Skip to content
worldfires
MN · Mongolia · –

Xalx gol fire, 17 September 2022 Xalx gol

Out · last measured on 18 Sept 2022

The fire started on 17 September 2022 in Xalx gol, Mongolia, and satellites saw it burning for 2 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 2,686 hectares from heat detections, spread across a single municipality.

It is the 42th largest in Dornod since 2016 (of 57 with a page). Number 14 in Mongolia in 2022, of 18.

We have the GWIS perimeter for this fire, but the VIIRS sensors did not capture it in enough detail: no day-by-day evolution, but the split by municipality is there.

Burnt area
2,686ha
GWIS perimeter (Copernicus)
Duration
2days
17 Sept 2022 – 18 Sept 2022
Municipalities hit
1
districts
Started on
17 Sept
2022
Danger at start
48
Very high · FWI index

Where it burned

The weather it burned in

18°high
70km/h · peak gust
26%lowest humidity

It had gone 10 days without rain (1 mm or more) when it started. Rain came after the fire: 1.5 mm on 22 Sept.

This area had burned before

1% of the perimeter overlaps earlier fires recorded since 2016: 40 ha in 2020.

How big is it?

10 km
It burned the equivalent of 1.7% of the area of London (27 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Xalx gol where it started
    2,604 ha
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents< 20

Inside the perimeter there was no noticeable built-up land and almost nobody lived there (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Strong wind: 56 % of the area in Mongolia

Day High Min. humidity Peak gust Rain Danger (FWI)
17 Sept 18.2 °C 33 % 70 km/h 0.1 mm Very high 48
18 Sept 15.0 °C 26 % 55 km/h 0.0 mm Very high 42
19 Sept after 12.4 °C 15 % 48 km/h 0.0 mm High 37
20 Sept after 16.9 °C 22 % 41 km/h 0.0 mm High 34
21 Sept after 18.0 °C 27 % 43 km/h 0.4 mm High 25
22 Sept after 10.8 °C 44 % 52 km/h 1.5 mm Low 8

Its twins: fires that started in the same weather

It started with an FWI of 48.0, a minimum humidity of 33% and 10 days without rain. Fires in the area that started in weather like this since 2016: 3.

FWI at the start 48.0
Minimum humidity 33 %
Days without rain 10
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Xalx gol fire, July 2017
7,175 ha 3 days FWI 45.7 Min. humidity 25 % 108 km away, in 2017

First rain (1 mm or more) after it ended: 3.5 mm on 4 Jul.

What happened to them

Fires in the area that started in similar weather: 3. With fewer than 15 we give no figures: they would be more noise than signal.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

1.5 mmfirst rain
22 Sept4 days after it ended
70km/h · max. gust

It was considered over on 18 Sept, and on 22 Sept 1.5 mm fell. We do not know whether the rain or the firefighters put it out.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 10 Sept 2022
After · 25 Sept 2022

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 19 September 2022 the air beside the fire reached 25 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak25 µg/m³
Days over the guideline0 days
PM1036 µg/m³
Optical depth0.83
15 Sept17 Sept19 Sept21 Sept
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Other fires nearby

All fires in Mongolia

Frequently asked questions

How long did the Xalx gol fire last?
GWIS (Copernicus) dates it between 17 September 2022 and 18 September 2022: 2 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 2,686 hectares (26.9 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire only entered Xalx gol (2,604 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 18.2 °C, humidity dropped to 26 % and gusts hit 70 km/h. The fire danger index (FWI) reached 48, class Very high.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Mongolia (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 105 · 101 · Emergency number and official warnings

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 105 · 101.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. No Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.