Zapotlán el Grande fire, April 2016
Zapotlán el Grande, Zapotiltic, Tamazula de Gordiano
Out · last detection
The fire started on in Zapotlán el Grande, Mexico, and satellites saw it burning for 6 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,798 hectares from heat detections, spread across 3 municipalities.
It is number 98 by size of the 267 fires with a page that started in Jalisco since 2016. Number 61 in Mexico in 2016, of 204.
matches the official recordwith caveatssatellite onlymodel
When copying, the sentence is
Tick the figures you want: they make up the lede and the CSV.
Burned area
with caveats
2,798ha
Perimeter published by GWIS (Copernicus).
This page2,798CONAFOR1,412
Source
GWIS (Copernicus)
Date
29 Apr 2016 – 4 May 2016
+− cross-check
CONAFOR: 1,412 ha (matched records: 1). Difference between the page and the official record: +98.1%. Matched on 22 November 2026. The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Duration by satellite
satellite only
6days
29 Apr 2016 to 4 May 2016: first and last day with fire on the page.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
last detection: 4 May 2016, 19:57 UTC
+− cross-check
Satellites pass a few times a day and cloud or smoke can hide the fire: a lack of detections is not an official extinction. Each country’s emergency service declares a fire contained or out.
Start
satellite only
29 Apr 2016
First day with fire seen by the satellites or the perimeter.
Source
GWIS (Copernicus) · NASA FIRMS · VIIRS
Date
29 Apr 2016
+− cross-check
The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Hotspots
satellite only
135
VIIRS detections at 375 m. Most intense hotspot: 98 MW.
Source
NASA FIRMS · VIIRS (Suomi NPP)
Date
29 Apr 2016 – 4 May 2016
+− cross-check
There is no official record to compare with. Each hotspot is a pixel detected in one satellite pass, not a separate fire.
The worst day
satellite only
717MW
Total radiative power on 29 April 2016; hotspots that day: 28.
Source
NASA FIRMS · VIIRS (FRP)
Date
29 Apr 2016
+− cross-check
Fire radiative power (FRP) measures the energy the fire gives off when the satellite passes. Added up by day, it compares intensity, not area.
Danger at the start
model
48.7FWI · very high
Fire Weather Index (Canadian system) computed by WorldFires for the day the fire started. Consecutive days without rain before: 8.
This is an index computed from weather model data, not a measurement of the fire nor an official warning. Danger warnings are issued by each country’s authority. Emergency number and official warnings ›
Weather during the fire
model
30.9°C · 17% RH
High of 30.9 °C and minimum humidity of 17% on 4 May 2016; gusts of 47 km/h on 3 May 2016.
These are model values for a cell of about 25 km, not from a weather station: they may differ from what was measured on the ground.
ⓘThis page’s change log has been kept since 24 October 2026: every night what it publishes is compared and the difference is logged. Anything earlier is reconstructed from each source’s date and marked as reconstructed.
Show
· reconstructedofficial
Matched with the official CONAFOR record
Nearby records with very different figures: 1,412 ha (records: 1).
A version keeps the area, dates, name and official record; the area as it was logged (changes under 2% are not logged). The map, hotspots and weather always show today’s data.
Citation
A lede of about 60 words figures only, no adjectives
Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.
People and buildings inside the perimeter
GHSL 2015
Built-up area0.82ha
Residents< 20
Inside the perimeter there were about 0.82 hectares of built-up land and almost nobody lived there (GHSL 2015, satellite-based estimate).
This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.
According to CONAFOR, this fire started on 29 April 2016 and burned 1,412 ha (the satellite measured 2,798 ha). The two figures differ a lot, so these may not be exactly the same fire: take them as nearby records.
Zapotlán el GrandeLos Charcos29 April 20161,412 ha· extinguished on 3 May 2016· cause: negligence
ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.
Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
It burned an area similar to its twins (2,798 ha against a median of 2,463 ha) and lasted 6 days, against 9 days.
In 15 of 33, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.
This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it
How it ended
1.3 mmfirst rain
9 May5 days after it ended
47km/h · max. gust
It was considered over on 4 May, and on 9 May 1.3 mm fell. We do not know whether the rain or the firefighters put it out. Twins with rain when they ended: 18 of 33, with a median of 2.0 mm.
Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)
How a twin is chosen
Same area: fires that have already ended, less than 250 km from this one, since 2016.
Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
They are sorted by similarity, and the outlines of the first five are drawn.
GWIS (Copernicus) dates it between 29 April 2016 and 4 May 2016: 6 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,798 hectares (28.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Zapotlán el Grande (1,446 ha, 5.2 %); Zapotiltic (883 ha, 3.5 %); Tamazula de Gordiano (486 ha, 0.4 %).
What was the weather like?
During the fire the temperature reached 30.9 °C, humidity dropped to 8 % and gusts hit 47 km/h. The fire danger index (FWI) reached 49, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mexico (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 33. Their median duration was 9 days and their median area 2,463 ha; 100 % went past 1,000 ha. In 15 of 33, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 2.0 mm.
Where to verify it
A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.
This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.
⚑Report an errorHow we know this›
Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
Dates from the perimeter: the VIIRS detections inside it did not change them. 135 Suomi-NPP VIIRS detections on those dates.
Compared with CONAFOR: 1,412 official ha against 2,798 ha of perimeter; similar, but with reservations.
Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2015, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.
The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.