Skip to content
worldfires
SS · South Sudan · –

Wulu fire, 16 December 2020 Wulu, Ibba

Out · last detection

The fire started on in Wulu, South Sudan, and satellites saw it burning for 6 days. Copernicus’s global GWIS system rebuilt a burnt perimeter of 14,368 hectares from heat detections, spread across 2 municipalities.

It is number 14 by size of the 119 fires with a page that started in Lakes since 2016. Number 26 in South Sudan in 2020, of 190.

Compare with…
Burnt area
14,368ha
GWIS perimeter (Copernicus)
Duration
6days
16 Dec 2020 – 21 Dec 2020
Municipalities hit
2
counties
Started on
16 Dec
2020
Heat detections
412
in a single hotspot: 172 MW
Danger at start
60
Extreme · FWI index
Average daily power
675MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 16 Dec21 Dec
21 Dec 2020

How it evolved, day by day

16 Dec 2020 · 199 MW · 34 17 Dec 2020 · 493 MW · 63 18 Dec 2020 · 960 MW · 92 19 Dec 2020 · 1,483 MW · 99 20 Dec 2020 · 886 MW · 119 21 Dec 2020 · 29 MW · 5
16 Dec 19 Dec

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

37°high
42km/h · peak gust
15%lowest humidity

It had gone 39 days without rain (1 mm or more) when it started.

This area had burned before

86% of the perimeter overlaps earlier fires recorded since 2016: 13,256 ha in 2016, 3,690 ha in 2017, 363 ha in 2018, 1,719 ha in 2019. Part of it burned more than once, so the yearly figures add up to more than the 12,365 ha that had burned before.

How big is it?

10 km
It burned the equivalent of 9.1% of the area of London (144 km² against 1,583 km²).

London boundary: geoBoundaries · Office for National Statistics (Open Government Licence v3.0).

This compares size, not location: both shapes are at the same scale, north up, centred on each other.

What happened to each town

  1. Wulu where it started
    13,834 ha reached on 16 Dec
    1.2 %
  2. 621 ha reached on 18 Dec
    0.1 %

Burnt area inside each municipality, from crossing the GWIS perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

People and buildings inside the perimeter

GHSL 2020
Built-up area< 0.1 ha
Residents≈ 350

Inside the perimeter there were about 0.05 hectares of built-up land and about 350 residents (GHSL 2020, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Started with Extreme FWI: 63 % of the area in South Sudan

Day High Min. humidity Peak gust Rain Danger (FWI)
16 Dec 36.7 °C 17 % 39 km/h 0.0 mm Extreme 60
17 Dec 35.5 °C 15 % 42 km/h 0.0 mm Extreme 67
18 Dec 35.1 °C 20 % 36 km/h 0.0 mm Extreme 61
19 Dec 34.9 °C 18 % 30 km/h 0.0 mm Extreme 55
20 Dec 35.1 °C 20 % 28 km/h 0.0 mm Extreme 54
21 Dec 35.9 °C 20 % 28 km/h 0.0 mm Extreme 53
22 Dec after 34.7 °C 25 % 37 km/h 0.0 mm Extreme 54
23 Dec after 36.0 °C 22 % 42 km/h 0.0 mm Extreme 61
24 Dec after 36.3 °C 21 % 31 km/h 0.0 mm Very high 44
25 Dec after 37.1 °C 18 % 29 km/h 0.0 mm Extreme 50
26 Dec after 36.2 °C 21 % 24 km/h 0.0 mm Very high 47
27 Dec after 36.5 °C 20 % 32 km/h 0.0 mm Extreme 54
28 Dec after 36.6 °C 20 % 35 km/h 0.0 mm Extreme 58
29 Dec after 36.0 °C 21 % 40 km/h 0.0 mm Extreme 60
30 Dec after 36.3 °C 19 % 32 km/h 0.0 mm Extreme 59
31 Dec after 36.6 °C 16 % 31 km/h 0.0 mm Extreme 55

Its twins: fires that started in the same weather

It started with an FWI of 60.3, a minimum humidity of 17% and 39 days without rain. Fires in the area that started in weather like this since 2016: 25.

FWI at the start 60.3
Minimum humidity 17 %
Days without rain 39
this fire chosen twins rest of the area
Almost identicalSimilar

Outlines of the closest twins

Ibba fire, January 2025
10,299 ha 11 days FWI 60.3 Min. humidity 17 % 66 km away, in 2025

First rain (1 mm or more) after it ended: none in the following ten days.

What happened to them

11 days
median duration
7,578 ha
median area
28 %
went past 10,000 ha
1.6 mm
rain at the end (median; 3 of 25 had it)

It was 1.9 times larger than the median of its twins and lasted 6 days, against 11 days.

Only 3 of its 25 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 22 of 25, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

This is a bank of analogues: it shows what usually happens, not what will happen. With fewer than 15 twins we give no figures. How we calculate it

How it ended

—first rain
—no rain in ten days
42km/h · max. gust

It was considered over on 21 Dec, and not even 1 mm fell in the following ten days: it went out without rain. Twins with rain when they ended: 3 of 25, with a median of 1.6 mm.

Weather on this page: Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

How a twin is chosen

  • Same area: fires that have already ended, less than 250 km from this one, since 2016.
  • Same start: we compare the FWI on the first day, the minimum humidity that day and the run of days without rain before it. The slider sets how much they may differ.
  • Only pages with final weather data (ERA5 reanalysis) calculated in the same way as this fire’s; agricultural and grass burns and pages with data under review are left out.
  • Fires burning at the same time as this one (a week before or after) are left out: they share the same spell of weather and do not count as a precedent.
  • They are sorted by similarity, and the outlines of the first five are drawn.

How we calculate it

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 9 Dec 2020
After · 28 Dec 2020

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

Detections table · 412Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in South Sudan

Frequently asked questions

How long did the Wulu fire last?
GWIS (Copernicus) dates it between 16 December 2020 and 21 December 2020: 6 days between the first and last heat detection of the perimeter.
How much area did it burn?
The perimeter GWIS (Copernicus) rebuilt from heat detections is 14,368 hectares (143.7 km²). It is an estimate: official national figures may differ.
Which municipalities burned?
The fire entered 2 municipalities: Wulu (13,834 ha, 1.2 %); Ibba (621 ha, 0.1 %).
What was the weather like?
During the fire the temperature reached 36.7 °C, humidity dropped to 15 % and gusts hit 42 km/h. The fire danger index (FWI) reached 67, class Extreme.
Where does this data come from?
From the GWIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of South Sudan (geoBoundaries). It is not an official report.
How did the fires that started in similar weather in this area end?
Fires less than 250 km away that started since 2016 with a similar FWI, humidity and dry spell: 25. Their median duration was 11 days and their median area 7,578 ha; 28 % went past 10,000 ha. Only 3 of its 25 twins burned more. The weather on the first day does not explain everything: the wind in the following days, the fuel and the firefighting also count. In 22 of 25, not even 1 mm fell in the ten days after the end: they went out without rain. In the rest, the first rainy day brought a median of 1.6 mm.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy.

How we know this
  • Perimeter: GWIS (Copernicus), rebuilt from heat detections rather than mapped on imagery.
  • Dates from the perimeter: the VIIRS detections inside it did not change them. 412 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2020, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology

Where this data comes from

The perimeter comes from the Copernicus Global Wildfire Information System (GWIS), which rebuilds it from MODIS and VIIRS heat detections and publishes it under CC BY 4.0. It is not measured on imagery as in Europe, so it is an estimate. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM2 (Creative Commons Attribution 3.0 Intergovernmental Organisations (CC BY 3.0 IGO)). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ from each country’s official figure.