Skip to content
worldfires
HN · Honduras · →

Yoro fire, 8 May 2026 Yoro, Jocón, Olanchito

Out · last detection 14 May 2026, 19:19 UTC

The fire started on 8 May 2026 in Yoro, Honduras, and satellites saw it burning for 7 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 1,604 hectares from heat detections, spread across 3 municipalities.

It is the 11th largest in Yoro since 2016 (of 36 with a page). Number 36 in Honduras in 2026, of 99.

The power measured by the satellite is low (13.7 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Burnt area
1,604ha
GWIS perimeter (Copernicus)
Duration
7days
8 May 2026 – 14 May 2026
Municipalities hit
3
municipalities
Started on
8 May
2026
Heat detections
39
in a single hotspot: 14 MW
Danger at start
26
High · FWI index
Energy released
171MW
sum of detected power

Where it burned

14 May 2026
HOTSPOTS BY DAY 8 May14 May

How it evolved, day by day

891011121314

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
38km/h · peak gust
30%lowest humidity

It had gone 4 days without rain (1 mm or more) when it started. Rain came after the fire: 1.4 mm on 24 May.

This area had burned before

No earlier perimeters overlap this fire since 2016, when the satellite record begins.

What happened to each town

  1. Yoro where it started
    1,476 ha reached on 8 May
    0.6 %
  2. 135 ha reached on 8 May
    0.4 %
  3. 3 ha reached on 8 May
    0.0 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance is from the town centre to the nearest fire: staying a kilometre away does not mean it reached the houses.

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
8 May 37.1 °C 35 % 35 km/h 0.0 mm High 26
9 May 37.3 °C 30 % 34 km/h 0.0 mm High 27
10 May 37.3 °C 31 % 38 km/h 0.0 mm High 29
11 May 36.0 °C 36 % 36 km/h 0.1 mm High 30
12 May 34.6 °C 40 % 37 km/h 0.1 mm High 29
13 May 34.1 °C 39 % 35 km/h 0.4 mm High 29
14 May 35.1 °C 36 % 33 km/h 0.0 mm High 29
15 May after 35.3 °C 37 % 38 km/h 0.0 mm High 31
16 May after 36.3 °C 32 % 31 km/h 0.1 mm High 30
17 May after 37.1 °C 34 % 36 km/h 0.2 mm High 30
18 May after 36.9 °C 32 % 37 km/h 0.0 mm High 31
19 May after 37.0 °C 35 % 35 km/h 0.0 mm High 30
20 May after 36.9 °C 31 % 37 km/h 0.0 mm High 31
21 May after 36.8 °C 33 % 37 km/h 0.2 mm High 32
22 May after 36.8 °C 37 % 32 km/h 0.1 mm High 32
23 May after 36.2 °C 40 % 36 km/h 0.3 mm High 32
24 May after 36.5 °C 39 % 32 km/h 1.4 mm Moderate 21

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 1 May 2026
After · 21 May 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 14 May 2026 the air beside the fire reached 64 µg/m³ of PM2.5. That day averaged 32: 2.2 times the WHO daily guideline (15).

PM2.5 peak64 µg/m³
Days over the guideline11 days
PM1068 µg/m³
Optical depth0.64
67891011121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 39Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Honduras ›

Frequently asked questions

How long did the Yoro fire last?
GWIS (Copernicus) dates it between 8 May 2026 and 14 May 2026: 7 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 1,604 hectares (16.0 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Yoro (1,476 ha, 0.6 %); Jocón (135 ha, 0.4 %); Olanchito (3 ha, 0.0 %).
What was the weather like?
During the fire the temperature reached 37.3 °C, humidity dropped to 30 % and gusts hit 38 km/h. The fire danger index (FWI) reached 30, class High.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Honduras (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 911

Satellite cross-check

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 911.

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 4.0 International (CC BY 4.0)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.