
38.8°C · 27% RH
High of 38.8 °C and minimum humidity of 27% on 9 November 2026; gusts of 42 km/h on 10 November 2026.
Source
weather model at the fire’s grid cell
Date
6 Nov 2026 – 16 Nov 2026
Model
ECMWF IFS 0,25° · Open-Meteo.com · provisional
+− cross-check
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page is not in the change log yet: its first snapshot is saved tonight. What follows is reconstructed from each source’s date.
Show
· reconstructedweather
Weather and FWI computed from the forecast (provisional until ERA5 arrives)
GWIS (Copernicus) has not yet published the perimeter of this fire. It rebuilds it from hotspots, which can take several days, and it does not always arrive. For now the area is the one rebuilt from heat detections (about 14 hectares per pixel). If the perimeter arrives, this page picks it up on its own and keeps the same address.
Is it still active?
No detections since 16 Nov 2026, 05:10 UTC. That usually means no flame is visible from space any more, although hotspots may remain. Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
The wind is blowing from the north-west and pushing to the south-east; no sharp shifts are expected until Fri 20, 01:00.
ECMWF IFS 0.25° at the centre of the fire · computed 17 Nov 2026, 04:20 UTC
No sharp changes in the next 72 h
No strong wind shifts and no dry nights. No warnings does not mean the fire will go out: in this weather it can carry on as it is.
Checked, no warning:✓ no wind shifts of more than 60°✓ nights recover humidity (peaks of 78 % or more)✓ no useful rain expected (2.4 mm in 72 h)
Hour by hour, local time
Tap the strip to see each hour
Mean windGusts➤ where it blows toRelative humidityNight (8 pm to 8 am)Rain (mm) · chance in %
Where is it blowing? The next 48 h
geoBoundaries/Instituto Brasileiro de Geografia e Estatística (IBGE), OCHA ROLAC (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO))
At this hour
Places the fan reaches
Is it heading my way?
We compare your point with the fan for each hour. Your location never leaves your device.
or tap the map
This is not an official warning. It is a global model forecast with cells of about 25 km, at the centre of the fire: it cannot see valley winds or the winds the fire itself creates. The fan shows where the wind blows, not where the fire will spread. If in doubt, follow what the authorities say.
Forecast: ECMWF IFS 0.25° (European Centre for Medium-Range Weather Forecasts), served by our own Open-Meteo instance; the chance of rain comes from the ECMWF ensemble. Variables: wind and gusts at 10 m, wind at 850 hPa, relative humidity and temperature at 2 m, rain. Open-Meteo.com (CC BY 4.0).
Fire: VIIRS (NASA FIRMS); hotspots from the last 24 h: VIIRS from NASA FIRMS. Boundaries: geoBoundaries/Instituto Brasileiro de Geografia e Estatística (IBGE), OCHA ROLAC (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)).
How it is worked out: wind shift = a change of more than 60° in 6 h or less, with at least 15 km/h before and after; no overnight recovery = peak humidity between 8 pm and 8 am stays below 55 %; useful rain = 2 mm or more in 6 h. The fan opens 18° plus however much the wind varies within ±3 h and reaches 25 km beyond the edge of the fire: one model cell, not a rate of spread. Methodology ›
Where it burned
HOTSPOTS BY DAY
6 Nov16 Nov
Play back16 Nov 2026
How it evolved, day by day
6 Nov9 Nov13 Nov
Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.
Area with fire inside each municipality, rebuilt from heat detections (about 14 hectares per VIIRS pixel). An estimate until the official perimeter arrives. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
The weather day by day
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · forecast models, provisional until the ERA5 reanalysis arrives
Day
High
Min. humidity
Peak gust
Rain
Danger (FWI)
6 Nov
37.9 °C
28 %
32 km/h
0.0 mm
High 34
7 Nov
37.7 °C
32 %
35 km/h
0.1 mm
High 37
8 Nov
38.0 °C
31 %
32 km/h
0.1 mm
High 36
9 Nov
38.8 °C
27 %
30 km/h
2.0 mm
High 35
10 Nov
36.8 °C
48 %
42 km/h
2.9 mm
Low 10
11 Nov
36.7 °C
37 %
36 km/h
1.1 mm
High 28
12 Nov
37.1 °C
36 %
33 km/h
0.5 mm
High 29
13 Nov
37.6 °C
33 %
38 km/h
0.1 mm
High 36
14 Nov
38.5 °C
26 %
29 km/h
0.1 mm
High 35
15 Nov
38.8 °C
30 %
24 km/h
0.2 mm
High 30
16 Nov
38.3 °C
28 %
23 km/h
1.0 mm
High 31
Before and after, from space
Drag the line to compare the same ground before the fire and after it.
↔
Before · 30 Oct 2026
After · 16 Nov 2026
Sentinel-2 did not pass over on that day. Try another date, or use false colour, which is daily.
If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.
Detections table· 318Every satellite heat detection, one by one, with time, satellite, power and coordinates.›
⬇ Download CSVTimes in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
According to the heat detections seen by satellite, it burned from 6 November 2026 to 16 November 2026 (11 days between the first and the last detection). There is no perimeter yet to date it.
How much area did it burn?
There is no perimeter yet. Heat detections rebuild about 3,136 hectares with fire (31.4 km²), a rough figure; GWIS will give its own when it publishes the perimeter, which can take several days.
Which municipalities burned?
The fire only entered Alenquer (3,136 ha, 0.1 %).
Is the Alenquer fire still active?
No fire detections since 16 Nov 2026, 05:10 UTC. A lack of detections is not an official extinction.
What was the weather like?
During the fire the temperature reached 38.8 °C, humidity dropped to 26 % and gusts hit 42 km/h. The fire danger index (FWI) reached 37, class High.
What weather is expected at the fire over the next 72 hours?
The wind is blowing from the north-west and pushing to the south-east; no sharp shifts are expected until Fri 20, 01:00. No strong wind shifts, dry nights or useful rain are expected. Times are local time at the fire. ECMWF IFS forecast (Open-Meteo) computed 17 Nov 2026, 04:20 UTC; this is not an official warning.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Brazil (geoBoundaries). It is not an official report.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
No perimeter yet: the area (≈ 3,136 ha) is estimated by counting VIIRS pixels with fire, about 14 ha each.
Dates of the first and last VIIRS detection of the cluster. 318 Suomi-NPP VIIRS detections on those dates.
Weather: ECMWF IFS model, provisional until the ERA5 reanalysis arrives.
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.