Skip to content
worldfires
IQ · Iraq · –

Al-Kahla fire, 13 July 2022 Al-Kahla

Out · last detection 28 Jul 2022, 09:25 UTC

The fire started on 13 July 2022 in Al-Kahla, Iraq, and satellites saw it burning for 22 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 5,834 hectares from heat detections, spread across a single municipality.

It is the 3th largest in Maysan since 2016 (of 29 with a page). Number 2 in Iraq in 2022, of 12.

Burnt area
5,834ha
GWIS perimeter (Copernicus)
Duration
22days
13 Jul 2022 – 3 Aug 2022
Municipalities hit
1
districts
Started on
13 Jul
2022
Heat detections
79
in a single hotspot: 122 MW
Danger at start
92
Very extreme · FWI index
Average daily power
76MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 13 Jul3 Aug
28 Jul 2022

How it evolved, day by day

18 Jul 2022 · 64 MW · 6 23 Jul 2022 · 5 MW · 3 24 Jul 2022 · 24 MW · 8 25 Jul 2022 · 4 MW · 2 26 Jul 2022 · 186 MW · 33 27 Jul 2022 · 230 MW · 26 28 Jul 2022 · 21 MW · 1
18 Jul 24 Jul 27 Jul

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

51°high
67km/h · peak gust
7%lowest humidity

It had gone more than two months without rain (1 mm or more) when it started.

This area had burned before

93% of the perimeter overlaps earlier fires recorded since 2016: 3,514 ha in 2016, 541 ha in 2017, 7,829 ha in 2018, 859 ha in 2021. Part of it burned more than once, so the yearly figures add up to more than the 5,401 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 3.7% of the area of London (58 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Al-Kahla where it started
    5,838 ha reached on 18 Jul
    1.6 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Very dry air: 69 % of the area in Iraq 60 days without rain: 27 % of the area in Iraq

Day High Min. humidity Peak gust Rain Danger (FWI)
13 Jul 48.1 °C 9 % 40 km/h 0.0 mm Very extreme 92
14 Jul 48.8 °C 10 % 35 km/h 0.0 mm Extreme 65
15 Jul 49.6 °C 8 % 31 km/h 0.0 mm Extreme 63
16 Jul 49.7 °C 9 % 26 km/h 0.0 mm Extreme 66
17 Jul 49.8 °C 9 % 32 km/h 0.0 mm Very extreme 78
18 Jul 50.6 °C 8 % 38 km/h 0.0 mm Very extreme 95
19 Jul 51.3 °C 9 % 40 km/h 0.0 mm Very extreme 97
20 Jul 50.1 °C 11 % 33 km/h 0.0 mm Very extreme 74
21 Jul 47.2 °C 12 % 28 km/h 0.0 mm Extreme 65
22 Jul 49.7 °C 11 % 48 km/h 0.0 mm Very extreme 73
23 Jul 48.0 °C 8 % 67 km/h 0.0 mm Very extreme 152
24 Jul 47.0 °C 8 % 59 km/h 0.0 mm Very extreme 136
25 Jul 46.1 °C 7 % 45 km/h 0.0 mm Very extreme 104
26 Jul 47.1 °C 7 % 47 km/h 0.0 mm Very extreme 106
27 Jul 47.0 °C 8 % 41 km/h 0.0 mm Very extreme 95
28 Jul 44.9 °C 13 % 36 km/h 0.0 mm Extreme 54
29 Jul 43.4 °C 36 % 40 km/h 0.0 mm Extreme 58
30 Jul 44.0 °C 31 % 32 km/h 0.0 mm Very high 42
31 Jul 45.7 °C 21 % 36 km/h 0.0 mm Very high 45
1 Aug 46.1 °C 25 % 31 km/h 0.1 mm Very high 49
2 Aug 46.4 °C 25 % 22 km/h 0.6 mm Very high 43
3 Aug 48.0 °C 19 % 21 km/h 1.2 mm Very high 41
4 Aug after 51.7 °C 10 % 28 km/h 0.0 mm Extreme 68
5 Aug after 50.8 °C 8 % 28 km/h 0.0 mm Extreme 69
6 Aug after 49.4 °C 12 % 28 km/h 0.0 mm Extreme 68
7 Aug after 49.9 °C 15 % 25 km/h 0.0 mm Extreme 62
8 Aug after 50.3 °C 12 % 45 km/h 0.0 mm Very extreme 71
9 Aug after 51.6 °C 8 % 59 km/h 0.0 mm Very extreme 116
10 Aug after 50.6 °C 9 % 56 km/h 0.0 mm Very extreme 129
11 Aug after 50.3 °C 11 % 41 km/h 0.0 mm Very extreme 76
12 Aug after 50.3 °C 10 % 48 km/h 0.0 mm Very extreme 96
13 Aug after 48.7 °C 12 % 41 km/h 0.0 mm Extreme 68

Its twins: fires that started in the same weather

It started with an FWI of 91.6, a minimum humidity of 9% and more than two months without rain. Fires in the area that started in weather like this since 2016: 13.

FWI at the start 91.6
Minimum humidity 9 %
Days without rain 60+
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Al-Mejar Al-Kabir fire, September 2018
1,054 ha 43 days FWI 90.3 Min. humidity 9 % 9 km away, in 2018

First rain (1 mm or more) after it ended: 1.7 mm on 21 Oct.

What happened to them

Fires in the area that started in similar weather: 13. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
67km/h · max. gust

It was considered over on 3 Aug, and not even 1 mm fell in the following ten days: it went out without rain.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 6 Jul 2022
After · 10 Aug 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 79Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Iraq

Frequently asked questions

How long did the Al-Kahla fire last?
According to the heat detections seen by satellite inside the perimeter, it burned from 13 July 2022 to 3 August 2022 (22 days). The perimeter dates it from 14 July 2022 to 27 July 2022.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 5,834 hectares (58.3 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Al-Kahla (5,838 ha, 1.6 %).
What was the weather like?
During the fire the temperature reached 51.3 °C, humidity dropped to 7 % and gusts hit 67 km/h. The fire danger index (FWI) reached 152, class Very extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Iraq (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page · 2 Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.
  1. Last day with fire: 27 July 2022 → 3 August 2022.
  2. Start date: 14 July 2022 → 13 July 2022.

RSS Changes to this page With cross-checks and a citable version

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates adjusted with the VIIRS detections inside the perimeter, which said 14 July 2022 to 27 July 2022. 79 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.