Skip to content
worldfires
IT · Italy · →

Agrigento fire, 28 June 2022 Agrigento

Out · last detection 28 Jun 2022, 01:40 UTC

The fire started on 28 June 2022 in Agrigento, Italy, and satellites saw it burning for 1 day. Copernicus mapped a burnt perimeter of 194 hectares from satellite imagery, spread across a single municipality.

It is the 132th largest in Agrigento since 2016 (of 289 with a page). Number 70 in Italy in 2022, of 161.

The power measured by the satellite is low (2.8 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
194ha
Copernicus perimeter
Duration
1day
28 Jun 2022 – 28 Jun 2022
Municipalities hit
1
municipalities
Started on
28 Jun
2022
Heat detections
8
in a single hotspot: 3 MW
Danger at start
41
Very high · FWI index
Average daily power
16MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 28 Jun28 Jun

How it evolved, day by day

28 Jun 2022 · 16 MW · 8

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

34°high
28km/h · peak gust
21%lowest humidity

It had gone 30 days without rain (1 mm or more) when it started.

This area had burned before

78% of the perimeter overlaps earlier fires recorded since 2016: 72 ha in 2016, 5 ha in 2018, 66 ha in 2019, 116 ha in 2020, 55 ha in 2021. Part of it burned more than once, so the yearly figures add up to more than the 152 ha that had burned before.

What happened to each town

  1. Agrigento 55,512 inhabitants · 17.0 km from the centre where it started
    194 ha reached on 28 Jun
    0.8 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land72 %
  • Agricultural areas25 %
  • Artificial surfaces3.7 %

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2020
Built-up area0.28 ha
Residents< 20

Inside the perimeter there were about 0.28 hectares of built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
28 Jun 34.4 °C 21 % 28 km/h 0.0 mm Very high 41
29 Jun after 32.4 °C 37 % 35 km/h 0.0 mm High 38
30 Jun after 32.2 °C 47 % 32 km/h 0.0 mm High 32
1 Jul after 31.9 °C 41 % 35 km/h 0.0 mm High 31
2 Jul after 32.5 °C 43 % 30 km/h 0.0 mm High 30
3 Jul after 33.8 °C 33 % 34 km/h 0.0 mm High 35
4 Jul after 33.4 °C 36 % 32 km/h 0.0 mm High 33
5 Jul after 35.1 °C 29 % 34 km/h 0.0 mm Very high 40
6 Jul after 35.5 °C 28 % 39 km/h 0.0 mm Very high 41
7 Jul after 34.2 °C 28 % 36 km/h 0.1 mm Very high 41
8 Jul after 31.0 °C 42 % 47 km/h 0.0 mm Very high 40

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 21 Jun 2022
After · 5 Jul 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 1 July 2022 the air beside the fire reached 24 µg/m³ of PM2.5. That day averaged 21: 1.4 times the WHO daily guideline (15).

PM2.5 peak24 µg/m³
Days over the guideline5 days
PM1059 µg/m³
26272829301
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 8Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Agrigento fire last?
Copernicus dates it between 28 June 2022 and 28 June 2022: 1 day between the first and last image with fire.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 194 hectares (1.9 km²). Official national figures may differ.
Which municipalities burned?
The fire only entered Agrigento (194 ha, 0.8 %).
Did the fire reach a town?
The fire started in Agrigento and came within 17.0 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 34.4 °C, humidity dropped to 21 % and gusts hit 28 km/h. The fire danger index (FWI) reached 41, class Very high.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 8 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.