Skip to content
worldfires
IT · Italy · →

Vico Equense fire, September 2026 Vico Equense, Positano, Piano di Sorrento

Out · last detection 15 Sept 2026, 12:00 UTC

The fire started on 14 September 2026 in Vico Equense, Italy, and satellites saw it burning for 2 days. Copernicus mapped a burnt perimeter of 235 hectares from satellite imagery, spread across 3 municipalities.

It is the 5th largest in Napoli since 2016 (of 12 with a page). Number 99 in Italy in 2026, of 232.

The power measured by the satellite is low (8.2 MW in the strongest hotspot), more typical of grass or stubble burning, or a slow surface fire, than of a large crown fire.

Compare with…
Burnt area
235ha
Copernicus perimeter
Duration
≈ 2days
14 Sept 2026 – 15 Sept 2026
Municipalities hit
3
municipalities
Started on
14 Sept
2026
Heat detections
21
in a single hotspot: 8 MW
Danger at start
12
Moderate · FWI index
Average daily power
51MW
detected power per day, on average

Where it burned

HOTSPOTS BY DAY 14 Sept15 Sept
15 Sept 2026

How it evolved, day by day

14 Sept 2026 · 1 MW · 1 15 Sept 2026 · 101 MW · 20
14 Sept 15 Sept

Fire radiative power detected each day, in megawatts, and number of hotspots. The magenta bar marks the peak day.

The weather it burned in

27°high
33km/h · peak gust
41%lowest humidity

It had gone 2 days without rain (1 mm or more) when it started. Rain came after the fire: 2.5 mm on 18 Sept.

This area had burned before

31% of the perimeter overlaps earlier fires recorded since 2016: 39 ha in 2017, 41 ha in 2024. Part of it burned more than once, so the yearly figures add up to more than the 73 ha that had burned before.

What happened to each town

  1. Vico Equense 20,254 inhabitants · 3.2 km from the centre where it started
    167 ha reached on 14 Sept
    5.7 %
  2. 42 ha reached on 15 Sept
    5.0 %
  3. Piano di Sorrento 12,355 inhabitants · 3.2 km from the centre
    26 ha reached on 15 Sept
    3.6 %

Burnt area inside each municipality, from crossing the official perimeter with administrative boundaries. The distance runs from the point marking the centre of each area to the nearest fire: staying a kilometre away does not mean it reached the houses.

What burned

  • Other natural land58 %
  • Scrub and transitional woodland16 %
  • Sclerophyllous scrub13 %
  • Broadleaved forest12 %
  • Agricultural areas1.3 %

Natura 2000 protected area affected: 50 %

Natura 2000 sites (European Environment Agency, 2024 release) crossed by the perimeter.

Land cover inside the perimeter according to Corine Land Cover, as reported by Copernicus.

People and buildings inside the perimeter

GHSL 2025
Built-up area0.14 ha
Residents< 20

Inside the perimeter there were about 0.14 hectares of built-up land and almost nobody lived there (GHSL 2025, satellite-based estimate).

This is an estimate on 100 m cells, made from satellite imagery and census data: it does not mean that homes burned or that anyone was harmed. The perimeter also contains land that never burned. The GHSL 2025 epoch is a projection made from 2020 and earlier data.

Source: Global Human Settlement Layer (GHS-BUILT-S and GHS-POP R2023A), European Commission Joint Research Centre (JRC), © European Union, CC BY 4.0. Sum inside the perimeter computed by WorldFires. human-settlement.emergency.copernicus.eu

The weather day by day

ECMWF ERA5 reanalysis at the fire location, the standard reference for past weather, and the Canadian Fire Weather Index (the same system Copernicus uses), computed by WorldFires from that data. Days after the fire run until the first rain.

Open-Meteo.com (CC BY 4.0) · Copernicus Climate Change Service (ERA5)

Day High Min. humidity Peak gust Rain Danger (FWI)
14 Sept 27.0 °C 41 % 33 km/h 0.0 mm Moderate 12
15 Sept 28.3 °C 42 % 29 km/h 0.0 mm Moderate 14
16 Sept after 26.0 °C 47 % 17 km/h 0.0 mm Moderate 12
17 Sept after 25.5 °C 69 % 17 km/h 0.0 mm Low 8
18 Sept after 25.1 °C 73 % 17 km/h 2.5 mm Very low 1

Before and after, from space

Drag the line to compare the same ground before the fire and after it.

Before · 7 Sept 2026
After · 22 Sept 2026

If the day is cloudy, change the date: each satellite passes once a day. In false colour the burnt ground looks brown or red.

The smoke

CAMS · Copernicus

On 17 September 2026 the air beside the fire reached 23 µg/m³ of PM2.5, but no daily average passed the WHO guideline (15).

PM2.5 peak23 µg/m³
Days over the guideline0 days
PM1032 µg/m³
Optical depth0.20
121314151617
Good Fair Moderate Poor Very poor Extremely poor

Particles from the Copernicus CAMS model at the centre of the perimeter; these are not measurements in each town. The pale bar is the worst hour, the solid one the daily average.

Open-Meteo.com (CC BY 4.0) · Copernicus Atmosphere Monitoring Service (CAMS)

Detections table · 21Every satellite heat detection, one by one, with time, satellite, power and coordinates.
⬇ Download CSV Times in UTC. Each detection is a 375 m pixel: a large fire yields hundreds per pass.
Date and timeSatelliteFRP (MW)LatLon

Other fires nearby

All fires in Italy ›

Frequently asked questions

How long did the Vico Equense fire last?
The official perimeter only gives the start date (14 September 2026). The end comes from the heat detections inside the perimeter: it burned until 15 September 2026 (2 days from 14 September 2026), the last day with detections before more than 10 days in a row without any, so it is approximate.
How much area did it burn?
The perimeter Copernicus measured from satellite imagery is 235 hectares (2.4 km²). Official national figures may differ.
Which municipalities burned?
The fire entered 3 municipalities: Vico Equense (167 ha, 5.7 %); Positano (42 ha, 5.0 %); Piano di Sorrento (26 ha, 3.6 %).
Did the fire reach a town?
The fire started in Vico Equense and came within 3.2 km of its centre. That is the distance from the perimeter, or the nearest hotspot, to the point marking the centre; it does not mean it entered the houses.
What was the weather like?
During the fire the temperature reached 27.0 °C, humidity dropped to 41 % and gusts hit 33 km/h. The fire danger index (FWI) reached 12, class Moderate.
Where does this data come from?
From the EFFIS (Copernicus) burnt perimeter, NASA FIRMS VIIRS hotspots and the administrative boundaries of Italy (geoBoundaries). It is not an official report.

Where to verify it

A satellite detection is not an official report. Final figures and the fire’s status are published by each country’s emergency service.

Emergency number: 112 · 1515 · Emergency number and official warnings ›

Satellite cross-check

History of this page Changes in area, dates, name, official record or merged pages, compared every night since 24 October 2026.

No changes since 24 October 2026.

RSS Changes to this page

Does something look wrong on this page?

This page is built from satellite data and official records, and it sometimes gets things wrong: the wrong dates, the wrong town, two fires merged into one, or something that was not a wildfire at all. If you know this fire first-hand (you live nearby, saw it, fought it or reported on it), tell us what really happened and we will check it.

Report an error
What do you think is wrong?

We will only use your email to reply about this report. Privacy. This is not an emergency service: if there is a fire now, call 112 · 1515.

How we know this
  • Perimeter: EFFIS (Copernicus), mapped on satellite imagery.
  • The official perimeter has no end date: the end is the last day with VIIRS detections inside the perimeter before a gap of more than 10 days (150 days at most), so it is approximate. 21 Suomi-NPP VIIRS detections on those dates.
  • We have not matched this page with any official record.
  • Weather: Copernicus ERA5 reanalysis at the fire location, in cells of about 25 km.
  • Built-up area and population come from the JRC Global Human Settlement Layer (epoch 2025, 100 m cells), summed inside the perimeter: an estimate of what was there, not a damage count.

How we build fire pages: methodology ›

Where this data comes from

The perimeter and land cover come from the Copernicus European Forest Fire Information System (EFFIS), measured on MODIS and Sentinel-2 imagery and published under CC BY 4.0. Heat detections come from the VIIRS sensors aboard Suomi-NPP and NOAA-20, distributed by NASA FIRMS at 375 m resolution. Municipal boundaries come from geoBoundaries ADM4 (Creative Commons Attribution 3.0 License). The area per municipality is computed by WorldFires by crossing the perimeter with those boundaries, so it may differ slightly from each country’s official figure.